预水合

A steel bar is washed and dried, and then put into a glass pipe which is sealed to obtain stirring magneton; a mixed solvent of Gamma-methacrylate oxide propyl trimethoxy silane and methanol is prepared and added with an organic base to obtain a pre-bonding solvent; the stirring magneton is immerged into the pre-bounding solvent, and the outer surface of the glass pipe of the stirring magneton is bonded with a layer of silane substance with alkenyl; a reactive monomer mixture and a pore-forming agent mixed solvent are evenly mixed and then added into a container, the stirring magneton after the pre-bounding is put into the container which is sealed and then put into a water bath; after reaction, the container is removed, the stirring magneton coated with a polymer is taken out and put into a extractor and extracted by using a solvent; or the stir bar is immersed into the solvent till no impurity can be checked in the solvent, thereby obtaining the product.

将铁条清洗干燥，放入玻璃管内，密封得搅拌磁子；配制γ-甲基丙烯酸氧丙基三甲氧基硅烷与甲醇的混合溶液，加入有机碱得预键合溶液，将搅拌磁子浸入预键合溶液，在搅拌磁子的玻璃管外壁键合一层带烯基的硅烷化物质；将反应单体混合剂和致孔剂混合溶液混匀后倒入容器中，将预键合后的搅拌磁子放入容器，密封后置于水浴中，反应后除去容器，取出涂有聚合物的搅拌磁子，置于提取器中，以溶剂提取，或将搅拌棒置于溶剂中浸泡至溶剂中无杂质检出，得产物。

The study indicated that, with SnCl22H2O and TSA as the catalyst, the comparatively appropriate reaction conditions were as follows: the catalyst content was 0.5% to OLLA, polymerized at 180℃ for lob under a system vacuum of 0.98 MPa.

研究表明，较为适宜的工艺条件为：以二水合氯化亚锡(SnCl22H2O)和对甲基苯磺酸为催化剂，且SnCl22H2O相对于乳酸预聚体的质量比为0.5%，真空度－0.98MPa，温度180℃，反应时间10h。

Ultrafine copper powder s were prepared by direct reduction method with hydrazine hydrate and formaldehyde as composite reductive agent and glucose prereduction method,respectively.

分别采用水合肼-甲醛复合还原剂法以及葡萄糖预还原法制得了微米级的超细铜粉，并利用粉末X射线衍射以及扫描电镜对其进行了表征。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。