高度的

The altimetry system not capable of flying in feet in accordance with paragraph 2.5 should not flight plan in the RVSM airspace and shall comply with the paragraph 9.0 as required.

配备的高度表不能按照2.5款所要求的条件飞行相应英制高度的航空器，不得计划在RVSM空域运行，并且需要遵守9.0款的有关要求。

ABSTRACT In order to improve the high industrialization, the high yielding standardization and the high flexibility of furniture industry of China, furniture computer aided design, in which the advanced technologies~ devices-, design ways are used, will be the optimal choice; as the purpose of replacing the traditional design way drawing on the drawing table with hands, at the same time in stead of the low efficiency..

为使我国的家具工业实现高度的工业化、标准化生产的同时兼具生产的高度灵活性，家具计算机辅助设计将是最佳选择。

Because these greenhouse gas to come from the sun radiation of it is thus clear that only have height of through sex, and come out to the Earth glint of the long wave radiation have high absorption, be also "green house effect"

由于这些温室气体对来自太阳辐射的可见光具有高度的透过性，而对地球反射出来的长波辐射具有高度的吸收性，也就是常说的"温室效应"，导致全球气候变暖。

It can be realized by reasonably setting the heald frame height of air jet loom by depending on the different form of the shedding and the different step of the weft insertion.

根据不同的开口形式及在引纬过程中不同的阶段对综框高度的要求，进行合理的综框高度设定。

The whole process of moment-curvature relationship for RC beam was analyzed with the relative depth of compressive zone of the beam about 0.15 using the strip integral method and computer programme. The relationships between moment and strain of concrete, strain of steel, depth of compressive zone were got.

采用条带积分法，应用计算机编程，对相对受压区高度为0.15左右的钢筋混凝土梁的弯矩－曲率关系进行全过程分析，得出弯矩－曲率关系曲线，并给出弯矩与混凝土应变、钢筋应变及梁的相对受压区高度的对应关系。

From this model the height of 500 mb surface andthe thickness between a certain selected isobaric surface in the vicinity of thetop of friction layer and 500 mb surface can be forecasted.

在某些近似下，作者推导了一组闭合的预告500mb 高度和500mb 与某等压面之间的厚度的方程式；把它推广，作者还求出了一组预告三层等压面高度的方程式。

The differential exhumation caused by the NNE-trending faults probably continued all the way from the 180℃isothermal surface, through 110℃isothermal surface to the 70℃isothermal surface. At 90Ma, Dabie orogen"s average height of topography, compared with the current sea level, reached 1.45 km (when geothermal gradient is chosen as 25℃/km) or 1.75 km (when geothermal gradient is chosen as 20℃/km), which is 4(when geothermal gradient is chosen as 25℃/km) or 5(when geothermal gradient is chosen as 20℃/km) times of the height of today"s surface topography in simulated region.

这种由于NNE向断裂系引发的差异推隆剥露，可能从等温面180℃锆石(U-Th／He的封闭温度、经过110℃(磷灰石裂变径迹的退火温度)一直延续到70℃等温面磷灰石(U-Th／He的封闭温度大别造山带90Ma时与现今海平面相比地形平均高度可达1.45km(地温梯度取25℃／km时)或1.75km(地温梯度取20℃／km时)，是现今模拟区域地形平均高度的4倍(地温梯度取25℃／km时)或5倍(地温梯度取20℃／km时)。

The results were gained that correspond to different heat load, amount of solution elevation, vapor amount, maximum height of the elevated solution, the minimum submersed depth of solution.

得出了对应于不同的加热负荷，浓溶液的提升量、蒸汽发生量、浓溶液最大提升高度及稀溶液最小浸没高度的关系曲线，为该类型热虹吸泵的设计和运行提供了依据。

By using a wide field stereo-microscope and a CCD video camera system,the axial liquid flow and dryout pointin vertical rectangular capillary microgrooves heat sink were observed and measured under pure evaporation heat transfer conditions.An experimental study of the influences of microgroove geometric parameters and working liquids on wetting height was conducted.

利用宽视场体视显微镜和CCD摄像系统对纯蒸发换热情形下竖直放置的矩形毛细微槽群热沉中的液体沿微槽槽道方向的流动情况和干涸点高度进行了观察测量，并对微槽几何尺寸、工质等因素对润湿高度的影响进行了实验研究。

The factors affecting the stair-step height are analyzed and the research results provide theoretical basis for the building orientation and slicing parameters of the prototypes.

左右的侧表面次之。分析了影响侧表面台阶高度的各种因素，找出了影响规律，给出了台阶高度的计算公式。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。