非分布的

Simulation results show that, for the fixed sampling frequency, the error rises with the frequency increasing of periodic signal, and decreases with the attenuation time constant increasing of non-periodic signal. The sampling frequency determines the upper limit of appropriate frequency band directly. The research provides the basis for the selection of cutoff frequency in filter design.

仿真结果表明，在采样频率确定时，对于周期信号，计算误差随频率的增加而增大，而对于非周期信号，计算误差随衰减时间常数的增大而减小，采样频率大小决定了插值法用于分布参数模型的适用频带上限，该研究为滤波器设计中截止频率的选择提供了依据。

However, we found, for nonstationary panels with deterministic trends, the S_N test statistics would be biased and its asymptotic distribution would not be standard normal.

但我们的研究表明，在非平稳综列数据含有确定性趋势时，SN检验是有偏的，不再服从标准正态的渐近分布，而需要进行修正。

Through theoretical and experimental research, the viscoelastic mechanical model of optical fiber coupler in the process of fused biconical taper was established, with which, the numerical analysis under non-uniform temperature field was realized.

基于理论与实验研究，建立了光纤耦合器熔融拉锥过程的粘弹流变力学模型，并给出了光纤耦合器非均匀温度场条件下的流变过程数值分析，获得了拉锥速度、熔融温度等流变工艺参数对器件应力分布与器件性能的影响规律。

The introduced model can simulate both the steady state and the transient temperature field of the top surface of the thermal sensitive layer on a bolometer detector.

本文主要介绍用有限元数值分析的方法对非致冷红外测辐射热计探测器的温度分布进行计算，其有限元模型可以对测辐射热计探测器热敏层表面的稳态和瞬态温度场进行仿真。

The inelastic scattering angular distributions of discrete levels and double differential cross sections were calculated and analyzed by using the distorted wave Born approximation theory ,the unified Hauser-Feshbach model and the exciton model.

应用得到的光学模型势参量，根据光学模型、统一的Hauser-Feshbach和激子模型理论以及扭曲波玻恩近似理论，系统计算和分析了中子与58，60Ni反应的非弹散射角分布和双微分截面，理论结果与实验很好地一致。

First, a non-parametric density estimate method based on kernel function is adopted to estimate the statistic distribution of the SAR images, and then, the SAR images is segmented with Markovian contexture by maximizing a MAP estimator, taking the former estimation as its likelihood term.

该算法首先采用基于核函数的非参数方法估计SAR图像的统计分布，然后将此统计量作为图像分割的似然函数，利用马尔可夫上下文约束进行SAR图像分割。

It is shown that the friction force and bulkhead thrust are the main factors of shield thrust setting, while the friction between the cutterhead and soil is the main factors of cutterhead torque setting. Friction force between shield and soil would make front soil of shield upheave, and subsidence of surface soil is induced by ground loss when the friction force between the cutterhead and soil results in the surface settlement asymmetrical distribution.

通过计算发现，盾构施工中盾壳摩擦和正面推力是盾构推力设置的主要因素，而刀盘与土体摩擦是刀盘扭矩设置的主要因素，盾构前方土体隆起主要由盾壳摩擦引起，刀盘摩擦作用主要引起地表沉降的非对称分布，地表沉降主要由盾尾空隙产生。

The dependence of internal friction on annealing temperature and annealing time is experimentally investigated for amorphouse alloys Pd_(80Si_(20) and Ni_(80)P_(20), the streched exponent function is used to fit the decay law, M= exp.

考虑到非晶态合金（Pd_（80）Si_（20），Ni_（80）P_（20））结构上存在的涨落将导致弛豫激活能谱呈现为一种宽的关联分布，从而修正了传统的激活能模型，并由此得到了4种类型的弛豫函数。

The key to increase accuracy of reservoir description, delimit distribution of residual oil and enhance reservoir development is to know the reservoir heterogeneity.

提高油藏描述的精度、确定剩余油的分布、改善开发效果的关键是认识油藏的非均质性。

The influence of non-uniform flow and particle density distribution on the simulation results was discussed.

分析了流体的非稳态流动及颗粒的密度分布对模拟结果的影响。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。