非乳制的

When the sodium lauryl sulfate and p-octyl polyethylene glycol phenyl ether is used and its level in 3% and 6: 4 ratio, the polymerization process has the lowest coagulum and the highest monomer conversion. Higher reaction temperature and more level hydroxyl value lead to more coagulum, the latter also lead to larger particle size. The acid value has larger influence on viscosity and coagulum, there exist a best range. The emulsion particle size is larger for its hydrophilicity, most of its particles are connected together.

在含较高亲水单体的乳液聚合体系中，难以制得稳定的预乳化液，不能采用工业生产中常用的预乳化工艺，而只能采用混合单体直接滴加的方法；由于单体混合物的亲水亲油值较高，用阴离子型乳化剂十二烷基硫酸钠和非离子型乳化剂聚乙二醇辛基苯基醚混合，用量为单体总量的3％，且比例在6：4时，乳液聚合时具有最低的凝聚物含量和最高的单体转化率；乳液聚合反应温度升高，可以提高单体转化率，增加反应速度，但凝聚率相应提高；随着羟基单体含量的增加，聚合过程中凝聚率增加，聚合物乳胶粒平均直径增加；羧基单体有一个最佳的用量（2.6％），过高或过低凝聚率均提高；羧基含量对乳液的粘度有较大的影响，当羧基含量较低时，羧基含量增加，乳液粘度增加明显；含羟基乳液粒子由于含亲水基团较多，使得乳胶粒径增大，乳胶粒子大多数互相凝聚在一起，处于凝聚态。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。