骨盆测量

These were ealuated forCobb angle, end ertebrae selection, Ferguson angle, apex of the cure, C7 balance, pelic obliquity, Risser sign,status of the triradiate cartilage, kyphosis Cobb angle, endplate selection for kyphosis, and kyphotic index.

分别从Cobb角，终椎的选择，Ferguson角，顶椎的选择， C7平衡，骨盆倾斜， Risser征，髋臼"Y"软骨的情况，脊柱后凸Cobb角，脊柱后凸的终板选择，脊柱后凸指数进行测量。

Methods: 75 corpses were collected locally. According to the physical anthropological measurement, the breadths of the shoulder and iliac crest, and the variables of the clavicle were measured and the data were analyzed with SPSS13.0 statistics software.

用本地收集的75例成年男性尸体，按体质人类学测量方法，对肩宽、骨盆宽和锁骨的各项目进行测量，所得值用SPSS13.0统计学软件进行相关和回归分析处理。

Objective:This study was designed to measure the angles of the acetabular abduction when facing the different pelvic obliqueness angles.

目的：通过对正常骨盆标本在骨盆歪斜不同角度时的髋臼外展角进行测量，得出髋臼外展角在骨盆绕身体矢状轴旋转时的变化趋势和规律。

Methods:The angle of the acetabular abduction of 21 pelvis all 42 hip joints were measured with the manual devices when facing the 9 different pelvic obliqueness angles.

手动测量21具骨盆标本共42髋在骨盆绕身体矢状轴向头侧和尾侧歪斜的9个不同角度时的髋臼外展角的度数。

Radiographic pelvimetry is of limited value in managing most cephalic presentations.

大多数头先露时放射骨盆测量价值有限。

METHODS: Analysis of the pelvis in the sagittal plane is commonly assessed by 3 angular measurements: the pelvic incidence (morphologic parameter directly linked to sagittal morphotypes), the pelvic tilt (or pelvis retroversion used to maintain an upright posture in the setting of spinal deformity), and the sacral slope.

矢状面骨盆的分析一般包括3个角度的测量：骨盆下陷度(与矢状面形态直接相关的形态学参数)，骨盆倾斜度(脊柱畸形时为维持直立姿势骨盆的后倾角度)，及骶骨斜度。

The length is measured from the point of the prosternum or breastbone to the rear edge of the pelvis, the ischial tuberosity.

德国牧羊犬的体长略大于身高，理想的比例为10/8.5，身体长度的测量方法是从胸骨到骨盆末端，坐骨突起处。

METHODS: The distances from anterior acetabular margin, posterior acetabular margin to anterior inferior iliac spine, iliopubic eminence and pubic tubercle were measured, respectively to determine and make serial cross-sections of the acetabular anterior column. In addition, the safe angle of screw entry on all entry points of each cross-section was measured, and all data were put into software SPSS 10.0 for statistics process.

分别测量20个半骨盆标本髋臼前、后缘到髂前下棘、髂耻隆起和耻骨结节的距离，确定和制作髋臼前柱系列断面，并测量各断面上各进钉点的安全进钉角度，将测量数据输入到SPSS10.0软件进行统计学分析。

Methods: Three out of eight pelvic specimens of cadavers were measured as normal group. then vertically unstable pelvic fractures were produced, and the biomechanical stiffness of internal fixation by sacroiliac screws with four hole LCDC symphyseal plates was tested and compared in the different reductions placement (low displace group and high displace group), the vertical and horizontal displacements of the sacroiliac joint and pubic symphysis were measured.

将8具尸体骨盆随机取3具做压力测试设为正常组，然后制成垂直不稳定骨盆骨折模型，骶髂关节和耻骨联合在移位0~4mm及移位8~12mm行后环骶髂关节螺钉和前环钢板螺钉固定，测量骶髂关节和耻骨联合的垂直和水平移位。

All half pelvises were dissected according to a certain steps. The range of "Holy plane" was defined and measured. Rectosacral fasciae were taken and examined by immunohistochemistry, and the nerves and lymph nodes were checked.

将21具成人尸体完整骨盆均从正中矢状面剖开，共42个半骨盆，按一定步骤进行解剖，界定并测量&Holy plane&范围；取盆壁层筋膜做免疫组化检查。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。