静态的

I contact bran-new content,first of all I have to comprehend the principles of all procedures and the action of each variable in them,then find out the distinct manners of reserving variables between the flow procedure and the static stability procedures. It is the most difficult to authorize a connective procedure between the two procedures and link and debug the whole procedures.

我接触的是全新的内容，首先必须理解 QR 算法和各程序的原理及各程序中变量的意义，找出潮流程序和静态稳定程序存储变量的异同，编写潮流程序和静态稳定程序之间的接口程序以及连接、调试所有的程序是本毕业设计的难中之最。

In this design, the dimension M of the memory vector field may be not necessarily equal to the dimension N of the network vector field. This may be the usually case in applications. Designing a network with either static or oscillating behavior, after analysing the dynamical. behavior of its four-dimension subspace, we get 2-torus in the subspace. If we vary the ratio of the imagine parts of the complex conjugate eigenvalues, the periodic motion of all kinds of period ratio on 2-torus are obtained.

设计一个既具有静态平衡点又具有动态振荡的网络，其静态平衡点由多余维叉形分叉得到，动态振荡形式由多余维Hopf分叉得到，通过对其中一个具有振荡行为的四维子空间的进一步分析，可以得到网络在四维子空间中的二环面运动，适当调整约当形中共轭复特征根虚部的比值，可以得到各种周期比的二环面上的周期运动。

Firstly, the equation for stress intensity factors under static uniform pressure is used as the reference case, and then the weight function for a thick-walled cylinder containing a radial edge crack can be worked out. Secondly, the dynamic stresses in uncracked thick-walled cylinders are solved under internal impulsive pressure by using mode shape function method. The solution consists of a quasi-static solution satisfying inhomogeneous boundary conditions and a dynamic solution satisfying homogeneous boundary conditions, and the history and distribution of dynamic stresses in thick-walled cylinders are derived in terms of Fourier–Bessel series. Finally, the dynamic stress intensity factor equations for thick-walled cylinder containing a radial edge crack subjected to internal impulsive pressure are given by dynamic weight function method.

首先采用静态内压下的应力强度因子作为参考解，得到了带径向边裂纹厚壁圆筒的权函数；然后用振型函数方法推导无裂纹厚壁圆筒在冲击内压下的动应力响应，分析中将相应的弹性动力学方程解分为满足非齐次边界条件的准静态解和满足齐次边界条件的动态解的叠加，利用傅立叶-贝塞尔级数展开，推导出了厚壁圆筒内动应力的响应历程和分布规律；最后由动应力权函数方法导出带径向边裂纹厚壁筒在冲击内压下的动态应力强度因子计算公式。

The tests have Simulated the rainstorm state and the order state, and the results indicated the disposal of microorganisms-aquatic plant system is efficient. The optimization removal rate time was ascertained under the static state test, in dynamic test, comparing and analyzing the effect on removal rates of different concentration wastewater. The results showed, without aeration, the removal rate of CODCr, TN was 85.9%,75.1%, respectively, the highest removal rate of TP was 64.6%, and the concentration of DO increased steadily from 2mg/L to 7mg/L during experiment. In dynamic test, the microorganisms-aquatic plant systems have also appeared better effect on freshet, and the removal rate of TN,TP and CODCr, was 64%,69% and 81%, respectively.

利用接种高效微生物菌剂促进填料快速挂膜，并和水生植物联合作用去除水体中的氮磷等污染物，在静态水体下研究达到最佳去除效率的时间，并在连续流试验下对比分析不同浓度下的去除效率，根据静态模拟试验结果表明，在不曝气，自然复氧条件下，CODCr和TN的最终去除率分别为84.3%和71.4%，TP最高去除率为62.9%，DO也从2mg/L稳定的升高到7mg/L左右；在连续流模拟试验结果表明，该系统对雨后入湖的河水中TN、TP及CODcr的去除率分别稳定在近64%，69%和81％以上。

In order to investigate the variation of controllability and observability affected by network scheduling,the model of scheduling for Networked Control System is established,which has communication constraint on its input and output channel.Utilizing communication sequence to express the scheduling of channel,the model can be transformed into discrete-time switch system.Under static scheduling,using the theory of recursive invariant subspace and its character,a necessary and sufficient condition of NC...

为了研究网络调度对能控性与能观性的影响，对输入、输出通道都存在通信约束的网络控制系统的调度进行建模；利用通信序列表示通道的调度情况，最终将模型转化为离散切换系统；在静态调度下，利用循环不变子空间理论及其相关的性质，给出了网络控制系统能控性、能观性成立的充要条件，并给出了原有控制系统与经网络静态调度后的系统之间能控性、能观性的关系；最后用仿真实例说明了所提结论的正确性。

In the system of high precision and low speed, Because of the existence of the nonlinear friction, the static and dynamic performance of the servo system is very bad, such as stick slip, hunting, large error and so on, Because the traditional control of PID is hard to solve the nonlinear problem of the servo system, so this paper begins to introduce a new control method which is named adaptive fuzzy PID, It utilizes the rule of the fuzzy control to adjust the parameter of proportion, integral and differential on line, So this control method has some intelligence to improve the static and dynamic performance of the servo system.

