齿轮组

Now a member of the Kapp Group, Niles shares in the development and implementation of joint technologies such as the use of Kapp CBN tools for large module gears.

现在的成员之一，柯组， niles股份，在制定和执行联合技术，如使用柯cbn刀具大模数齿轮。

The paper will not be damaged while corrugating with the help of the gear duster and the chain wheel.

此机通过多组齿轮及链轮转动，保证纸在压瓦楞过程中不破损。

Aimed at the difficulty to extract the fault information of a low speed shaft in a large gearbox, wavelet analysis was used to realize the local analysis of signals in a time and frequency domain simultaneously. The signals were dissembled to a sieres of compactly supported wavelet bases non-redundantly and without leaking.

针对大型齿轮箱低速轴故障信息难以提取的问题，采用小波分析方法对故障数据进行处理以实现信号在时/频域的局域性分析，将其无冗余、无泄漏地分解到一组具有紧支撑性的小波基上。

Depending on the method of manufacture, the gear may be of the continuous-tooth herringbone variety or a double-helical gear with a space between the two halves to permit the cutting tool to run out.

推力问题可以通过在同一坯见切削两组斜齿来克服。根据制造方法的不同，齿轮可以是连续人字形的，或者在两列斜齿之间留一间隙的双斜齿形的，以便切削刀具通过。

The article divided the stress influencing factors of involutes spur gear tooth root into 5 levels of 5 factors, with orthogonal table L25(4^5) setting up a group of 24 combinations of factors.

文中将渐开线直齿圆柱齿轮齿根应力的影响因素分为5因素5水平，用正交试验表L25(4^5)组建了24组因素组合。

Based on the involutes gear generating method and UG、ANSYS three-dimensional modeling capabilities, models of accurate calculation of the finite element tooth root bending stress are established with 24 groups of data.

依据渐开线齿轮范成加工原理及UG、ANSYS三维建模功能，建立的有限元齿根弯曲应力精确计算模型，并进行了24组数据计算。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。