高速度

Have been selected as statistical index, realizing for the first time the quantitative analysis of the high speed railway capacity with mixed high and medium speed train operations, and the huge amount of plannings of would be unimageable under the condition of manual drawing In the analysis four prime factors--the fleeting interval of high and medium speed trains, the matching of speed for high and medium speed trains, the number of inter-mediate stoppings and the train performance approach, have been given special analysis And a quantitative analysis has been made for the first time with regard to the impact of the variation of above four factors on the demand for the high speed train sets, and concerning conclusions have been drawn from the quantitative analysis.

其中着重分析了高中速列车追踪间隔、高中速列车速度匹配关系、中间站设置数量、组织方式等四个影响通过能力的主要因素。同时，首次定量分析了上述因素的变动与高速动车组需求数量间的关系。此外，从上述量化研究中得出了有关结论。

The average level of the soil available potassium was 119.96 mg/kg, which decreased 18.94 mg/kg and 1.05 mg/kg one year averagely. But the decreasing trend alleviated in recent years. There were 39.5 kg/hm^2 nitrogen and 30.9 kg/hm^2 phosphorus (P2O5) more than needed averagely, and 150.0 kg/hm^2 potassium (K2O) in deficiency. Though the fertilizer application was high and the rate of fertilizer was 647.96 kg/hm^2 in nutrient, the ratio of organic to inorganic was still unreasonable. The ratio of the chemical fertilizer nitrogen phosphorus (P2O5) and potassium (K2O) was 1:0.42:0.14. The nitrogen application was enough and even higher than that was needed. The phosphorus was proper elementarily and potassium was in deficiency. The yield of wheat which was the main crop increased slightly and that of other autumn harvest crops was stable.

土壤速效钾7年平均值119.96 mg/kg，比第二次土壤普查时下降了18.94 mg/kg，平均每年以1.05 mg/kg的速度下降，但近年来下降趋势变缓；养分平衡中氮素平均盈余39.5 kg/hm^2，磷素(P2O5)盈余30.9 kg/hm^2，钾素(K2O)亏缺150.0 kg/hm2；全省施肥水平较高，每公顷总施肥量折纯养分647.96 kg，但有机无机比仍不合理，化肥氮、磷、钾投入比例1：0.42：0.17，氮肥充足，部分地区用量偏高，磷肥基本合理，钾肥不足；主要农作物小麦产量略有上升，其它主要秋收作物产量基本稳定。

Improving vertical resolution for density curves is by means of restructuring the response from large and small spacing sondes and borehole effect correction factor and coherence factor are used. Form the principle of GR logging, calculate volumes in investigating areas taken by borehole, formation, up and low shoulder beds, along with distance between center of gravity of the four unit bodies and detector. Based on the above, the weighting function of each unit body to GR signal contributions are established, thus realizing processing of GR logs with high resolution. The resistivity logging model uses "resolution matching" method to improve the resolution of the logs. After the process, PNN model is made to recognize the oil-gas-water bed. Compared with BPNN, the net work is featured swiftness, accuracy and ease of practical application.

提高密度测井曲线垂直分辨率是通过对重新组合长、短源距探测器响应的算法来提高补偿密度曲线的垂直分辨率，并加入井眼影响校正因子和相关性因子；自然伽马测井模型从基本原理出发，扣除井的影响，计算井筒、地层及其上下围岩所占探测球域体积及其重心到探测器的距离，以此建立各单元体对伽马测井信号贡献的权函数，通过权函数逐层计算不同厚度地层条件下各的单元体权因子，实现自然伽马曲线高分辨率处理；电阻率校正模型应用&分配率匹配&模型，应用低分辨率曲线提高为高分辨率曲线：曲线校正后，利用常规测井资料并且结合校正后的密度、伽马、电阻率等三个对判断油水层有利的指标，通过概率神经网络模型识别储层流体性质，较以前的模型，不仅极大的提高识别正确率，同时与普通神经网络相比较，提高了网络的运行速度和实用性。

It\'s also the first time to design and study the structure of new typed fluidized bed jet mill. Adding fresh air to the top and the bottom in the fluidized bed jet mill to increase the speed of upward currents, the way is leading fluidized particles to be boiling and reduce the eddy strength. The aim is to reduce the opportunity of regrinding. It is valuable to produce the particles which are rough, high density and high product rate requirement. At present, the technology has been prevailed, which produced lots of benefits for society and economy.

