额定的

A channel-to-channel voltage rating and a common-mode voltage rating of at least 500V is desirable.

通道－通道电压额定值和共模电压额定值至少为500 V才是合理的。

Ensure that the total ampere ratings on all units plugged into the extension cord is not above the cord's rating.

确保插在电源器上的电源线范围数不要超过额定数，也不要超过总的额定电流。

The input and output voltage ratings may be exceeded if the input and output current ratings are observed.

输入和输出可能会超过额定电压的输入和输出，如果额定电流得到遵守。

2TheMax GPX750 PSU for the desktop computer features total output of 750W, rated supply voltage of 115V to 230V auto range, rated mains frequency of 47 to 63 Hz, rated input of 115V at 10A or 230V at 5A, efficiency of 85% minimum at typical load, holdup time of 16.6ms at nominal line under full load condition, power good signal between 100ms to 500ms, over current protection at 110% to 150% individual output power, over voltage protection for +5V is between 5.8V to 6.3V,+12V from 14V to 17V, 3.3V from 3.6V to 4.2V, air flow by DC fan, operating temperature of 0°C to 50°C and operating humidity of 20% to 90% non-condensing.

2themax gpx750电源为桌上型电脑的功能总产量750瓦特，额定电源电压115v到230v汽车范围，额定工频47至63赫兹，额定输入的115v在10 A条或230v在5 ，效率85 ％，最低在典型负载，持的时间16.6ms的名义在网上下，满负荷条件下，电源良好信号之间的100 ms到500ms ，过电流保护在110 ％至150 ％个别的输出功率，过电压保护，为5 V是之间的5.8 V至6.3v ，+12 V的从14v至17v ，电压为3.3 V从V到3.6 V至4.2 V ，空气流量由直流风扇，操作温度0° C到50 ° C和运作中的湿度为20 ％至90 ％，非冷凝。

Insulation Resistance meauring: rated voltage of 100 V and above, use of 1000 V Megohmmeter; rated voltage below 100 V, use 500 V Megohmmeter.

绝缘电阻的测定：额定电压为100V及以上者，使用1000V兆欧表；额定电压为100V以下者，使用500V兆欧表。

Do not supply power voltage higher than the rating voltage, which may cause fire or systematic damage.

不要使用高于额定工作电压的电源，使用高于本产品额定电源可能会引起火灾或系统损毁。

At the same time, the introduction of proportional solenoid control valve core part of the location of the pilot, the design specifications for valves used in Path parameter for the 32mm, the largest flow 480L/min, I rated the work of oil into the pressure of 31.5MPa, I rated the oil pressure to 30.5MPa.

同时引入比例电磁铁控制先导部分阀芯位置，本设计所采用的阀门规格为通径参数为32mm，最大流量为480L/min，进油口额定工作压力为31.5MPa，出油口额定工作压力为30.5MPa。

6 A max when input rated voltage and output rated load.

当输入额定电压带额定负载时，最大的输入交流电流 0.6A

This invention concerns a current control process for a feed-in voltage converter, wherein a detected flux-inducing current component and a detected torque-inducing currrent component of an actual currrent vector of a rotating field machine are each controlled for a flux-inducing current component set value and a torque-inducing current component set value of the rotating field machine. To that effect, a control set-value (DELTA u*sp, DELTA u*sq) is determined, dependent each time upon a determined current component control deviation. From these, current components of an actual current vector are formed each time by overlay of a formed pilot value (u*spvor, u*sqvor). This invention also concerns a device for carrying out this process.

本发明涉及一种用于馈入电压式变流器的电流调节方法，其中分别将所检测的一感应式电机的一实际电流向量（i s 的磁通感应电流分量和一转矩感应电流分量i sq ）调节至该感应式电机的一额定电流向量的一磁通感应分量额定值和一转矩感应电流分量额定值，在这种情况下，分别根据所检测的一电流分量调节偏差计算出一调节器调节量（△u * sp ，△u * sq ），由这两个调节器调节量分别通过叠加所形成的一预控制量（u * spvor ，u * sqvor ）形成一额定电压向量的电压分量（u * sp ，u * sq ），本发明还涉及一种用于实施该方法的装置。

CJX2－d Series AC contactor is mainly used in the ciruit AC 50HZ (or-60HZ),rated insulating voltage is 380V unde AC-3 usage it can be combined with suitable thermal overload equipment into a electromagnetic starter to protect the circuit that may appear overload The comactor can be equipped with builbing block style auxiliary con tact group、air delaying contact、Interlonking mechanism and so on ac cessories to combined into time relay、reversible comtactor and star-delta starter.

CJX2-d系列交流接触器主要用于交流50HZ（或60Hz，额定绝缘电压为660V，在AC-3使用类别下额定工作电压为380V时额定工作电流至95A的电器中，供远距离接通和分断电器，并可与适当的热过载电器组成电磁起动器以保护可能发生过载负荷的电路。接触器可组装积木式辅助触头组、空气延时头、联锁机构等附件；组成延时继电器、可逆接触器、星三角起动器。

And Pharaoh spoke to Joseph, saying, Your father and your brothers have come to you.

47：5 法老对约瑟说，你父亲和你弟兄们到你这里来了。

Additionally, the approximate flattening of surface strip using lines linking midpoints on perpendicular lines between geodesic curves and the unconditional extreme value method are discussed.

提出了用测地线方程、曲面上两点间短程线来计算膜结构曲面测地线的方法，同时，采用测地线间垂线的中点连线和用无约束极值法进行空间条状曲面近似展开的分析。