零位置

The distribution of induced current and the acoustic pressure inside the spheres with different conductivity were presented.

仿真结果表明，感应电流密度在中心位置处为零，在电导率边界处变化较大；声压分布在中心位置处为零，在边界处变化较大。

Based on the traits of dyadic wavelet decomposition of signal and that of the distribution of wavelet image coefficients, PLVQ and ZR are conjoined by making use of D\-4 lattice. Firstly, Pyramidal lattice vector quantization is adopted to quantize wavelet image coefficients. Nonzero lattice vectors and zero lattice vectors are formed. Secondly, nonzero lattice vectors are dealt with by adopting complex entropy coding. Finally, in order to fix on the position of nonzero lattice vector effectively, that is, to deal with zero lattice vectors effectively, the concept of significant map is introduced into. The significant map is scanned two times from down to up and from up to down.

根据信号的二进小波分解特点和小波图象系数的分布特点，利用D\-4格将PLVQ和零树结合起来，提出了一种基于零树和金字塔格型矢量量化的小波图象编码方法，该方法首先采用金字塔格型矢量方法来量化小波图象系数，以得到非零格点和零格点；然后采用复合熵编码来处理非零格点；最后为了有效确定非零格点的位置，也就是为了有效地处理零格点，又引进了重要图的概念。

In general, the dipole components are located at the zero potential plane, called null plane. However, for 3D topographic mapping, many zero potential points can be detected. Instead of testing all the possible points, the proposed approach is to fit the selected zero potentials in terms of a linear plane, i.e. null plane, via least square approach.

一般来说，电偶极的位置都在零电位面上，为了取得零电位面，本研究在三度空间拓朴图映射中找出多点零电位点，然后采用最小平方法，找出一个线性平面通过这些零电位点当做零电位面。

A pointer to the tensility table in the zero position.

将张力表的指针在零位置上。

This paper presents a non-watermarking algorithm based on the most significant bits to construct the key. Firstly, the binary watermarking image is scrambled and extended to the size of the main image. Then the value of every pixel of the watermarking image is compared with that of the corresponding MSB of the main image. When the compared value is true, the location of the main image is marked by a zero matrix, and the marked zero matrix is a key that can be used to detect the watermarking image later.

本文提出一种基于最高有效位构造密钥的零水印算法，先将二值水印图像置乱并拓展为载体图像的大小，再将其像素值与载体像素的MSB进行对应比较，当比较结果为真时，用一个零矩阵来标记载体像素的位置，被标记过的零矩阵作为密钥来检测水印。

This paper presents a nonwatermarking algorithm based on the most significant bits to construct the key. Firstly, the binary watermarking image is scrambled and extended to the size of the main image.Then the value of every pixel of the watermarking image is compared with that of the corresponding MSB of the main image. When the compared value is true,the location of the main image is marked by a zero matrix, and the marked zero matrix is a key that can be used to detect the watermarking image later.

本文提出一种基于最高有效位构造密钥的零水印算法，先将二值水印图像置乱并拓展为载体图像的大小，再将其像素值与载体像素的MSB进行对应比较，当比较结果为真时，用一个零矩阵来标记载体像素的位置，被标记过的零矩阵作为密钥来检测水印。

But for the first packet data do Convolutional Interleaver These zero position is indeed the last automatic zero.

但针对第一包数据做卷积交织时，这些零位置上最后确实自动补零。

This paper presents several control methods for BLDC motor, and describes their fundamental principles ,advantages and disadvantages in brief. The method of speed-independent function,based on a new flux linkage function,is explained in detail. This method makes it possible to detect the rotor position over a wide speed range from near zero to high speed.

本文介绍了几种无位置传感器无刷直流电动机的转子位置检测方法，并对它们的基本原理，优缺点作了简单的说明，详细地阐述了基于一种新磁链函数之上的与速度无关的位置函数控制方法，利用这种方法从零转速到高转速的宽速度范围内能检测到转子位置。

Three Alexander Dennis Super Pointer Dart decorated with special livery were entered service in Jun 07 for the opening of the Airport route NR334. These Super Pointer Darts featured with luggage-rack installed but not provide any space for wheelchairs. The capacity is 33 seats and 33 standees while the Dennis Super Pointer Dart is 39 seats and 25 standees. The oil-tank inlet was relocated at the rear of the left.

为配合往返机场路线NR334开办，珀丽湾客运於二零零七年引进多三架以亚历山大丹尼士为品牌的Super Pointer Dart，车身披有独特的涂装，而且装上大型行李架，但没有提供摆放轮椅位置，载客量亦由先前八架Super Pointer Dart的39人座位加25人企位，变成33人座位及33人企位，另外，入油位置亦改为於左边车尾。

Hence, the kinetic energy of the system is zero when its potential energy has its maximum value (choose the static equilibrium position of the system as the zero point of potential energy).

当振体运动到距静平衡位置最远时，速度为零，即系统动能等于零，势能达到最大值（取系统的静平衡位置为零势能点）。

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。