非分布的

Firstly, the equation for stress intensity factors under static uniform pressure is used as the reference case, and then the weight function for a thick-walled cylinder containing a radial edge crack can be worked out. Secondly, the dynamic stresses in uncracked thick-walled cylinders are solved under internal impulsive pressure by using mode shape function method. The solution consists of a quasi-static solution satisfying inhomogeneous boundary conditions and a dynamic solution satisfying homogeneous boundary conditions, and the history and distribution of dynamic stresses in thick-walled cylinders are derived in terms of Fourier–Bessel series. Finally, the dynamic stress intensity factor equations for thick-walled cylinder containing a radial edge crack subjected to internal impulsive pressure are given by dynamic weight function method.

首先采用静态内压下的应力强度因子作为参考解，得到了带径向边裂纹厚壁圆筒的权函数；然后用振型函数方法推导无裂纹厚壁圆筒在冲击内压下的动应力响应，分析中将相应的弹性动力学方程解分为满足非齐次边界条件的准静态解和满足齐次边界条件的动态解的叠加，利用傅立叶-贝塞尔级数展开，推导出了厚壁圆筒内动应力的响应历程和分布规律；最后由动应力权函数方法导出带径向边裂纹厚壁筒在冲击内压下的动态应力强度因子计算公式。

It was found that because of the difference in component distribution and structure, the tendency that pores furcate and bend was smaller in amorphous precursor than in crystalline precursor, and for the amorphous precursor, the velocity of Al leaching-out and the expanding of specific surface area of catalyst were more sensitive to activation process parameters.

结果发现，由于两者在组元的分布及结构上的差异，非晶态前置体合金在活化过程中形成的微孔发生弯折、分叉的倾向要小于晶态前置体合金，同时前者在活化过程中的抽Al速率、以及所得到的催化剂的比表面积等对活化工艺更为敏感。

Theobserved strain is 10~2 times as local point strain at the same observed stress.This indicates that macroscopical symmetrical rock is quasi-brittle materialwith microcosmic heterogeneousness and its macroscopical mechanicalbehavior is the results of reciprocity and magnification between microcosmiccharacteristic, not simple sum.(4) The degree of irregularity of strain increases with the number of cycle.But degree of irregularity of transverse strain fluctuates larger at the samecycle. Moreover degree of irregularity of transverse strain is larger than that ofaxial strain. This shows that deformation and failure of rock is process ofevolvement of small crack. Small crack evolves from even and out-of-orderstatus to heterogeneous and ordinal status.(5) Ultrasonic speed decreases with the number of cycle. The decreasecourse is such: Firstly, ultrasonic speed fluctuates in a steady scope in somecycles; And then ultrasonic speed quickly decreases to a certain more smallvalue; Afterwards in succedent cycles, ultrasonic speed fluctuates about thevalue. That is to say, ultrasonic speed fluctuates and decreases at intervals ofcycles. In deformation process of rock, quantitative change and qualitativechange of its small crack evolvement carry through crosswise.(6) Strength and modulus of rock decrease with exponential function asscale of specimens increases.

同一表观应力下，局部点应变与表观应变相差可达2个数量级，表明宏观上均匀的岩石是具有细观特征的准脆性材料，其宏观力学行为是细观特征相互作用、放大的综合结果，而不是简单的叠加；(4)岩样轴向应变不均匀程度和横向应变不均匀程度随循环次数的增加渐进增大，但是在同一个循环内，横向应变离散系数随应力的变化波动较大，且同一循环级别下，横向应变不均匀程度大于轴向应变不均匀程度，表明岩石内部微裂纹的演化是岩石变形破坏的本质特征，这一演化表现为微裂纹从均匀无序分布逐渐向非均匀有序发展；(5)随循环次数的增加，所有岩样内部超声波速会出现衰减，衰减过程表现为在某几次循环内超声波速在某一相对范围内波动，然后急剧减小到某一较小值，在随后的循环内，超声波速又会保持在这一较小值附近波动，即超声波速表现为波动和急剧减小间隔形式衰减，表明从宏观看来平稳的岩石变形过程，内部结构演化过程(微裂纹发展及其相互作用)却表现为均匀量变和突发质变不断交叉进行的现象；(6)岩石强度和弹性模量随尺度增大呈指数函数规律减小。

A theoretical analysis shows that the non-zonation of ACC in the region of Kerguelen Plateau is due to the changes in potential vorticity of the water column caused by the curl of the ratio of wind stress to topography. The bifurcation and turning of ACC is related to the curl distribution.

