面

Such as: chicken broth, shrimp, seeds, eggs, vegetables, carp, monosodium glutamate XieHuang egg, fine fine delicate, more than ten varieties of these varieties are distinctive, Different varieties of different flavor, taste delicious, easy to digest the food, the elderly and infirm, can appetitive, enhanced physique, both young and nutrition food.

鸡汤面、虾籽面、鸡蛋面、鲫鱼面、果蔬面、蟹黄面、味精挂面、蛋清挂面等十多个精致品种，这些品种各具特色；不同品种风味各异，味道鲜美，易于消化，年老体弱者食之，能促进食欲，增强体质，是老少皆宜的营养食品。

The characteristics of pentacene/perylene derivatives based organic solar cells are investigated in this thesis Donor and acceptor layers are pentacene and N N'-dioctyl-3 4 9 10-perylenetetracarboxylic diimide (PTCDI-2~13C) respectively Twelve organic solar cells with pentacene/PTCDI-2~13C heterojunctions were fabricated to study the influence of various alkylic perylene derivatives on the power conversion efficiency Under the sunlight simulator with AM1 5G filter and 100 mW/cm2 the solar cell of pentacene/PTCDI-7C heterojunction with cathode of Ag/Al bilayer has the best performance among the devices with pentacene/PTCDI-2~13C heterojunctions In PL spectrum analyses the pentacene/PTCDI-7C film had lower recombination rate than the other pentacene/PTCDI-2~13C films; therefore more excitons could reach the P/N junction and enhance short-circuit current Furthermore the PTCDI-7C film grown on the surface of penatcene was more matched than other PTCDI films analyzed by the PL peak shifts of 10 nm and 45 nm thick PTCDI-2~13C and images of atomic force microscope More lattice match between the films of pentacene and PTCDI resulted in fewer defects in P/N junction and more carries can reach electrodes Accordingly the power conversion efficiency approach 2% was obtained from the solar cell with the active layer of pentacene/PTCDI-7C

本研究探讨以五环素/骈苯衍生物异质接面太阳能电池之特性，利用pentacene作为电子施体有机材料，PTCDI -2C~13C作为电子受体有机材料，制作出异质接面为pentacene/ PTCDI-2C ~13C等12种有机太阳能电池，比较不同碳数的骈苯衍生物对於有机太阳能电池之光电转换效率之影响。在AM1 5G、100 mW/cm2的模拟太阳光下，以pentacene/PTCDI-7C异质接面太阳能电池具有短路电流9 882 mA/cm2、开路电压0 376 V、填充因数0 523及光电转换效率达1 945%，皆比其他pentacene/PTCDI-2C ~13C异质接面太阳能电池来的大。由薄膜分析可知PTCDI-7C在这12种太阳能电池中具有较低的电子电洞复合发光效率，可以让较多激子到达异质接面进行电荷分离，减少电子电洞对复合发光的机率；此外，由光激发萤光光谱之峰值位移配合原子力显微镜表面结构图，可以得知当PTCDI-7C成长在pentacene上时会顺著pentacene的结构成长薄膜，故较无缺陷产生在P/N接面处；而在其他结构下则无此现象产生，致使在pentacene/PTCDI-7C薄膜中的载子有较大的机会可以移动至电极，使光电流提高，进而使光电转换效率提高。

Figure 3 the rink and the dot or reduce the map click here to view all news photo 3 1/4 tiles there are four 50% of the standard that is used to control exposure, proofing, Business card printing and membership card when the layout of the deep and superficial changes. 50% of the standard dot if the angle is large, targejia dot gain, on the other hand if a crane in the four corners, the dot.

图3 目测网不面增不小或放不小图不面击此处查察残部故事图片3）每1/4图块洋有4个50%的尺度不圆网不面，用于把持晒版、打样、制卡和会员卡制作时版面的深浅变冻。50%的尺度不圆网不面如果搭角不小，则网不面增不小，反之如四角脱开，则网不面放不小。

A calculating method to determine the clearance size of the rudder face along the extension direction of the swept-back wing for airplane is presented, which can be used for calculating the clearance size of the rudder face at limiting deflection angle, and point out that several parameters for determining the caearance is essential .

本文针对某型无人机翼面、舵面设计，首先导出了一种确定后掠翼舵面展向缝隙尺寸的计算方法，使用该方法能够定量地计算舵面在极限偏转角下缝隙的尺寸，并指出决定舵面缝隙大小几个主要参数，为舵面缝隙设计提供了可靠依据。

On the rhombohedron face {1011}, Dauphine twinning showed different shapes of etching pits between individuals, because rhombohedron positive form {1011} and negative form {0111} appeared on both sides of twin partition line, while Brazil twinning showed symmetry plane between the irregular triangle etching pits of individuals. On the trigonal prism section 11(average20, Dauphine twinning showed different shapes of etching pits between individuals, because trigonal prism positive form {1120} and negative form {2110} appeared on both sides of twin partition line, while Brazil twinning should show symmetry plane between the ellipse or quadrilateral etching pits of individuals, which was not observed.

