静态

I contact bran-new content,first of all I have to comprehend the principles of all procedures and the action of each variable in them,then find out the distinct manners of reserving variables between the flow procedure and the static stability procedures. It is the most difficult to authorize a connective procedure between the two procedures and link and debug the whole procedures.

我接触的是全新的内容，首先必须理解 QR 算法和各程序的原理及各程序中变量的意义，找出潮流程序和静态稳定程序存储变量的异同，编写潮流程序和静态稳定程序之间的接口程序以及连接、调试所有的程序是本毕业设计的难中之最。

It includes established quality system, quality disaccord and improvement method. According to its different usage, the quality knowledge is divided into two parts. The static quality knowledge is composed of established quality systems. The dynamic quality knowledge includes quality disaccords and improvement methods, which is directly used to implement the improvement process and generated from the static quality knowledge. And it will act on static quality knowledge.

根据质量改进过程中知识的作用，本文将已建立的组织质量体系作为静态质量知识，将质量问题及其改进方法，即质量改进知识作为动态质量知识，动态质量知识是直接实现改进的知识，它依据静态质量知识生成，并且能够反作用于静态质量知识。

The process was introduced. The Static and Dynamic performances were simulated. Through this process the Static and Dynamic curves were graphed. At the same time, the differences between the model and the CNG-engine Higher Depressed Valve were analyzed in the Static and Dynamic performances.

对该模型的建立过程进行了详细的阐述，并且进行了静态和动态仿真，通过仿真得到了静态特性曲线和动态特性曲线，同时通过对这些曲线的分析，阐释了模型与实际天然气高压减压阀在静态和动态特性上的差异。

Steady-state harmonics and transient performance of the conventional static synchronous compensator controllers are first investigated. Based on the sensitivity analysis of the STATCOM output power, it is found that the voltage magnitude is more effective than the phase angle in controlling the reactive power output. An analytical approach to harmonic analysis of a STATCOM based on Bessel functions of the first kind is described.

本博士论文首先分析传统静态同步补偿器(Static Synchronous Compensator， STATCOM)控制器的优缺点，利用对静态同步补偿器输出功率的灵敏度分析，得知要控制补偿器输出虚功大小时，直接对静态同步补偿器输出电压大小作控制，会比对相角作控制来得有效。

In this research we increased the backsights from 3 to 10 points.and observed 5 sets of VRS,1 set of static GPS,5 sets of 3D LASER. we considered the Static GPS as the standard observation set,and compared it with the VRS's coordinates after adjustment.The RMS and the range of differences are taken as the indicator of accuracy .

一般而言，3D LASER作业只须三个已知点即可定得绝对坐标，为了增加多余观测量，本研究将3个后视点增加为10个后视点，针对这10个后视点分别施测5组VRS、1组静态GPS、及5组3D LASER，文中以静态GPS为对照组，以改正前后之VRS坐标与静态GPS坐标较差之RMS及分布范围为精度分析之指标。

The study and comprehensive analysis of static high-pressure quenching experiments and laboratory dynamic high-pressure experiments on chondrites,as well as the study of shock-induced phase transition of minerals in the Suizhou meteorite revealed that the P-T conditions for phase transition of minerals during natural impact events,such as collision of cosmic bodies or impact of meteorites on the Earth′s surface,are not consistent with those obtained by shock experiments on chondrites or rocks in laboratory,...

通过对球粒陨石的静态高压淬火实验和人工动态高压实验的研究和综合分析，以及对在太空中经受过撞击的随州陨石中矿物发生高压相变的研究，查明了自然界的冲击事件，如星体的相互碰撞和陨石对地球表面的撞击中，矿物发生相变的P-T条件与人工冲击波实验的结果并不一致，而与静态高压淬火实验的结果相似，即前者类似静态高压淬火实验，保压时间较长，能产生高压矿物，后者保压时间极短，无高压矿物形成。

There are two methods to study the fitting of the interest rate term structure currently, which are the dynamic method and the static one. The static method is to fit the term structure at a point in time using the market information at that time according to a particular standard, and the dynamic one is to describe, based on the result of the static fitting, the change of the term structure using the random process.

目前利率期限结构的研究角度主要有动态和静态两类：静态是根据某个时点的市场信息按特定的标准对该时点的利率期限结构进行拟合；而动态则是在静态拟合的基础上，使用随机过程对利率期限结构的变化过程进行描述。

Experiments were carried out to verify the static model. Experimental results show that the experimental curve matched well with the simulated curve, and there was certain error between them (maximal static error is 0.035 rad). The error cause was analyzed. Then the experiments were carried out to measure the dynamic performances of the side-sway joint. Experimental results show that the step response time of the joint was about 2 s steady value's tolerance zone ?

完成了侧摆关节静态特性试验，试验结果与仿真曲线基本吻合，验证了静态模型的正确性，但存在一定误差（最大静态误差为0.035 rad），分析了误差原因；对侧摆关节进行了动态特性试验，试验结果表明对于不同的期望值角度阶跃信号，侧摆关节开环阶跃响应时间大约是2 s

The critical shear angle of quasi-static state was given under different loading speeds and frame lengths condition, and the influence of specimen size on this shear angle range is also discussed.

在此基础上，提出了在特定的剪切范围内，可以将画框的运动看作是准静态过程进行处理的思想；得出了在不同拉伸速度和边框长度条件下装置处于准静态时的临界剪切角，并且分析了织物试样尺寸大小对准静态范围的影响。

The corresponding relations between the strain of the static state and dynamic cycle load and the volume resistance of the short chopped carbon fibers, short chopped carbon mat, unidirectional carbon fibers reinforced vinyl resin composites is existed. The physical modes of these kinds of composites are also designed based on the experiment data. The resistance and strain of the short chopped fibers reinforced vinyl composites satisfy the equation of y =A + Bx + Cx~2 in the static strain test method and the short chopped mat reinforced vinyl composites is y = A + Bx.

短切碳纤维、短切碳纤维毡、单向碳纤维增强乙烯基酯树脂复合材料在静态和动态循环载荷下，应变与电阻之间有较好的对应性，同时根据实验数据，建立了不同条件下该复合材料应变和电阻变化规律的物理模型，短切碳纤维增强乙烯基酯树脂复合材料在静态拉伸时电阻与应变之间满足：y=A+Bχ+Cχ~2；碳纤维毡增强乙烯基酯树脂复合材料在静态拉伸破坏时电阻与应变之间满足：y=A+Bχ。

I didn't watch TV last night, because it .

昨晚我没有看电视，因为电视机坏了。

Since this year, in a lot of villages of Beijing, TV of elevator liquid crystal was removed.

今年以来，在北京的很多小区里，电梯液晶电视被撤了下来。