驱动电路

Later, it makes some comparison with four kinds of modulation technique, and finally, it implements the three-level PWM switching power amplifier with the PWM technique. The power of the amplifier is 2kVA, and the frequency bandwidth is 10～3kHz. In the thesis, the author designs and makes the hardwares of the switching power amplifier. The hardwares contain power inverter rank circuit, control system circuit based on DSP, drive and isolation circuit, and protective circuit. The thesis also analyses the potential safety problems and put forward some solutions for the problems. Furthermore, the thesis accomplishes the software design of the control system, and successfully debugs it. The methods of designing higher power ampilfier are also discussed in the thesis. It analyses the feasibility of the methods, outlines the way of how to design higher power switching power amplifier, and does some experiments with the method of switches-parallelling.

根据电动振动试验系统对开关功放的要求，提出了以电感电流瞬时值控制技术为基础的三电平脉宽调制开关功放的设计方案，并通过系统仿真进行了原理性论证；然后设计并制作了开关功放的硬件，包括功率转换电路，基于DSP的控制电路，驱动、隔离电路以及保护电路；针对开关功放数学模型不易得出的特点，细致分析了模糊自适应PID控制方法，在此基础上编写了控制程序；研制出一台功率为2kVA，通频带为10～3kHz的三电平脉宽调制开关功放；论文中还探讨了实现大功率开关功放的方法，分析了各种方法的可行性，给出了实现大功率开关功放的思路，并进行了并联开关管实现大功率开关功放的实验。

Design the key circuits to realize X processors low power strategy, which include the circuit used to stop clock, the circuit of the microcode engine unit, frequency-dividing circuit and clock driving unit.

设计了与X处理器功耗控制相关的关键电路，包括包括停止时钟电路、微码部件电路、时钟驱动模块、分频比电路等； 4。

The module integrates dual insulated driving and special protection circuits. It has high push-pull driving capability, bootstrap power supply technology and is easy for miniature design of inverter. The paper also introduces the application in portable diesel engine generator inverter and discusses some attention items in practical application.

该驱动模块内部集成两路独立驱动和独特的故障"局域网"保护电路，驱动能力强，体积对装小，易于逆变器的小型化设计，并介绍了该驱动模块在便携式柴油发电机逆变电源中的应用，讨论了设计中应注意的问题。

Since the output signal from fringing field dielectrometry sensors under a low frequency driving voltage are very low, the shield-drive, signal buffer and band-pass filter are adopted to improve SNR. With the signal gain and phase angle from a transform circuit, the complex permittivity of pressboard are obtained.

鉴于边缘场电容式传感器在低频正弦驱动信号作用下输出的感应信号非常微弱，调理电路采用驱动屏蔽方式进行测量信号缓冲，用带阻滤波器提高信噪比，并利用相应的变换电路求出电容系统的相位角和幅值增益，从而得到绝缘纸板的复介电常数。

However, the CMOS image sensors can provide stronger anti-radiation capacity than CCD as well as Single Chip Integrating with image sensors array, drive and control circuit, signal processing circuit, A/D conversion circuit and Completely Digital Interface Circuit. The CMOS image sensors also possess high quantum efficiency, wide spectral response, good response uniformity, low supply voltage and low request of clock. At the same time, the small bulk, high reliability, low power consumption and low cost are the prominent advantages of the CMOS image sensors too, thus CMOS image sensor has more exploiture foreground in X-ray real-time radioscopy imaging system.

由于CMOS 图像传感器比CCD 具有更强的抗辐射能力，还具有将图像传感器阵列、驱动和控制电路、信号处理电路、模数转换电路、全数字接口电路等实现单片集成以及量子效率高、光谱响应宽、响应均匀性好、工作电压低、对时钟脉冲要求低、体积小、重量轻、功耗低、高可靠、低成本等优点，因此在X 射线实时检测中更具有开发前景。

Finally choose reduce wheel speed, acceleration and slip ratio control parameters of logic threshold for control methods, as the paper...

本文用Protel Dxp软件完成了以SPCE061A为核心的ABS控制器的硬件电路设计，包括电源电路、轮速信号调理电路，驱动及故障诊断电路等。

This paper will emphasize on analyzing these two problems, and make a driving board with TLP250, this driving circuit can drive four IGBTs.and its driving signal is produced according to the requests, each driving signal is separated rightly with only one power supply, this circuit can also prevent from overflowing or short-circuit and keeping bridge arm from connecting directly.

本文将着重分析这两个问题，并利用TLP250设计了一块模块驱动板，此板可以驱动四个IGBT。此板的驱动信号符合要求，每路驱动信号在电位上是隔离的，而输入电源只有一个，该电路还有过流或短路保护功能以及防止桥臂直通的功能。

This design is used for the control of the core SCM STC89C51 automatic drying rack, the system increases from SCM software PWM DC electromechanical drive L298 Road, humidity and photoelectric sensor signal acquisition circuit, LED display circuit, remote control receiver circuit, a power supply module .

本设计是采用STC89C51单片机为控制核心的自动晾衣架，系统由单片机PWM软件加 L298驱动直流电机电路，湿度和光电传感器信号采集电路，LED显示电路，遥控接收电路，电源模块构成。

This design is used for the control of the core SCM STC89C51 automatic drying rack, the system increases from SCM software PWM DC electromechanical drive L298 Road, humidity and photoelectric sensor signal acquisition circuit, LED display circuit, remote control receiver circuit, a power supply module .

本设计是采用STC89C51单片机为控制核心旳自动晾衣架，系统由单片机PWM软件加 L298驱动直流电机电路，湿度和光电传感器信号采集电路，LED显示电路，遥控接收电路，电源模块构成。

The peak-to-peak jitter of the retimed data of CDR using the improved MCML latch is 7.5ps better than the 11.2ps peak-to-peak jitter of the retimed data of CDR using common MCML latch.

使用改进过后的电流驱动闩锁器电路的重新取样资料抖动为7.5ps，比原本的电流驱动闩锁器电路的资料抖动11.2ps来得佳。

Singer Leona Lewis and former Led Zeppelin guitarist Jimmy Page emerged as the bus transformed into a grass-covered carnival float, and the pair combined for a rendition of "Whole Lotta Love".

歌手leona刘易斯和前率领的飞艇的吉他手吉米页出现巴士转化为基层所涵盖的嘉年华花车，和一双合并为一移交&整个lotta爱&。

This is Kate, and that's Erin.

这是凯特，那个是爱朗。