在高精度、超低速伺服系统中，由于非线性摩擦环节的存在，使系统的动态及静态性能受到很大程度的影响，主要表现为低速时出现爬行现象，稳态时有较大的静差或出现极限环振荡；由于传统的PID 控制很难解决伺服系统中的非线性问题，因而不能适用于高精度、超低速伺服系统；本文通过引入模糊自适应整定PID控制，利用模糊规则在线调整比例、积分、微分环节，使系统具有一定的智能，从而非常明显的改善伺服系统的静态及动态性能。

The micro actuator's static state characteristic by static electric force is analyzed in detail. The steady balance position's existing condition is educed while the moving pole move with linear displacement, and the relationship between driving voltage and the moving pole's line displacement is presented. The adsorption voltage by which the moving pole is adsorbed to fixed pole is exported. The resolution method of the pole cornual displacement's static state characteristic is opened out.

以应用RP技术制作三自由度电容式微型激励器为例，阐明了这种制造工艺的主要特点，探索了复杂微机械结构制作的新方法；详细分析了所设计微驱动器在静电力作用下的静态特性，推导出了可动极板线位移运动时存在稳定平衡位置的条件及驱动电压与可动极板线位移量之间的关系曲线；给出了可动极板吸合到固定电极上的吸合电压，指出了分析可动极板角位移静态特性的解析方法。

In this paper a new contingency screening and ranking method is formed by combiningiterative filtering screening technology with continuation power flow analysis. Researchingpreventive control policy in reactive power compensation and load control when themargin of stability is serious, and reciprocal math model is given;through the exempleof IEEE39 typical system , the availability of the discussed methods in this dissertationwas approved. Aimed at the real grid, the contingency screening analysis and preventivecontrol policy based on Beijing power grid is discussed;the static voltage stabilityanalysis software based on figure draw of Beijing grid is realized, and the software hasthe junction to BPA .

论文提出了将迭代过滤筛选技术和连续潮流法相结合的事故筛选分析方法；从无功补偿控制和负荷控制两方面研究了系统裕度紧张时的预防控制策略，给出了相应的数学模型；采用IEEE39节点的标准系统算例，验证了本文提出的静态电压稳定事故筛选分析方法的可行性；针对实际电网讨论了基于北京电网的事故筛选分析和预防控制策略；通过与BPA接口实现了基于北京电网图形平台的静态电压稳定分析软件。

Result: In first experiment, the results shows erector spinae of CLBP had positive correlation in the force-sEMG signal relationship on the testing of non-fatigue state of step extensions exercise; AEMG, MPF, IMPF increased with the load, but the Lempel-Ziv Complexity remain firm against the load. The second experiment of the research was that the mean values and the slopes of sEMG of the LBP were significantly different from healthy subjects during the isometric contractions of 20%MVC load intensity, except AEMG.

90秒静态负荷运动过程中，10％MVC运动强度时，慢性下背痛被试和健康被试AEMG、MPF、IMPF、复杂度的均值均没有显著性差异；20％MVC运动强度时，健康被试的MPF、IMPF、复杂度均值都低于LBP被试，对于10％MVC和20％MVC运动负荷强度时，慢性下背痛被试的AEMG、MPF、IMPF、和C的变化斜率都快于健康被试，除AEMG外，其余指标的变化率之间均有显著性差异；在两种负荷强度下的静态运动负荷实验中，左右侧腰部竖脊肌肌电信号特征无明显差别。

The computational model andsimulation method are tested by post-process and visualization of experimentalresults. The application of 2-D Particle Image Velocimetry is also discussed.8 Optimal design of the furnace tube system in an ethylene-cracking furnace isstudied as a practical example. Screw-pitch of the static mixer unit andinstallation layout of tubes with static mixer is discussed.

讨论了先进的二维PIV实验方法应用的可能性。8、以一台典型的工业炉——乙烯裂解炉为例，对静态混合式炉管进行结构优化设计，优化参数涉及元件螺距、安装方式——如安装间距、安装个数、安装方向和相位角等，提出随着静态混合元件的螺距的增大，安装间距也在增大。

Do you know, i need you to come back

你知道吗，我需要你回来

Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.

1〕 杨银书，王祥生，李德昌。安徽省首次发现嗜群血蜱。