颗粒分析

The distributing of SiC in the composite material and the decomposer of SiC and interface between steel and SiC are analyzed too.

分析了SiC颗粒在基体中的分布状况、SiC颗粒在高温钢液和热处理过程中的分解以及其与基体的界面结合状况；同时还对制得的复合材料进行力学性能如显微硬度、硬度、耐磨性作了与基体金属的对比实验并分析了SiC颗粒的加入对于提高复合材料的性能的影响。

In this paper, the effects of factors like flotation、cooling velocity on distribution and microstructure of the material were studied under the condition of unidirectional and multidi〓tional solidification, an order of magnitude analysis was performad in order to understand the dynamics of an advancing solid/liquid interface behind a particle as well as the behavior of the particle in front of the interface, and a model of critical velocity for the pushing/engulfment transition of particles by the interface was built, the theoretic result gave a good explain to experimental one.

本文考察了在常规铸造和定向凝固条件下，浮力、冷却速度等因素对SiC颗粒分布以及材料组织的影响，分析了颗粒在凝固过程中的行为以及对界面的作用，建立了在胞状树枝晶凝固条件下枝晶对颗粒的推移/吞并临界速度模型，理论分析和实验结果基本一致。

With the theoretical model of spherical grain dynamics of sparse two-phase flow in single dimension, computing formulas of velocity′s attenuation and scattering distance were built for explosive residue grains in horizontal. Then, a simplified theoretical model on distribution of explosive residue was put forward on the basis of a spherical space with radius equalling to maximum horizontal scattering distance of explosive residue grains with certain diameter.

为了对残留物颗粒的飞散运动及分布规律进行理论分析，利用球形颗粒一维稀疏二相流动力学模型，研究得到炸药残留物颗粒的速度衰减及水平飞散距离计算公式；在此基础上，建立了以某粒径残留物颗粒水平运动极限距离为半径的炸药残留物颗粒球面空间分布简化理论模型。

The deformation of conductive particles in pure metal connected by anisotropically conductive adhesives has been investigated using finite element analysis. The results indicate that the increment in stresses of the conductive particles begins at the contact area toward the boundary through the centers of conductive particles when the reduction in height increases. When stress is over the yield strength, the similar behavior was observed. So the deformation of conductive particles is not uniform, which means that the deformation of conductive particles is the same as the stress does.

采用有限元模拟分析了各向异性导电胶连接的纯金属导电颗粒的变形过程，研究结果表明，随着压下量的增加，导电颗粒的应力增加由接触面开始，经中心区域向导电颗粒的周边扩展，大于屈服强度的应力变化与此相似，因此导电颗粒的变形是不均匀的，即导电颗粒的变形由接触面开始，经中心区域向周边区域进行。

Using the SEM, polarized light microscope and X-ray analytical method, granule morphology, granulitization and Non-crystalline of starch with non-crystallized granule state were investigated. Corn, tapioca and potato of non-crystalline had blowing out pole. Some poles of non-crystallized corn were big and deep, and the other little and low. Pole of tapioca of non-crystalline was low, and pole of potato was a big, deep stripe.

采用扫描电镜、偏光显微镜、X-射线等分析测试手段，对非晶颗粒态淀粉颗粒形貌以及颗粒性、非晶性进行了研究，发现非晶玉米、木薯、马铃薯淀粉均具有爆裂孔，其中非晶玉米淀粉颗粒的孔有的大而深，有的小而浅；而非晶木薯淀粉颗粒的爆裂孔较浅，而非晶马铃薯淀粉则形成一大而深的长条形的爆裂孔。

It is very detrimental to materials performance. From the viewpoint of the effects of PPB precipitation on the frature of hipped P/M Rene'95, the surface segregation and reaction in Rene'95 powder metallurgy superalloy were analyzed by modern surface techniques and by electron microscopy. The mechanisms of the formation and reduction of PPB precipitation are revealed.

本文从原始颗粒边界析出对热等静压压坯断裂的作用的角度出发，利用现代表面分析技术及电子显微分析技术研究了Rene′95雾化粉末表面的偏析、预处理粉末的表面反应和表面析出相的粗化规律以及热等静压压坯的界面反应和原始颗粒边界析出相，揭示了原始颗粒边界析出的形成机理和预处理方法改善原始颗粒边界析出的原因。

From the experiment results,it is concerned that the thin film was composed of many small particles(most of them was with a size between 20 and 30 nm)uniformly deposited and intervein on the substrate surface. Some large particles were tightly embedded into the thin film.The deposition rate increased by increasing the precursor flow rate and the discharge power.

