阀门

This valve is not an ASME approved safety relief valve, and should not be used in system applications with this requirement.

这种阀门不是ASME认证的安全阀，不能用在有这种要求的系统上。

No valve is to be placed between the relief valve and tank .

在热水器储水罐和安全阀之间不需要安装任何阀门。

No valve is to be placed between the relief valve and the tank.

在安全阀和容器之间不能安装任何阀门。

Valves requiring processing in the Clean Room should first be assembled prior to cleaning, subjected to cracking and reseat pressure, and flow tested in the flow outside the clean environment.

要求在绝对无尘室处理的阀门首先必须在清洗前进行组装，经过裂化及复位施压，然后在清洁环境下的流体中作流动测试。

For most of these valves, a restriction is necessary to produce the required pressure control.

对于大多数的这些阀门、限制是必要的生产要求的压力控制。

It is recommended that to use the valve in one way but in the case of the revers sealing is not important, using in double way is permitted.

该阀门推荐单向使用，在反向密封要求不严格时，可双向使用。

When packing for the valve, the valve packing section and the same space, it is best Preloading Central: When the time for the pump, valve packing and the space section (about 0.3mm-0.6mm) axis and the disk so that there is a leakage of the root space is conducive to lubrication and cooling.

当盘根用于阀门时，盘根截面和阀的空间一样，最好是预压环：当用于泵时，盘根截面和阀的空间(约0.3mm-0.6mm)使轴和盘根有一泄露间隙，有利于润滑和散热。

The use of imported high quality raw materials to produce products that have tubes, pipe fittings, valves, multi-purpose spray equipment, Rotameter, automatic hydraulic valve, squeeze hard plate, heat-resistant ABS Products, CPVC hot and cold seafood, clean UPVC Products such as the top ten of the 80 series, 1000 specifications.

采用进口优质原料生产的产品有管材、管件、阀门、多功能喷具、转子流量计、全自动液动阀、挤压硬板、耐热ABS产品、CPVC冷热水产品、洁净UPVC产品等十大部分，80个系列，1000个规格。

A steam iron having a thermostat, a steam valve, and a rotatable temperature control.

一种具有一个恒温器、一个蒸汽阀门、和一个可旋转温度控制器的蒸汽熨斗。

Hebei loftyValve Group Co., Ltd. is located in the village of industrial roundwood Yin, China Yan-fat.

河北远大阀门集团有限公司位于隆尧县尹村工业圆，是中国严发。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。