阀门控制

Rate'.'' of water flow through a sluice.

控制通过水闸的水速的阀门。

Sources equipment checks : cold water, vacuum, compressed air, ventilation, nitrogen system; 2 Second, production of electrical equipment checks : Mixing, thermometers, pressure gauge, safety valve and the water supply valve and pipe materials Absorption normal; 3 ③ measurement and control system for communications; Facilities and environmental monitoring system checks; 1.3 production plans and arrange the production cycle length ahead of the relevant staff work schedules.

哪位高手能给翻译一下？①动力源设备检查：冷热水、真空、压缩空气、通风、氮气等系统；②生产设备检查：搅拌电机、温度表、压力表、安全阀及供水和吸放料管道阀门是否正常；③计量和通讯控制系统检查；环保设施和监控系统检查； 1.3 人员安排：根据生产计划和产品生产长短周期提前安排好有关人员作息时间。

I don't know how to control this valve .

我不知道怎么控制这个阀门。

What is the control function of the valve?

阀门的控制功能是什么？

It contains establishing control model of this engine, the models are based on engine average value in time, they can be divided as intake manifold, engine dynamics, velometer section and other subsystem model of CBM engine. Besides these, it also contains model of sensors using in engine intake system and running detection, model of step motor using in driving throttle.

文章主体的内容包括建立发动机燃用变组分燃料的控制模型，建模的思路是采用基于时间的发动机平均值模型，其中分为进气歧管、发动机动力学、调速器等发动机各子系统模型，另外包括对发动机进气系统、运行参数进行检测的传感器模型以及驱动阀门的步进电机模型等。

Xuzhou ARCA Chemical Machinery Co. Ltd., the Chinese investor of Xuzhou ARCA Control Valve Co.

徐州化工机械有限公司系徐州阿卡控制阀门有限公司的中方投资方。

Controlling the position of electrically or electropneumatically actuated valves, these devices were developed for Amot G Series temperature control valves.

这些能够控制电力或者电力气动阀门位置的装置，使AmotG系列的温控阀得到了进一步的发展。

In addition to an extensive range of single and multiple vessel systems Stansted also manufacture and supply optical cells,basic pressure vessels,pressure generation and control systems,pressure transducers,valves and fittings with experienced local support India by Hydraulicon Systems

除了提供整套系统以外，Stansted也可生产提供配件如：光信连接器、高压容器、压力发生及控制系统、压力传感器、阀门及液压系统连接头等。

Results indicate:(1) The newly developed simulation technology can form fairly average and easily controllable back pressure downstream the inlet, so it can he used to investigate the back pressure characteristics of hypersonic inlets.(2) By regulating the valve of injection pipe, the simulation technology can realize the switch of hypersonic inlet started state and unstarted state in about 8 milliseconds, so it is suitable to investigate the starting/unstarting/resarting problem of hypersonic inlets.

结果表明：(1)所提出的凹腔喷流技术可在进气道下游形成较为均匀的、可控的背压环境，因此可用于进气道的反压特性研究；(2)适当调节凹腔的喷流总压，并在实验中实时控制阀门的开度，凹腔喷流技术能够在较短的风洞实验时间内（约8s）实现进气道起动、不起动、再起动流态之间的切换，因此可用于进气道的不起动／再起动特性研究。

Thus, a decoupling chamber pressure control system was designed and installed at the end of the tailpipe of a valveless self-excited pulse combustor. The relative pressure in the decoupling chamber was controlled from about -10 kPa to 10kPa through a blower, and the influence of pressure variation on the heat transfer in tailpipe was investigated.

在一台无阀自激脉动燃烧器尾部建立了去耦室压力控制系统，通过调节引风机前的阀门开度来改变去耦室内部压力即尾管出口压力大小（调节范围-10～10 kPa），实验研究了去耦室压力变化对脉动燃烧器尾管传热的影响。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。