菱面体{1010}面上存在道芬双晶处，道芬双晶双晶缝合线两端分别是菱面体正形、菱面体负形出露处，导致蚀坑形状不同；菱面体{1011}面上存在巴西双晶处，不规则三角形蚀坑形态的方位关系为对称面关系；三方柱切面{1120}面上存在道芬双晶处，道芬双晶双晶缝合线两端分别是三方柱正形、三方柱负形出露处，导致蚀坑形状不同；三方柱切面{1120}面上存在巴西双晶处，椭圆形或四边形蚀坑方位应为对称面关系，但实验中未见到。

The results indicate that the main erosion type is sheet ero-sion at the beginning of the rainfalls, and serious erosion happens after rill erosion appears. Accumulated sheet and rill erosion amount increases with the rainfalls time. The percentage of sheet erosion amount decreases and rill erosion percent-age increases with time. At the end of the rainfalls, the total rill erosion amounts are 4.3 and 5 times more than sheet ero-sion.

研究结果表明，降雨初期坡面以面蚀为主，细沟出现后，坡面侵蚀将加快加剧；随着降雨时间的延续，累积面蚀量和细沟累积侵蚀量都将逐渐增加，后者的增加速率大于前者，面蚀所占总侵蚀量的百分比随降雨时间呈曲线形式逐渐递减，细沟侵蚀则逐渐增加；试验结束时细沟侵蚀量分别为面蚀量的4—5倍。

It is sometimes referred to by the nickname "Chinese spaghetti" in the West, which is symmetrical to Chinese calling spaghetti bolognese "Western zhajiang mian."

人们有时候称炸酱面为"中国面条"就像我们把意大利面叫做西方炸酱面一样。人们有时候称炸酱面为"中国面条"就像我们把意大利面叫做西方炸酱面一样。

We also developed several experiential formula based on structural unit model for high-index surfaces, which can give an estimate of the energies of the high-index surfaces if the value of surface energy of (001),(110) or (111) are known.

作为各条曲线表面结构单元的两个低密勒指数面[001]晶带的(100)面和(110)面，[-110]晶带的(110)面和(111)面或(112)面其表面能值分别是对应曲线上的一个极小值点。

At first it analyzes the bedding rock slope"s bedded rock and its incontinuity face, and studies the stress, strain, stability"s condition of the bedding rock slope, fully considering the cohesive force of rock layer and incontinuity face.Geologic mechanics models of two types of bedding rock slope are set up, the instability coefficient of bedding rock slope under different mechanical parameters is computed, and the conclusion that the stability of bedding rock slope is relation to rock layerer, cohesive force of incontinuity face, inner friction angle and rock layer obliquity has been gotten.

本文首先对顺层边坡的层状岩体及其中的层理面和不连续面进行了分析，对其应力应变进行了研究，得出了顺层边坡的稳定性不仅与岩体中岩石的强度有关，还与岩体中层理面及不连续面的内聚力、内摩擦角及其倾角有关；论文建立了层理面和节理面的地质力学模型，讨论了其力学参数变化对边坡稳定性的影响，并在此基础上将层理面和节理面归纳为顺层边坡稳定性的结构面影响因素，同时讨论了影响顺层边坡稳定性的其他因素，从而得出顺层边坡稳定性的评价预测指标。

Using maximum flooding surface and local explosure erosion surface as the correlation framework surface in the 4-th hierarchical base-level cycles, sand-body in the 3-th hierarchical base-level cycles formed in the 4-th hierarchical base-level cycles may be correlated layer by layer. The law of the sand-body and the characters of reservoir heterogeneity formed in the 4-th hierarchical base-level cycles are discussed. The study shows:①During early period of the 4-th hierarchical base-level cycle rising, subaqueous distributary channel formed, continuously stacked vertically, and migrated in limit range laterally, and channel sand-body stretches farther longitudinally, and lacks interbeds of mud rock and siltsand in sand rock, reservoir heterogeneity is relatively weak.②During mid-period of the 4-th hierarchical base-level cycle rising, subsaqueous distributary channel migrated actively, channel divided and converged strongly to form netted sand-body and sand sheet mainly, but interbeds of mud rock and siltsand increases gradually in sand-body, reservoir heterogeneity increased.③During later period of the 4-th hierarchical base-level rising and early period of the 4-th hierarchical base-level falling, reservoir sand-body was poor, and only form thin sand-body of subsaqueous distributary channel, subsaqeuous creveas and distal mouth bar, sand-bodys are surrounded by mud and silt rock.

进一步采用以第4层次基准面旋回中相当最大湖泛面的相转换面和具有区域性暴露侵蚀作用的层序边界面为等时地层对比框架的边界，对发育于MSC2—MSC4三个第4层次基准面旋回的第3层次基准面旋回内砂体进行了逐层等时对比，探讨第4层次等时地层对比格架内储集砂体发育分布规律，及储集砂体的非均质性特点，研究发现：①第4层次基准面上升初期发育的水下分流河道，砂体呈连续叠置、侧向迁移受限，纵向上呈长距离延伸的带状产出，砂体间泥、粉砂岩夹层少，储层非均质性相对较弱；②在第4层次基准面上升中期发育的水下分流河道侧向迁移活跃，纵向延伸过程中分流汇合作用强烈，以形成网状或席状连片砂体为主，但砂体间泥、粉砂岩夹层逐渐增多，储层非均质性增强；③第4层次基准面上升晚期和下降早期，不利于储集砂体发育，仅出现少量薄的水下分流河道、水下决口扇、远—河口砂坝砂体。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。