阻尼的

In this paper, we introduced very much and compared elasticity damper and viscous clamper more according to the wildly use in structure control at present. The result is that viscous damper be recommended.

对目前减振控制中应用较为广泛的粘弹性阻尼器和粘滞型阻尼器进行了重点介绍和对比，在自编程序中设置了粘滞型阻尼器单元的力学模型，可以模拟不同阻尼系数的粘滞型阻尼器，并导出了不可压缩流体的计算公式及给出了适用于结构流固耦合分析过程的近似算法。

Based on description method of damping motion in mechanical vibration, variables movement of generator are divided into two basic motion models: damping oscillation and critical damping motion. Detail methods of extracting damping parameters from simulation data is introduced to establish variable motion models. An approximate method is put forward to simulate low-frequency signal and generator response characteristic, from which motion models and damping parameters of main variables are obtained. The influences of oscillation amplitude, frequency and initial operating point of power system to the motion damping parameters are analyzed.

借鉴机械振动中阻尼运动的描述方法，将低频振荡下发电机主要变量的运动归纳为阻尼振荡和临界阻尼两种基本运动形态；介绍了从仿真数据提取阻尼参数建立参数运动模型的方法，实现对发电机振荡特性的量化分析；提出一种系统侧低频振荡信号的近似模拟方法，并应用于发电机响应仿真，获得了主要变量的运动模型和阻尼参数；分析了系统侧振荡幅度、频率以及初始工况对发电机功角振荡的影响。

The excitation displacement and damping force were measured and the equivalent damping was evaluated from the experimental results.

试验采用频率为4 Hz、振幅为1 mm的正弦波，通过所记录的阻尼器位移和阻尼力时程来评价阻尼器的等效阻尼及其变化，并对阻尼器的刚度影响进行了定量分析。

It is indicated that the damping of the alloy is induced by phase interface slipping or grain boundary viscous sliding, the infinitesimal plastic deformation which is caused by the difference of elastic modules and heat expansion coefficients between phases of the alloy.

结果表明： ZA27-4%Si合金阻尼随频率增大而减小，随温度升高而增大，阻尼不随应变振幅的变化而变化； ZA27-4%Si合金室温阻尼为5.83×10-3，与ZA27合金阻尼相当； ZA27-4%Si合金的阻尼是由合金内部的晶界和相界面滑动、位错振动以及各相的热膨胀系数和弹性模量间差造成的微塑性变形共同造成的。

As the Coulomb friction of the damper is increased, the vibration amplitude of the rotor system is decreased near the undamped critical speeds, but is increased in a range between the first and the second undamped critical speeds.

随着磁流变液阻尼器的库仑阻尼力的增大，支承在磁流变液阻尼器上的转子系统在无阻尼临界转速处振幅明显下降，但在两阶无阻尼临界转速之间的一定转速区振幅反而增加。

Classing by function:normal ball bearing slide ,self closing runner (self close runner,self-closing ball bearing slider,auto close drawer slide),soft close runner(soft-closing ball bearing slide,drawer slides rails damped by air,drawer slides rails damped by oil,moving action slow down slide),concealed drawer runner(undermount slide,hidden drawer slide),concealed self close drawer runner, concealed soft close drawer runner, one -tuch auto opening concealed drawer slide,basket ball bearing slide,drawer runner,Touch Release Runners,TIP-ON runner/slide,Concealed Undermount Drawer Slides.

按功能分类：普通钢珠滑轨，自关滑轨，自关缓冲滑轨，液压缓冲阻尼滑轨，气压缓冲阻尼滑轨，自关阻尼滑轨，，隐藏式普通滑轨，隐藏可调节滑轨，隐藏自动回拉滑轨（或隐藏自动回位滑轨，隐藏阻尼滑轨），隐藏自动弹出式滑轨，反弹式滑轨，双层小板抽拉篮滑轨(Double-layer pull out rack runner)，可调式挂钩滑轨，全抽式米箱滑轨--科学直观的分类

First, the angular velocity function and maneuver load for certain maneuver flight (including hover, dive-hike and these two combined) are set up. The simulation results of the vibration of double-disk rotor system with cantilever supported on rigid bearings show that rotor would be apparently deformed under maneuver load. Second, the performance of oil force of SFD in maneuver flight is analyzed. The results show that in maneuver flight, the SFD with centering spring will become eccentric and its oil force will be time-related and offset-related.

