频率

This thesis introduces the research history of sonoluminescence, the properties and equipments of single-bubble sonoluminescence and the factors affecting the amount of light emission. Based on the experimental realization of SBSL, the experiment in this thesis is to confirm the coherence between the emitting frequency and the driving cycle of SL. Under this feature ,we established the programme of the experiment that measure the angular correlations in SBSL , built the experimental devices and conducted initial measurements .Then we got the conclusion that there is a presence of non-spherical symmetry in the process of SBSL .

本文介绍了声致发光的发展历史，对单泡发光的特性和实现声致发光的设备进行了描述，对影响发光强度的要素做了概述；并在实现单泡声致发光的基础上通过实验验证了单泡声致发光的发光频率与驱动超声频率具有一致性的特点，根据这一特点确立了声致发光角分布测量的实验方案，建立了实验装置，并进行了初步测量，得到在声致发光的过程中存在着非球形对称状态的结论。

Positive frequencies are produced by anticlockwise rotation and negative frequencies by clockwise rotation.

正频率是用逆时针旋转来产生，而负频率是用顺时针旋转来产生。

Finally, we investigated the expression of STDP at LPP synapses. One stimulating electrode was placed at LPP to evoke fEPSP. At the same time, another stimulating electrode was placed at mossy fiber to evoke antidromic APs.

在一段0.033 Hz频率10分钟的基础刺激之后，相关性长期增益可以被引发出来（兴奋性突触后电位在回溯性动作电位之前30 ms之内，并以0.167Hz的频率共配合100次），当配合时间差大於30 ms时长期增益就无法被引发了。

The frequencies ofpostoperative nausea and vomiting and frequencies of requirementfor rescue antiemetic and antipruritic were recorded.

记录术后恶心呕吐的发生频率和止吐剂止痒剂的使用频率。

Record the Signal Generator frequencies and the distances between adjacent antinodes for the next three resonant modes by adjusting the frequency in the Signal Generator window and by sliding the detector coil from one antinode to the next antinode.

为测量下面三个共振模，需要调节信号发生器窗口的频率，以及将探测线圈从一个波腹移动到另一个波腹，同时记下信号发生器的频率和相邻波腹间的距离。

The results show that injection locking synchronization is realized when injection rate is large enough. In the injection locking regime, similarity index is larger for external modulation than that for direct modulation. If injection rate keeps unchanged, synchronization is little affected by modulation index, but it is affected by modulation frequency. Since outputs of the master laser are antiphase for direct modulation and external modulation, the fluctuations of similarity index with modulation frequency for the two lasers are contrary.

研究结果表明：当注入强度足够大时，系统实现注入锁定同步，外部调制的相似指数大于内部调制；注入强度恒定时，同步品质几乎不受调制指数的影响，而受调制频率的影响；由于内部、外部调制引起主激光器的输出反相，两种调制方式下同步品质随调制频率的变化趋势也相反。

The receptance characteristics of track system has been predicted with the three dimensional track for high frequency vibration, with this model, the structure parameters of track system affect onreceptance have been discussed. The results show that the stiffness of ballast, sleeper mass, and stiffness of railpad are the main factors affecting on resonance and antiresonance under second resonance frequency.

利用轨道系统高频振动模型预测了各种参数对轨道系统导纳特性的影响，结果表明：道床刚度、轨枕质量和轨枕垫刚度是影响轨道系统第二阶共振频率以下共振和反共振的主要因素，随道床刚度增加，或轨枕质量减小，或轨枕垫刚度增加，第一、二阶共振和第一阶反共振频率增加，道床阻尼、轨枕垫阻尼主要影响第一、二阶共振和第一阶反共振振幅，阻尼越大，共振峰值和反共振谷值越平缓。

And children diet frequency, father educational background and age, mother age, family income all cause apparent difference on children diet frequency.

而幼儿饮食频率方面，父亲教育程度与年龄、母亲年龄、家庭收入皆对幼儿饮食频率有显著差异。

Put forward is a new method of skin effect correction based on function relationship between the real part of apparent conductivity against frequency and true formation conductivity in uniform formation condition.

根据均匀地层感应测井视电导率实部与频率和地层电导率的函数关系提出了一种双频率校正与归一化校正相结合的趋肤效应校正新方法。

The results indicate that the thermal conductivity of Si3N4 thin film increases with the temperature;under high frequency stage the frequency has apparent effect on the thermal con...

测试结果表明：Si3N4薄膜的热导率随温度的升高而增大；高频段下，热导率受频率影响大，误差大；在低频段下薄膜热导率与频率变化基本无关；基于电子与声子的局部热平衡运输方程假设，S i3N4薄膜的热导率具有极度非平衡性；通过比较电阻、热导率与温度的关系可以看出加热器的尺寸大小会影响薄膜的热导率，最佳加热器的宽度选用20μm左右。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