面

There are intimate connection between the Bouguer gravity anomaly and the Moho depth, so it is one of main methods to inverse the Moho depth according to gravity anomaly.

布格重力异常与莫霍面深度之间具有紧密的联系，利用重力异常反演莫霍面深度成是研究莫霍面深度和编制莫霍面深度图的主要手段之一。

In the tread compound tests showed that with the reduced amount of softener, tread rubber hardness increase in the formula for the 7:00 performance tables are in line with national standards tread compound, in the formula Add a renewable 10 ordinary plastic tensile strength, elongation at break are not GB request, and add 10 high-performance renewable plastic, also reached the performance tread compound GB requirements, and easy Compound and the time is short, and other process performance is also very good, adding 10 HPRR than not joining the compound reduced costs 0.73 yuan / Kg.

在轮胎胎面胶试验中表明，随软化剂用量减少，胎面胶硬度增加，在配方为表七时各项性能均符合轮胎胎面胶国家标准，在该配方中添加了10份普通再生胶拉伸强度、扯断伸长率都达不到国标要求，而添加10份高性能再生胶，各项性能亦达到轮胎胎面胶国标要求，并且炼胶易、时间短、其他工艺性能也大好，添加10份HPRR比没加入的胶料成本降低了0.73元/Kg。

In order to model complex hair styles, such as curly hairs and wavy hairs, we first construct five types of surfaces and three curves: curved cylinder, curved circular frustum, curved prism, curved edged frustum, curved revolving paraboloid, and curved cylinder helix, curved circular frustum helix and curved revolving paraboloid helix. Then we give the expressions for points and normal vectors on these surfaces, suitable to composition.

为了构造复杂发型，例如卷发发型和波浪发型，我们首先构造了五种曲面和三种曲线：弯曲圆柱面、弯曲圆台面、弯曲棱柱面、弯曲棱台面和弯曲旋转抛物面，以及弯曲圆柱螺线、弯曲圆台螺线和弯曲旋转抛物螺线，并且给出了这些曲线曲面上适合于拼接的点和向量的表示方式。

So before applying Mather's theorem of connecting orbits to concrete Hamiltonian system, we have to check whether the set W〓 is empty or not, and which cohomology classes are C-equivalent. In present paper, by investigating the topological structure of action minimizing sets near a co-dimensional one torus which is preserved under generic perturbations and becomes hyperbolic in nearly integrable Hamiltonian system.

与传统的Poincaré-Melnikov方法相比，我们方法明显优越之处在于，一方面我们的方法不仅可以得到双曲环面之间的异宿轨道，而且当该环面附近的其它环面破裂时，可以得到不同Mather集之间的连接轨道，另一方面，我们把异宿轨的存在性的证明转化为双曲环面极小同宿轨的某种弱孤立性的证明，所需条件比Poincaré-Melnikov方法弱得多。

With the viscosity solution of Eikonal equation, a method is proposed on the 3D reconstruction of convex surface based on an image. Then, the additive saddle surface and multiplicative saddle surface are defined.

利用Eikonal方程的粘性解给出了基于单幅图像的凸面三维重建算法；定义了2类鞍面--加性鞍面和乘性鞍面。

Between the {111} planes in single crystal Si there are two interplanar spacings, d(111) and d(111), but there is only one interplanar spacing d(110) between Si {110} planes, so that their blocking dips would be different.

单晶Si的{111}晶面有两个面间距d_(111)~和d_(111)~，而{110}晶面只有一个面间距d(110)。由此导致两者的堵塞坑是不同的，我们已从α粒子和质子的Si单晶堵塞效应的实验得到了证实。

Results revealed that the large side insulation of the stator bar in slot is available for ultrasonic pulse-echo testing; Coupling transducer on the surface of a practical stator bar could minimize the influence on the measurements of velocity, contributing no destructivity of the ultrasonic testing for stator insulation; The simultaneity of same velocity and higher attenuation can be used to detect insulation delamination from conductors; Compared with the wide sides of the bars in slot, the short sides of the bars near the exit from slot and the end bars had a same velocity and a higher attenuation; The velocity might be exactly measured on the shot sides of the bars near the exit from slot and the end bars, while the attenuation might not, which were examined though filed tests; V min decreased greatly and V av decreased slightly with the service time of the bars.

在实验室对线棒多种结构处的主绝缘和不同运行年数(未老化、16、18 和23年)线棒的主绝缘进行了低频超声反射法检测试验，并进行了现场试验，发现(参见 Hao et al， IEEE DEI， to be published)，槽部线棒的宽面绝缘不受换位绝缘的影响，比窄面绝缘更适合超声测量；线棒表面平滑的半导体层减小了耦合剂对超声测量的影响，实现了无损性；波速不变而声衰减减小可以检测线棒出现绝缘与导体脱壳缺陷；出槽口和端部线棒的窄面绝缘与槽部线棒的宽面绝缘相比，声衰减大而波速一致；现场试验验证了波速不受绝缘结构和现场测试条件的影响，而声衰减受以上因素影响很大(参见 Hao et al，中国电机工程学报， Vol.23 No.4)； V min 随运行年数明显减小， V av 随运行年数慢慢越小。

First, this paper, in the field of intrinsic geometry, studies the geometric problems on garment design, as well as applies the frame and semi-geodesic coordinates to prove the fundamental theorem of being a developable surface.

文中首先在内在几何学的层次上，研究了服装设计所涉及的几何学问题，应用标架与半测地坐标方法证明了曲面成为可展面的基本定理，研究了可展面的分类及其性质，考虑到服装三维几何造型的需要，证明了组合式可展面各组成片相切连接条件的命题，作为构造可展面的理论依据，证明了单参数平面族的包络面必为可展面的命题，在此基础上发展出服装几何造型的"刮大白"方法以及相关的三种构造可展面的解析方法。3D→2D的变换是三维服装CAD的重要内容之一，其几何学实质是曲面的定长映射，文中总结了定长映射即可展面在平面上展开的基本准则，在这一准则的指导下，结合服装设计与相关领域的要求，讨论了可展面在平面上展开的解析方法与数字方法，上述内容确立了服装设计几何学的基本框架。

Our results show that the duality of self-dual tetrahedral link is "trivial", and the duality of hexahedral and octahedral link as well as dodecahedral and icosahedral link are "nontrivial".

从构型角度考虑，四面体链环的自对偶是"平凡"的，六面体链环和八面体链环，十二面体和二十面体链环的对偶是"非平凡"的。

The characteristics of the MHD structure observed in the soft x-ray tomography are as follows. It is constructed with m=2 mode oscillation, so that the magnetic surface is made up of two islands. The structure of the magnetic surface is relatively stable. It rotates in the direction of the electron dia-magnetic drift, and the rotation frequency is the half of the oscillation frequency of soft x-ray signals.

通过SX反演图象分析，MHD型磁面结构的特点：一是m=2模的振荡构成，因而此磁面始终有两个岛组成；二是磁面结构相当稳定，在MHD放电过程中没有明显变化；三是磁面结构整体沿电子逆磁方向极向旋转，旋转的频率是软X射线测量的信号频率的一半。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。