首先，建立了水平盘旋、俯冲拉起及盘旋+俯冲拉起复合机动三种机动飞行条件下的机动角速度函数，并确定了对应机动飞行条件下的机动附加载荷（附加离心力和附加陀螺力矩），分析了带刚支的双盘悬臂转子系统在机动飞行条件下的振动特性，发现发动机转子在机动飞行时会发生明显变形；随后，分析了非定心挤压油膜阻尼器的油膜力特性，机动飞行时，油膜轴颈在机动附加载荷的作用下偏离外环中心，使得带定心弹支的挤压油膜阻尼器也变成了非定心挤压油膜阻尼器，其非定心挤压油膜力是瞬态时变的，并且与SFD油膜轴颈偏移量和进动形态有关；然后，在经典的Jeffcott转子系统中引入带定心弹支的挤压油膜阻尼器，分析了机动飞行时非线性转子系统的振动特性，发现挤压油膜阻尼器油膜力的非协调特性也反映到转子系统的振动响应中；之后，对机动飞行条件下带挤压油膜阻尼器的双盘悬臂转子系统的振动特性进行了分析，并重点分析、总结了俯冲拉起机动飞行时，系统结构参数和工作状态参数（转速比、机动飞行半径、机动角速度等）对该系统振动特性的影响。

First, the angular velocity function and maneuver load for certain maneuver flight (including hover, dive-hike and these two combined) are set up. The simulation results of the vibration of double-disk rotor system with cantilever supported on rigid bearings show that rotor would be apparently deformed under maneuver load. Second, the performance of oil force of SFD in maneuver flight is analyzed. The results show that in maneuver flight, the SFD with centering spring will become eccentric and its oil force will be time-related and offset-related. Then, SFDs are introduced into typical Jeffcott rotor system. The whole system will be statically displaced in maneuver flight and the nonsynchronous components of oil force appear in the response of rotor system.

首先，建立了水平盘旋、俯冲拉起及盘旋+俯冲拉起复合机动三种机动飞行条件下的机动角速度函数，并确定了对应机动飞行条件下的机动附加载荷(附加离心力和附加陀螺力矩)，分析了带刚支的双盘悬臂转子系统在机动飞行条件下的振动特性，发现发动机转子在机动飞行时会发生明显变形；随后，分析了非定心挤压油膜阻尼器的油膜力特性，机动飞行时，油膜轴颈在机动附加载荷的作用下偏离外环中心，使得带定心弹支的挤压油膜阻尼器也变成了非定心挤压油膜阻尼器，其非定心挤压油膜力是瞬态时变的，并且与SFD油膜轴颈偏移量和进动形态有关；然后，在经典的Jeffcott转子系统中引入带定心弹支的挤压油膜阻尼器，分析了机动飞行时非线性转子系统的振动特性，发现挤压油膜阻尼器油膜力的非协调特性也反映到转子系统的振动响应中；之后，对机动飞行条件下带挤压油膜阻尼器的双盘悬臂转子系统的振动特性进行了分析，并重点分析、总结了俯冲拉起机动飞行时，系统结构参数和工作状态参数(转速比、机动飞行半径、机动角速度等)对该系统振动特性的影响。

The simulation results of the cylinder-block model were given in the article, consistent with that of Middlemen"s. It was shown that the block part could improve the uniformity of the flow distribution. The analysis of the flow field of some materials with different power-law factor in the die designed by Mckelvey was close to that of Mckelvey"s. It was shown that the flow distribution was uniform in the die that can producesheets with 1200mm in width. During the analysis the flow channel was divided into several parts to get the details about the fluid flow in each area. A conclusion was drawn after analyzing the influence of the die pressure on the flow distribution, that the higher pressure is good for the output and bad for the uniformity of the distribution. Simulation of the die applying the cylindrical main runner showed the fact that when the cylinder replaced the cone the change of uniformity was trivial. The uniformity of the non-block flow channel was so poor that the block in the proper position of the die channel was necessary. The project of the die for the wider sheet was put forth, and the analysis of the fluid flow in the die was shown.

本文模拟了圆柱管缝隙流模型的三维流动场，得到了与Middlemen结论一致的流动均匀性，并通过模拟直观地展示了采用阻尼块可以改善挤出均匀性的现象；分析了多种幂率指数的流体在Mckelvey等人设计的流道模型中的流动分布，得到了与Mckelvey的分析结果接近的压力降和流量偏差；本文建立了1200mm幅宽机头流道的三维有限元模型，并逐个分析各个区域和多个截面的流动分布状况，由此揭示了1200mm幅宽L-型机头流道内的流北京化工大学硕士学位论文动分布基本均匀，并在分析了机头压力对于挤出流动分布的影响后得出结论：较高的机头压力可以获得较大的产量，但是不利于物料均匀分布；模拟了采用圆柱管主流道时机头流道内的流动分布，得出结论：主流道由圆锥管改为圆柱管时对流动均匀性影响不大，通过设置适当的阻尼仍然可以达到挤出平衡；模拟了两端进料式圆柱管无阻尼流道的流动均匀性后得到结论：两端进料式无阻尼结构的流动均匀性较差，宽机头中仍然有必要设置阻尼块；确定宽幅机头流道的基本方案，并设计了一种宽幅防水卷材挤出机头流道的结构，通过流动模拟表明该种结构的流动均匀性较好；考察了宽幅机头对于不同厚度片材的挤出适应性，得到结论：当生产不同厚度的片材时，阻尼块高度需要调整。

There are two kinds of damping layers disposition. One is damping layer on beam that is free damping layer. The other is on neural axis of beam that is constrained damping layer.

阻尼层配置方式有两种，第一种阻尼配置位於梁表面为贴覆黏滞阻尼层，另一种位於梁的中性轴为夹芯黏滞阻尼层。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。