阳极氧化
- 与 阳极氧化 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
Current density, anolyte acid and concentration of SO42 in anolyte are notable factors influencing the current efficiency, oxidation rate and cell potential.
通过均匀设计的电解条件试验得出:电流密度、阳极液酸度和阳极液硫酸根浓度为影响电流效率、氧化率和槽电压的显著因素。
-
The traditional process of Cu and As separation employs an insoluble anode. When arsenic acid is reduced in the cathode,simultaneously arsenious acid is oxidized in the anode.
得知:在采用不溶性阳极电积脱铜脱砷传统工艺流程中,砷酸在阴极发生还原反应形成亚砷酸,亚砷酸又与阳极产生的氧气发生氧化反应形成砷酸。
-
The electrolytic oxidation of Cr 3+ to Cr 2O 2- 7 with lead dioxide anode is studied.
应用整体电解法,以二氧化铅为阳极,铜为阴极,对重铬酸钾间接电化学氧化蒽制蒽醌中影响Cr3 +电化学氧化过程电流效率的因素进行了探讨。
-
In this process, the discharge process of single point to point contact is transformed to the process of both point to point contact and the overall surrounding contact of sphere Ni through the self redox reaction, thus making a highly efficient electron transfer process. In this dissertation, the catalytic electrolysis mechanism is discussed. The influence of various parameters (e.g. kind and concentration of catalyst, reaction temperature and electrolysis duration) on electrolysis were investigated.
本文首次提出了以KMnO_4为代表的高锰酸盐作为电解过程电子传递的媒介,通过锰盐自身氧化还原反应的参与,在阳极和溶液中的球形Ni_2之间建立起高效的电子转移过程,使球形Ni_2和阳极之间单一的固体之间的点点接触放电,转变为点点接触放电和球镍与溶液全方位包围接触放电过程,大大提高了电解过程的效率。
-
The main factor affecting the frequency characteristic were given as the following:the coefficient of corrosion of the Al foil surfaces the figure of the hole of scorrosion,and the character of the oxide film on the surface of the anode and cathode;the fabric of the unimpregnated liner in the capacitor,as well as the resistance and steeping of the working electrolyte and the construction of the capacitor.
影响频率特性的主要因素有:阴极和阳极铝箔表面腐蚀系数的大小及腐蚀坑洞的形状;阴极和阳极铝箔表面氧化膜的性质;电容器中衬垫纸的构造;工作电解液的电阻和浸渍情况以及电容器的内外结构尺寸等。
-
The invention relates to an electrochemical method for preparing ultra-fine tantalum powder, wherein it uses the mixture slat flux with CaCl2 or CaCl2 as electrolyte; composites Ta2O5 powder/block with metal collector as solid cathode; uses graphite or inertia anode as anode; uses reference polar to control the electrolysis level, under inertia gas to electrolyze at 500-1000Deg. C; and the electrolysis time should make electrolysis electricity reach needed amount; reduces Ta2O5 into ultra-fine metal tantalum powder.
本发明涉及一种超细钽粉的电化学制备方法,以CaCl2或者含有CaCl2的混盐熔体为电解质,将Ta2O5粉末或块与金属集流体复合作为固态阴极,以石墨或惰性阳极作为阳极,用参比电极控制电解电位在惰性气氛保护下进行电解,电解温度控制在500-1000℃,控制电解时间使电解电量到达到理论所需电量及以上,将五氧化二钽电化学还原为超细金属钽粉。
-
At 25℃,in 30w/o KOH aqueous,when current density is 2000A/m 2,the evolution oxygen overpotential of the oxidized Ni anode decreases 260mV relative to unoxidized Ni anode.
常温下,电流密度2000A/m2电解30%KOH水溶液时,脉冲电流氧化的Ni阳极析O2超电势比普通Ni阳极下降260mV。
-
The oxidation rate is quick with the hoist of the temperature and the weight loss increased with the time pronging at certain temperature.
气种试样的氧化失重对比实验表明,无涂层的石墨阳极试样氧化失重严重,随着温度的升高,氧化速度加快,在确定温度下随着时间的延长,氧化损失不断增加。
-
The current decay of CO oxidation at Pt SPE gas sensing electrode in short time scale has been studied.
对短时间内Pt-SPE气敏电极上CO氧化电流的衰退现象的研究表明,Pt表面无CO吸附态情况下,衰退主要与电极阳极极化后Pt表面氧化程度加深有关;采用动电势扫描法可使电极对CO氧化的催化活性基本恢复,但随着电极的进一步极化,衰退仍会继续。
-
Results: 1Lightly selective solution appeared on the surface of anodizing samples. The sample's metal surface expanded and the thickness of oxide film is 1.72 times of the control samples. 2 The samples of degassing-preoxidation group formed very thick oxide film on surface and it was 23.32 times of the control samples, the relative content of O element in thick oxide film was higher than the other 2 groups.
阳极钝化处理的试片表面发生了轻度的选择性溶解,增加了金属的表面积,所形成的氧化膜厚度是空白对照组的1.72倍。2)除气加预氧化组则形成较厚的氧化膜,为空白对照组的23.32倍,而且氧化膜内氧原子的相对含量远远高于其他实验组。
- 推荐网络例句
-
They weren't aggressive, but I yelled and threw a rock in their direction to get them off the trail and away from me, just in case.
他们没有侵略性,但我大喊,并在他们的方向扔石头让他们过的线索,远离我,以防万一。
-
In slot 2 in your bag put wrapping paper, quantity does not matter in this case.
在你的书包里槽2把包装纸、数量无关紧要。
-
Store this product in a sealed, lightproof, dry and cool place.
密封,遮光,置阴凉干燥处。