高电压
- 与 高电压 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
The practice proves that the power supply has characteristus of steaely output voltage, small ripple and high efficiency.
实践证明,该通信电源输出电压稳定,纹波小,整机效率高。
-
Finally, the simulation of the system and the experimental results of PWM rectifier are presented. The results of the simulation and experiment indicate that the input power factor is close to 1, the output voltage of the rectifier is stable and the high quality charge and discharge: current of the accumulator is achieved, current ripple is small.
本文最后给出了系统的仿真和PWM整流器实验波形,仿真和实验的结果表明:系统实现了输入功率因数接近1,变流器输出电压稳定;获得了较高质量的蓄电池充放电电流,电流纹波小。
-
The model of the outer layer hard and inter layer soft magnetic structure was suggested that the amorphous ribbon and wire are constituted by the relatively"hard" magnetic"shell"with relatively high magnetic coercivity and relatively"soft"magnetic "core"with relatively low magnetic coercivity.
非晶材料的尖锐脉冲电压现象是由于具有显著的不可逆壁移磁化过程导致大巴克豪森跳跃所造成的,脉冲的尖锐性与动态磁滞回线的形态密切相关,回线的方形度越高,则脉冲愈尖锐。
-
As a member of the SWIFTL317C family of dc/dc regulators, the TL317C low-input voltage high-output current synchronous buck PWM converter integrates all required active components.
作为SWIFTL317C直流/直流稳压器,该TL317C低输入电压高输出电流同步降压PWM转换器集成了所有的家庭成员需要有效成分。
-
The TOSHIBA PM7346-BI consists of a silicone phototransistor optically coupled to a gallium arsenide infrared emitting diode in a four lead plastic DIP (DIP4) with having high isolation voltage AC: 5kVRMS
1第1页,本页显示记录1-14,共14条记录分1页显示东芝PM7346 - BI的由一个硅光光学耦合到一个砷化镓红外发光晶体管在4铅塑料DIP(DIP4)与具有高隔离电压(交流二极管:5kVRMS)。
-
Lightning voltages may be of high magnitude but are of very short duration; their time is measured in microseconds.
雷电过电压具有很高的幅值,但持续时间极短,以微秒计算。
-
However, the development of proper low-voltage phosphors is still facing lots of difficulties.
但是,合适的高、低电压萤光粉仍须研究开发。
-
The structure of the thin film capacitor 1 of this invention is: form sequentially at least the bottom electrode layer 102, the high dielectrics constant oxide film 103 and the upper electrode layer 105 on the semiconductor substrate 101; said upper electrode layer 105 which is a film layer 104 formed by the electrical conductive material which is processable by reactive ion etching, or a multilayered film composed of two kinds of film layers 107 and 108, which are each formed of a conductive material which is processable by at least two kinds of reactive ion etching.
要约 薄膜电容器1是至少在半导体基片101上按顺序形成下部电极层102、高介电常数氧化物膜层103、上部电极层105而构成的薄膜电容器,该上部电极层105由一种仅由可用反应性离子刻蚀加工的导电性材料形成的膜层104,或至少两种由可用反应性离子刻蚀加工的导电性材料分别形成层状的多层膜层107和108构成;经历350℃的热试验之后,对该薄膜电容器1施加OV到2V的驱动电压的薄膜电容器漏电电流密度为1×10 -8 A/cm 2 以下。
-
It is competently used in distribution circuits of AC380V, 50Hz,or 60Hz,for power distribution and protection of circuits and electrical equipment from overload, undervoltage and shortcircuit, as well as for non-frequent switching under normal working conditions.
H系列塑料外壳断路器,80年代从美国西屋引进,该断路器结构新颖,性能可靠,附件齐全,分断能力高,适用于交流50Hz,或60Hz380V及以下的配电线路中,作为分配电能和保护线路及电源设备免受过载,欠电压和短路危害以及在正常工作条件下作为线路的不频繁转换之用。
-
Although DDR3 supposes to reduce the system power consumption with its lower supply voltage of 1.5V versus 1.8V required on common DDR2, but since it is clocking at extremely high frequency, there is a need to have proper power management system and that is how the company's proprietary DHX+(Dual-path Heat eXchange) heatsink comes into picture.
虽然DDR3内存假设,以减少系统功耗较低的电源电压为枚1.5V与1.8V的需要共同的DDR2 ,但因为它是在非常高的时钟频率,还需要有适当的电源管理系统,这是如何公司专有的DHX +散热器进入图片。
- 推荐网络例句
-
She gently rebuff ed him, but agreed that they could be friends
她婉言拒绝了,但同意作为朋友相处。
-
If in the penal farm, you were sure to be criticized.
要是在劳改农场,你等着挨绳子吧!
-
Several theories about reigniting and extinguishing of the arc have been refered.
本文综合考虑了几种电弧重燃和熄灭理论。