预热

Grease a 7.5cm/3 inch deep ovenproof dish.

170C预热烤箱。取一个7.5cm长/3 英寸深的烤箱用盘（吐司烤盒，用少量黄油均匀涂抹盒的内壁、边角

DAYANG" products include: rotary kiln, ball mill,"Possession of mill, cement mill, raw mill, raw mill, cooling machine, dust collector, vertical mill, drying machine, crushing machine, five cyclone preheater device, humidification tower, the wind swept coal mill, roller press, plate feeder, bucket elevator, screw conveyor and other building materials machinery and chemical machinery and auxiliary electrical control system and a variety of bridges mold.

大洋产品有：回转窑，球磨机，〈管磨机、水泥磨、生料磨、原料磨〉、冷却机、收尘器，立式磨，烘干机，破碎机，五级旋风预热器、增湿塔、风扫煤磨、辊压机、板式喂料机、斗提机、螺旋输送机等建材机械和化工机械及配套电气控制系统以及各种桥梁模具。

After cracking of No 16 high pressure turbine's governor valve base have happened in Shanghai Chongming Power Plant, through the theoretical analysis to the weldability of this governor valve base's pearlitic heat-resisting cast steel and sensitivity of the reheat cracks , we provided, the basis for the preheat temperature and postweld heat treatment procedure of site repair welding.

崇明电力公司 16号汽轮机调门座发生裂纹后，通过对该调门座合金钢材料焊接性、再热裂纹敏感性的理论分析，为现场焊补工艺提供了预热温度和焊后热处理的工艺依据。

MOTOMAN SK-16 arc welding robot system with YASNAC MRCⅡ controller, welding power, wire-feeding structure, cooling system, V-plank and preheat system, it can accomplish continuous welding for multi-nipple fillet-welds of power boiler header .

MOTOMANSK -16弧焊机器人配用YASNACMRCⅡ控制器、焊接电源、送丝机构、冷却系统、V形支架和预热装置，通过示教再现的方式可完成电站锅炉集箱管接头多个角焊缝的连续焊接。

The paper gives the thermoanalysis model in different use of boiler waste-heat and the caculation method of conservation-energy evaluation index.

1前言目前，油田不少锅炉先后采用了不同的烟气余热回收方法回收烟气余热，并用来预热燃油、空气和给水。

Our most important energy conservation project at present is waste heat power generation.

当前我们最重要的节能项目是预热发电项目。

The temperature of flue gas out of air preheater in boiler is normally about 120～180℃, the flue gas enter the absorb tower from the bottom via pre-deduster and is accelerated by venturi tube at the bottom of absorb tower, then is taken to circulating fluid bed. The materials are in the circulating fluid bed, due to the effect of flow, the gas-phase and solid-phase generate fierce turbulence and combination and are fully contacted, then form polymers constantly during the ascending and return downward, while the polymers are constantly disassembled during fierce turbulence and elevated by airflow, which makes the slip velocity between gas and solid reach the tenfold times of single slip velocity.

首先从锅炉的空气预热器出来的烟气温度一般为120～180℃左右，通过预除尘器后从底部进入吸收塔，然后烟气通过吸收塔底部的文丘里管的加速，进入循环流化床，物料在循环流化床里，气固两相由于气流的作用，产生激烈的湍动与混合，充分接触，在上升的过程中，不断形成聚团物向下返回，而聚团物在激烈湍动中又不断解体重新被气流提升，使得气固间的滑移速度高达单颗粒滑移速度的数十倍。

Main function of RH preheating burner is to bake vacuum tank and impregnation pipe.

RH预热枪系统的主要功能是烘烤真空槽和浸渍管。

Based on analysis of preheating burner process and control requirement, baking function of vacuum tank was achieved according to flow mode and curve heating mode.

在分析了预热枪的工艺过程和控制要求的基础上，实现了按流量模式和曲线加热模式烘烤真空槽的功能。

In this unit,a large fraction of latent heat of the condensate and the sensible heat of brine is successfully recycled for preheating the feedstock and for its evaporation process.

由于在系统的蒸发及冷凝过程中，大部分水蒸汽的凝结潜热被重复利用于海水的预热及蒸发过程，因而系统具有较高的产水率。

By the time of its fall, most of the prisoners were writers who had written against the corruptions of the government.

到它被攻陷的时候，里面多数的犯人是写了反对政府贪污文章的作家。

The most obvious variation to ovum morphological character was that the color was changed from light green to sepiaceous in embryonic development, and all the ovums were almost hatched after 96h.

在胚胎发育过程中卵的形态特征最明显的变化是颜色从淡绿到深褐色，卵在发育96h后卵基本全部孵化。