零件

JDS-1 Interferometer is applicable for measurement of 3-4 grade gauge blocks or precision sizes up to 150 mm by high-precision comparison with a higher grade of gauge block or a standard reference component.

本仪器是一种采用量块或标准零件借以高精度的比较方式的立式精密长度计量仪器。

Besides this, we have studied the special function and significance of impulse vibration signal in the gear case's malfunction diagnose.

承、齿轮、轴系三类零件各自的故障特征信号，同时研究冲击振动信号在齿轮箱故障诊断中的特殊作用和意义。

In this paper, the optimum technique and reliability design are connected together to bring up the method of reliability and optimization design of the gear change mechanism.

本文将现代设计方法中的优化技术与可靠性设计理论相结合，提出了钻机关键零件的可靠性优化设计方法。

The main parts of gear pump is the pump body, cover and gear.

齿轮油泵的主要零件是泵体、泵盖和齿轮。

The P/M gear wheel with special shape is an important structure part in transmission mechanism.

粉末冶金异形齿轮是代步车传动机构中的一个重要结构零件，本文论述了其结构和性能特点、材料选择、生产工艺及模具设计等。

Therefore there must be gearing in the ratio of 3:1 between these parts.

因此，必须面向在该比例为3：1之间的这些零件。

This thesis is combined with the project－"design and exploitation of Automotive Constant Drive-Shaft", which is undertaken by the topic team. Based on the structural simplification to three-dimension solid models of ball-cage type and three column-shaft type constant velocity joint, and the three-dimension solid models are obtained by conversion engineering. Altair/Hpermesh software is used here for generating the finite element mesh of key parts of ball-cage type and three column-shaft type constant velocity joint.

本文结合课题组承担的"汽车等速驱动轴设计开发"项目，在对通过逆向工程方法获得的等速驱动轴的球笼式等速万向节和三枢轴式等速万向节三维实体模型进行结构简化的基础上，利用Altair/Hypermesh软件对球笼式和三枢轴式等速万向节的各关键零件进行了有限元网格划分。

The processing system could solve the problem, which in the processing of WEDM for straight generatrix surface, and this method gets a wild application in the mould manufacture.

此系统可以解决某些复杂空间直纹曲面的加工问题，在模具及异形零件制造中可望得到良好应用。

In order to filter the data sampled from inner-contour generatrix of pipe figure measured by laser, a new effective weighted average recursive filter based on energy difference is proposed.

对基于激光测量的管形零件内轮廓母线采样数据进行滤波。提出了基于能量差的加权均值递归滤波算法。

The presented scheme can effectively solve the problem of generatrix straightness measurement for deep holes.

该方法应用简单、成本较低且具有一定精度，能有效解决工程实际中深孔类零件母线直线度的测量难题。

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。