饱和

The female silkworm moth also contained large amounts of unsaturated fatty acids, the largest among them was the linolenic acid belonging to the n-3 series, 40 times as much as that in eggs and 38 times as much as that in milk, while 6.5 times larger than linoleic acid.

家蚕雌蛾体含有丰富的不饱和脂肪酸，其中必需的n-3系列多不饱和脂肪酸亚麻酸含量最高(39.88%)，是鸡蛋的40倍和牛奶的38倍，并高于亚油酸含量6.5倍。

Unlike steaks and hamburgers, it's low in saturated fat, which raises "bad" cholesterol and may increase insulin resistance, making blood sugar control more difficult. A 3-ounce serving of skinless chicken breast has only 142 calories and 3 grams fat.

和牛排汉堡不同的是，它的饱和脂肪酸的含量很低，饱和脂肪酸可以升高胆固醇水平，还有可能抗胰岛素，使血糖的控制更困难。3盎司的无皮鸡胸脯只有142卡热量和3克脂肪。

An equation for the specific heat capacity of liquids which contains four constants hasbeen developed in this paper by means of analysis of data of heat capacities and properties offunction curves and its form is simple and convenient for use.

在液相比热容的研究方面，已有很多学者根据饱和液体比热容的实验数据关联出了较多的饱和液体比热容的方程式，但还没有专门针对过冷液体定压比热容而研制的方程式。

The MFGM-derived fraction comprises approximately 25% sphingomyelin, and the fatty acids are primarily saturated and monounsaturated.

该MFGM衍生的部分包括大约25 ％鞘磷脂和不饱和脂肪酸主要是饱和，单。

For MOS capacitors, the saturation current is mainly attributed to the electron-hole pair recombination mechanism. But for MOS capacitors, the saturation current is mainly attributed to the electron-hole pair generation mechanism, and is also controlled by interface trap densities, bulk traps, and suboxide.

对於N型矽基板上的氧半电容而言，其饱和电主要为电子电对在界面及空乏区的合机制，但是对於P型矽基板上的氧半电容而言，其饱和电受控於空乏区内电子电之产生与表面陷阱电荷，矽基板内缺陷，还有次氧化层。

For example, on a lane of 3.7 meters in width, a car can carry 3,600 people at most in one hour; a bus in subsaturation can hold 60,000 people per hour that is 17 times of a car; whereas a half saturated train can transport 42,000 passengers per hour that is 12 times of a car.

譬如在3.7米宽的车道上，小汽车每小时最多能运载3600人；公共汽车在半饱和状态下，每小时可运载6万人，是小汽车的17倍；而半饱和的火车每小时可运载4.2万人，是小汽车的12倍。

The results show that:(1) after MA for 20h, single phase bcc nanocrystalline supersaturate solid solution formed in Fe84Nb7B9 and Fe80Ti8B12 alloys; the thermal stability of nanocrystalline microstructure in Fe80Ti8B12 alloy was improved significantly than that in Fe84Nb7B9 alloy, and the decomposition temperature of supersaturate solid solution decreased in Fe80Ti8B12 alloy.(2) under 30MPa/900℃/0.5h hot-press sintering conditions, the relative density of Fe84Nb7B9 and Fe80Ti8B12 bulk alloys were 96.7% and 95.5%, respectively. Compared with Fe84Nb7B9 alloy (muti-phase microstructure), Fe80Ti8B12 alloy was composed of superfine crystalline (50~200nm) of single phase α-Fe;(3) the magnetic properties of Fe80Ti8B12 bulk alloy σ(subscript s=198.6emu/g, H=54.6Oe were more excellent than that of Fe84Nb7B9 bulk alloy σ(subscript s=162.9emu/g, H=105.1G, it was related to the different phases formed during hot-press sintering and the grain size of nanocrystalline powder.

结果表明：(1)20hMA后，Fe84Nb7B9和Fe80Ti8B12均形成了单相bcc纳米晶过饱和固溶体，相对前者，后者纳米晶组织热稳定性明显提高，过饱和固溶体相分解温度略有降低；(2)在30MPa/900℃／0.5h热压条件下，Fe84Nb7B9和Fe80Ti8B12块体合金相对密度分别为96.7%和95.5%，相对前者，后者由超细晶(50~200nm)单相α-Fe组成；(3)Fe80Ti8B12块体合金软磁性能σ(下标 s=198.6emu/g，H＝54.6Oe明显高於Fe84Nb7B9块体合金σ(下标 s=162.9emu/g，H＝105.1Oe，此与纳米晶粉末在热压烧结过程中所形成相的种类和晶粒尺寸大小有关。

The modification of the prepared microgels to unsaturated polyester resins was also studied. It was found that microgels can improve the thixotropy of UPR in a certain extent and largely increase in its mechanical properties.

论文还研究了P微凝胶对不饱和聚酯树脂的改性作用，结果表明，该微凝胶对不饱和聚酯触变性有一定改善作用，使其强度有较大幅度的提高。

Based on the analysis of the mathematics models of saturation steam density and superheat steam density the paper states that the deviation of the detection on temperature highly affects the accuracy of intelligent flow totalizer.

文摘：在分析饱和蒸汽和过热蒸汽密度的数学模型的基础上指出，温度检测的偏差对智能流量积算仪的精度影响极大，尤其是饱和蒸汽，测温电路的精度应设计为远高于仪表的精度，同时引入一种基于比率法的高精度测温电路。

The expressions for describing RSA at steady, dynamic and transient state are presented, respectively.

根据这些理论分析了实现反饱和吸收的条件和影响反饱和吸收的各种因素。

This paper discusses design and realizable methods of remote test output interface from logical design angle.

本文从逻辑设计的角度讨论遥测输出接口的设计及实现方法。

This also 星体投射plies to buildings, structures and geological features.

这也适用于建筑物和地质特征。