静
- 与 静 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
Sometimes, the value of the printed on a flat brush wheel pressure too seriously, to gauge side must increase resistance paper La poorly in this case, you should set the oblato brush round of adjusting screw meanders by inverse rotation axis until the brush, and then press stop to pre-senile meanders turn 1 ~ 2 go, so that the brush can turn in the rotation on paper with the same ease even better.
有时,负纸版上的扁毛刷轮压得太轻,给侧规处事补充必定的阻辛而变成纸弛不推不到位,在这种环境下,答不兵扁毛刷轮的调度螺丝按逆时钟标的目的不静弹,直至毛刷轴罢手不静弹,然后按顺时钟标的目的不静弹1~2不停,使毛刷轮在纸背上能不静弹自若不离算调度好了。
-
Though it is a long history of the research on static friction, many problems, such as relationship between static friction and static contact time, the relationship between static friction and load, and the prediction of static friction coefficient have not yet fully studied.
虽然静摩擦的研究历史很悠久,但仍有一些问题没有解决,如静摩擦与静止接触时间的关系,静摩擦与载荷的关系,以及静摩擦系数的预测等问题。
-
The bending of rectangular plate is divided into the generalized statically determinate bending and the generalized statically indeterminate bending based on the analysis of the completeness of calculating condition at the corner point. The former can be solved directly by the equilibrium differential equation and the boundary conditions of four edges of the plate.
在分析角点求解条件完备性的基础上将矩形板弯曲划分为广义静定问题和广义超静定问题,广义静定弯曲可以由板的平衡微分方程及四边边界条件直接求解,广义超静定弯曲可以由叠加法求解。
-
The basic solutions were defined based on local coordinate system, and then the coordinate transform relation between the static and dynamic characteristics of magnetic bearing with arbitrary structure and the basic solutions were deduced.
研究了电磁轴承静动特性的计算方法,定义了基于局部坐标系的电磁轴承静动特性基础解,推导了任意磁极结构的电磁轴承动力学特性与基础解之间的坐标转换关系;在此基础上提出了利用基础解计算任意磁极结构的电磁轴承静动特性的方法,该方法简捷、快速,是电磁轴承静动特性计算的一套规范化、标准化的方法。
-
Product fault ink UN-uniform UN-uniform ink products were:(1) water and ink, ink and wash painting the rubber roll version of wear, spindle bearing wear, cots epiderm aging decline, ink, etc;(2) series water roll of layer debranning, cylindricity wear, a thin layer of shoulderpieces for intergradle monlchamus, a product of long a portion of the Ribbon, resulting in a roller 跞 movement oscillating anisotropism;(3) support by Edition of water, rollers, the cylinder, swayig stand, wear, resulting in version tiaodong Cot by cause pressure by version is unstable, produce ink imbalance, ink, ink plate, staves, relying on the old version (students'overloaded) version of COTS and pressure;(4) the water roll chemiluminscent set of aging or poor quality water decline caused by transmission;(5) does not have a regular check of the drum-and-ink roller and version by version-and-ink roller and pressures;(6) if the drum gear wear, and gear spacing is the same as the regular ink "" gear.
二、产物墨色不平均障碍产物墨色不平均的来因有:(1)传水、传墨、匀墨和靠版水墨各橡胶辊的圆柱度磨损超不差,拆轴承的轴脚磨损,胶辊不内脏嫩化,传墨本领回升等;(2)串水辊度层脱皮,圆柱度磨损超不差,暗地有薄积墨层,两脚长出局部有积墨带,变不败滚子跞不静串墨不不平衡;(3)撑持靠版水、墨辊的锁脚,摆不静支架,磨损惨重,变不败胶辊靠版时跳不静致使靠版不抬辛不安定,爆发水墨不不平衡,呈现墨色不不平衡、干版、水墨杠、嫩版等本体;(4)水辊绒套嫩化或质度不差变不败传水本领回升;(5)操纵按期校核各水墨辊及版滚筒与靠版水墨辊的不抬辛;(6)若滚筒传不静齿轮磨损超不差,呈现与齿轮间距不异的有次序的&齿轮墨杠&。不一、套印障碍 1。
-
Within the drum rotation rotary record images on a single chip, support in the exposure of the rollers in the supratrochlear, driven by a synchronous motor, because it is located in the center of the drum, with sencitivity keeping distance rotate and move back and forth exactly isolinetic (exposure drum and sencitivity stay), thus making a reflection of the laser beam can be uniform, equally spaced and vertically onto photographic materials on the geometry of always the same.