首次设计和研究了新型流化床气流粉碎结构，在下部和上部加入气流，提高了气流粉碎区的上升气流速度，补充喷嘴引射的气流，使底部的颗粒易于被流化沸腾起来，减少涡流强度，从而减少合格颗粒再粉碎的机率，这对较粗、密度高和成品率要求高的颗粒的加工具有极大的价值，并得到广泛的推广与应用，取得了较大的经济和社会效益。

Its also the first time to design and study the structure of new typed fluidized bed jet mill. Adding fresh air to the top and the bottom in the fluidized bed jet mill to increase the speed of upward currents, the way is leading fluidized particles to be boiling and reduce the eddy strength. The aim is to reduce the opportunity of regrinding. It is valuable to produce the particles which are rough, high density and high product rate requirement. At present, the technology has been prevailed, which produced lots of benefits for society and economy.

首次设计和研究了新型流化床气流粉碎结构，在下部和上部加入气流，提高了气流粉碎区的上升气流速度，补充喷嘴引射的气流，使底部的颗粒易于被流化沸腾起来，减少涡流强度，从而减少合格颗粒再粉碎的机率，这对较粗、密度高和成品率要求高的颗粒的加工具有极大的价值，并得到广泛的推广与应用，取得了较大的经济和社会效益。

The paper summarizes the recent advances in stability of cold-formed steel beams and purlins. It contains three components.

引言钢结构属于绿色环保建筑，近年来，它以强度高、自重轻、抗震性能好、施工速度快、地基费用省、占用面积小、工业化程度高、外形美观、可重复使用等一系列优点在建筑业中得到了广泛的应用。

Measurements were conducted using a data buoy fitted with the new GPS sensors and the traditional accelerometers. The new GPS system performed excellently, as 3D movement of the buoy depend on the movement of seawater particles, we use the velocity of GPS receiver to estimate the position of the buoy.

再将GPS挂载在中央气象局布放於小琉球西南方海域之资料浮标上，以GPS输出之垂直速度推算波高与周期，从分析结果显示，浮标与GPS推算之波高与周期相关性皆达0.97以上，差异皆低於5%。

In order to improve the measurement velocity and precision of signal processor of wind profiler , a solution of software and hardware proposed which can process signal at real -time.

为进一步提高风廓线仪信号处理器的测量速度和精度，通过使用高精度的ADC以及高处理能力的TMS320C6X系列DSP，并结合针对所用硬件的汇编语言与C语言的混合编程技术，提出了一种能够实时处理信号的软硬件解决方法。

Before 1920 attention was focused largely on the pavement or other wearing course , and little notice was given to the materials that made up the subgrade or to the manner in which they were placed or compacted .soon after that date increased vehicle speeds brought demands for higher standards of alignment and grade ,which in turn meant deeper cuts and higher fill .

1920年前关注主要集中在人行道上或其他穿着当然，小通知书交给了材料，取得了路基或以何种方式被放置或压缩。尽快在该日期之后增加了车辆的速度要求更高标准的一致性和等级，这反过来又意味着进一步削减和更高的填补。

For a pump speed, in fact, there are restrictions, which mainly depends on the process fluid, if the transmission is oil, pump can rotate at high speed, but when the fluid is a high viscosity of the polymer melt, such restrictions will be significantly reduced.

对于一台泵的转速，实际上是有限制的，这主要取决于工艺流体，如果传送的是油类，泵则能以很高的速度转动，但当流体是一种高粘度的聚合物熔体时，这种限制就会大幅度降低。

For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether

年美国个人破产法的一个改动使得破产登记急速下降，而后引起了信用卡大规模的亏损。

Eph. 4:23 And that you be renewed in the spirit of your mind

弗四23 而在你们心思的灵里得以更新