以上的分析结果表明：常压等离子化学气相沉积得到的薄膜是一种由众多小颗粒(其中主要为尺度在20-30nm的颗粒)的颗粒串联形成的网孔结构，并且在薄膜生长过程中一部分的颗粒被包埋在其中，薄膜颗粒分布较均匀。

In the case of granite, observation results indicate that the extending routes of active cracks are mainly intercrystalline, transcrystalline, inter-transcrystalline, and intracrystalline. When the strain rate is low, the long intercrystalline cracks are prevailing, and with increasing of the strain rate, the short transcrystalline and intracrystalline cracks gradually increase. The statistic results show that the active crack density increases with increasing of the strain rate, and the mean length of active cracks diminishes with increasing of the strain rate, that is, the induced damage in comminuted product increases with increasing of the strain rate. For the first time this dissertation integrates macroscopic results of comminution with active crack growth under impact loading. It elucidates why the dynamic comminution strength of mineral beds increases with increasing of the strain rate through the active crack extending, and analyzes the influence of structure and constitution of minerals on their damage under impact stress. It is authenticated that both the size distribution and the damage population of comminuted product can be characterized by the fractal.

为分析料层颗粒在冲击下的细观损伤效果，采用德国生产的ASM68K半自动图象分析仪对粉碎生成物中的损伤情形进行了观测，以花岗岩为例，观测结果表明花岗岩颗粒在冲击应力下的活化裂纹扩展路径主要表现为沿晶、穿晶、沿穿晶和晶内等形式，在低应变速率下，活化裂纹以沿晶裂纹较多，随着应变速率的提高，其它裂纹形式大量繁衍，统计结果表明活化裂纹密度随着应变速率的增大而增大，活化裂纹的平均长度随着应变速率的增大而减小，综合表现为颗粒的细观损伤程度随着应变速率的增大而增大；首次将应力作用下的活化裂纹演化特征与粉碎的宏观效果相联系，并就料层动态粉碎强度随应变速率增大而提高的现象从裂纹演化特征的角度进行了解释；分析了矿岩构造结构特性对损伤产生和分布的影响。

The second part was to test the appearance, ingredient analysis, surface potential, thermal conduction properties, and magnetism of the nano composite fluid prepared from the parameters. The experiment found that unoxidized particles, Ag, Cu, Fe, and Ni appeared round. If combined with oxygen in water as oxides, the nano particles would grow toward certain directions. In copper/iron nano composite fluid, FeO appeared cubic, Cu2O appeared coniferous. In silver/iron nano composite fluid, FeO was polygonal. In dielectric potential detection, the nano composite fluid was likely to aggregate and deposit, except for silver/iron set. In other sets, the pH of silver/cobalt nano composite fluid was 7, surface potential was 21.21mV; the pH for silver/nickel nano composite fluid was 6.5, surface potential was 21.04mV; the pH for copper/iron nano composite fluid was 7, surface potential was -30mV. The fluid particles of the three sets could all maintain suspension of 2 weeks or more. For thermal conduction, the silver/nickel, nano composite fluid showed the best thermal conduction. Under temperature of 30℃ fluid weight conduction of 0.4%, the thermal conduction increase was 26%. For magnetic detection, except for silver/iron nano composite fluid, the nano particles of other three sets were paramagnetic, and all four sets were soft magnetic nano composite materials.

第二部分。将由较佳制备参数所产出的奈米复合流体，进行形貌外观、成分分析、表面电位及热传导性质实验与磁性检测；在奈米颗粒的形貌部分，经实验发现Ag、Cu、Fe、Ni等未氧化的颗粒皆呈现近似圆形，而若与水中的氧结合形成氧化物，奈米颗粒则会朝特定方向成长，在铜/铁奈米复合流体中FeO为四方体结构、Cu2O的颗粒是针叶状，在银/铁奈米复合流体中FeO则为多边形结构；而介面电位检测方面，结果显示经本制程所产出的奈米复合流体除银/铁奈米复合流体这一组较容易聚集沉淀外，其他三组中银/钴奈米复合流体的pH值为7，表面电位为21.21mV，银/镍奈米复合流体的pH值6.5表面电位为21.04mV而铜/铁奈米复合流体的pH值为7时表面电位约在-30mV，且此三组流体颗粒皆能维持悬浮性2周以上，悬浮性较佳；热传导实验部分，四组奈米复合流体中以银/镍奈米复合流体在增进热传上效果最佳，在温度30℃及流体重量浓度0.4﹪条件下热传导系数增进达26﹪；磁检测方面，除了银/铁奈米复合流体外，其他三组奈米颗粒皆属顺磁性，且这四组奈米复合材料都是属软磁性。

In order to design optimally a model of screw conveyer which can simulate the separation of silt in Yellow River,the geometry of screw and the forces applied onto the silt particles were investigated in detail,and a horizontal screw centrifuger suitable for silt separation on Yellow River was designed by means of simulation.

为了优化设计一种可以模拟黄河泥沙分离的螺旋输送器模型，较细致地研究了螺旋的几何形状、作用在颗粒上的力以及模拟设计适应黄河泥沙分离用的卧螺离心机，优化分析了各个作用力对分离颗粒的受力情况，然后通过数值模拟螺旋输送器对液流中颗粒的作用状况，简单地分析了液流在螺旋输送器作用下的主要特征及其建模理论。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。