理论分析表明，凯尔盖朗海台区ACC的非纬向性主要是由风应力和海底地形的变化造成的，它通过该海台时的南北路径的分叉和转向与该海区风应力与水深之比的旋度的分布相吻合。

The discrete velocity ordinate method in the kinetic theory of gases is developed and applied to discretize the correspo

借助非定常时间分裂法和无波动无自由参数的NND耗散格式，建立直接求解微观分子速度分布函数的有限差分数值格式；研究并发展可用于离散速度坐标点选取和离散速度空间宏观取矩的高斯─埃尔米特无穷积分方法、等均间隔的牛顿─柯斯复合积分法、以勒让德多项式的根为积分结点的高斯─勒让德数值积分法，并应用于不同马赫数绕流模拟；通过对不同流域一维激波管问题、二维圆柱绕流问题和三维球体绕流的计算研究，并将计算结果与其他途径得到的研究结果诸如DSMC模拟值、N-S解及有关实验数据进行比较分析，创建了一套能有效模拟稀薄流到连续流不同流域气体流动问题简化的统一数值算法研究框架

Finally, we present an arithmetic of multiplehypocentral, heterogenous dislocation, and a multirupture segment superposition model for simulating the earthquake deformation field. The simulated LOS interferometry map presents the distribution characteristics of the earthquake deformation field better than that of previous studied. Meanwhile, a suit of fault geometric parameters of the earthquake is also obtained by the study. Having a better effect upon simulating asymmetry, great dislocation, macro rupture field, and nonhomogeneity of dislocation than the traditional model, the multisegment method is a progress of this work. It provides a better explanation for the study on hypocentral parameters.

基于上述原因，本文对Okada线弹性位错模型的算法进行了改进，提出了"多震源、非均一位错分量、多破裂段叠加"的线弹性模型，该模型模拟出的形变场干涉纹图较好地体现了地震形变场的分布特征，并由此获得了一套较为完整的地震发震断层的几何学特征参数，为破裂带长度、破裂面方向、破裂面大小等震源破裂特征参数研究提供了较好的解释。

In chapter5, the serial properties of numerical range of operator polynomial are put firstly. Secondly, the relation between numerical range of operator polynomial and n-numerical range are considered. Thirdly, in the light of matrix norm, matrix singular value, the regions and bounds of numerical range and spectrum of operator polynomial are dicussed carefully.

第五章研究了算子多项式数值域的性质、算子多项式数值域与n-次数值域的关系，特别地利用矩阵范数、矩阵的奇异值、非负矩阵的理论、友矩阵为工具，给出了算子多项式数值域及谱的范围全面刻画，并深刻地研究了算子线性束的正则性的等价条件及谱分布。

Firstly, electrization knowledge related to the research is introduced. After a deep study on various contact loss detection techniques, especially on the electric arcs detection techniques, we draw the conclusion that the untouched detection technique based on phototube sensor can acquire exact contact loss information, and will to be the leading technique for contact loss measurement in future. Secondly, combining with the special railways system in our country, we analyze the cause of the arcs, and the influence on the power supply system and the on board traction drive due to the arcs in detail, and study the arcs' spectrum characteristic. We also analyze detecting principles and put forward with a method - using phototube sensor to detect the contact loss arcs, conceive the configurations and detection flows of the measurement.

文章通过对电气化铁道相关知识的了解及对国内外离线检测技术的深入了解，尤其是对离线电弧检测技术的了解，总结出了基于光电传感器的非接触离线电弧检测系统能够得到准确的弓网离线情况，并且是国内外检测技术的发展方向；文章详细的分析了离线电弧产生的原因，电弧对机车牵引动力的影响情况，研究了我国铁路系统中离线电弧的光谱特征分布；分析了系统的检测原理，提出了采用光电传感器实现对离线电弧进行检测的方法，并设计了"电力机车弓网离线电弧检测装置"的检测功能和管理功能，规划了系统的组成结构及检测流程。

Barrel is the key part of artillery. In shot process, propellent gas of high pressure and high temperature flows in the tube at a high rate of speed, which brings an upheaval to the temperature field of the composite barrel. As to the composite barrel with metal inner, its poor thermal conductivity is more likely to cause uneven temperature distribution and bigger temperature gradient, to produce improper deformation and to make the work temperature of metal inner rise, all of which will affect the life span of barrel.

身管是火炮的关键部件，在火炮发射过程中，高温、高压的火药燃气在身管内成脉冲式高速流动，使身管受到急剧的加热，引起身管壁内的温度急剧变化，而对于带金属内衬复合材料身管，由于复合材料导热性能较差，更容易引起非均匀温度分布以及较大的温度梯度，产生不合适的变形，也会使身管的金属内衬的工作温度升高，从而使得身管的寿命降低，同时身管的发热会引起其刚度的变化，增大射弹散布。

High precision format, unstructured dynamic mesh with a large displacement and multi-species gas flows were computationally expensive, the problem of resourceless and inefficient of single computer appeared. Parallel arithmetic based on PC-Cluster system for the oblique detonation wave flow and the muzzle flow include high speed projectile were discussed. The results proved that the rationality of parallel arithmetic provided a new method to simulate the complex chemical reaction flows. The present code represents a validated, efficient and versatile tool developed for the simulation of hypersonic multi-species chemical non-equilibrium flows.

高精度计算格式、化学反应源项的刚性和大位移的运动边界处理都给计算和存储带来了沉重的负担，单机资源不足和计算时间长的问题凸现，利用PC机和局域网资源建立分布存储式并行计算系统，并基于非结构动网格和分区算法开发了复杂化学反应流场数值模拟的并行计算程序，对高速飞行实验弹丸诱导的斜爆轰波流场和含有大位移动边界的膛口燃气射流场进行了并行模拟，有效地缩短了计算时间，扩展了计算规模，为复杂化学反应流数值模拟研究提供了新的手段。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。