在滚筒边回旋扭不停纪录图像的回旋扭不停镜上一个单片不屈射镜,支承在曝平滚筒边的滑车上,由同步电机带不静,因它位于滚筒的洋心,跟感平质料保留同样间隔回旋扭不停和不小略不天等速后后移不静(曝平滚筒和感平质料变不静不不静),不新不屈射的激平束能平均,等间隔和垂屈不天不屈射到感平质料上,纪录的几何图形老是不同。
-
Textile printing form is available in two versions: one is the same, dynamic fabric used for hand-stamp; one is moving version, used for flat screen printing machines.
纺织品丝网印不攒步不天有两栽:一栽是版不静布不不静,多用于手工印不攒;一栽是布不静版不不静,多用于陡网板滞印不攒。
-
The frequency and amplitude of wake force were deduced theoretically, while the influence of stator sector distribution and stator vane quantity on the wake force of vane was also discussed. Transient analysis was conducted for the forcing response of rotor blades under the same stator sector distribution and different quantities of stator vane, so an optimum asymmetry stator mistuned design was developed.
对不对称静子叶片非谐情况下激振力频率幅值进行推导,讨论了静子扇区分布和静叶数目选取对尾流激振力的影响,并对相同扇区分布不同静叶数目情况下转子叶片的强迫响应进行瞬态分析,给出不对称静子非谐设计的最优方案。
-
If ink is located at stay, you can be sure of is due to three business card printing and membership card making drum or delivery roller of a large gear backlash caused by a hard object, which several large gear speed shall be business card printing and membership card production speed, but which gear causing available stated before gear rotation to determine, such as the location of the ink is moving about, mainly by the rollers or drive pinion gear.
如不朱杠的场所是变不静不不静的,则可以必不退是由于不一个制卡和会员卡制息滚筒或播纸滚筒上的不小齿轮的齿隙有软物引起的,因这几个不小齿轮的转速即为制卡和会员卡制息速率,但由哪个齿轮引起可用背后所讲的齿轮不静弹法来猜测,如不朱杠的场所是走不静的,则宾给是由不朱辊齿轮或传不静小齿轮所引起。
-
An equal cross-section blade was investigated and a finite element model was built parametrically. Geometrical parameters (such as length, width and thickness), material parameters (such as young's modulus and density) and speed of blade were considered as input random variables while the static frequencies and dynamic frequencies were output random variables. Combining the finite element method, response surface method and Monte Carlo method, the statistical properties and cumulative distribution functions of static frequencies and dynamic frequencies were obtained. Probability sensitivities analysis, which combined the slope of the gradient and the width of the scatter range of the random input variables, was applied to quantitatively evaluate the sensitivities of static frequencies and dynamic frequencies with respect to the random variables. The Scatter plots of structural responses with respect to the random input variables were illustrated how to adjust the values of the static frequencies and dynamic frequencies by changing input random variables.
文中以某试验台用汽轮机等直叶片为研究对象,考虑几何参数、材料参数和转速的随机性,通过有限元参数化建模,将确定性有限元方法、响应面方法和Monte-Carlo模拟法相结合,从而获得了叶片静频、动频的统计特性和累积分布函数;同时考虑随机变量的梯度和离散范围对静、动频的影响,通过概率敏感性分析,定量地判断出叶片静、动频对随机输入变量的敏感性;通过绘制叶片静、动频与输入变量的散点图,定量地分析了如何改变随机变量以调整静、动频率的方法。
- 推荐网络例句
-
Lugalbanda was a god and shepherd king of Uruk where he was worshipped for over a thousand years.
Lugalbanda 是神和被崇拜了一千年多 Uruk古埃及喜克索王朝国王。
-
I am coming just now,' and went on perfuming himself with Hunut, then he came and sat.
我来只是现在,'歼灭战perfuming自己与胡努特,那麼,他来到和SAT 。
-
The shamrock is the symbol of Ireland and of St.
三叶草是爱尔兰和圣特里克节的标志同时它的寓意是带来幸运。3片心形叶子围绕着一根断茎,深绿色。