阀弹簧

The wellhead part mainly includes the controlling device, the pneumatic valve, the blowout control box, the damping spring and the plunger catcher, and the downhole part consist of the combination tubing, the buffer spring, the tubing spider and the plunger which reciprocated between the tubing.

井口部分主要包括控制器、气动阀、防喷盒、减震弹簧、柱塞捕捉器；井下部分主要包括大小油管、缓冲弹簧、油管卡定器，以及在大小油管间往复运动的柱塞。

Check paper may affect the pressure of the pressure that the reason for the press paper under the valve in the fuel tanks in the culumn because of the unavailability for a long time fatigue has broken off a section of this article, press paper cylinder performance of the product will be trimmed to be exerted by request, the replacement of a good spring, cut-quatily.

逐一检查可能影响压纸器压力的诸多方面后，发现原因在于压纸油缸内下阀芯里的压力弹簧因用久疲劳折断了一节，致使压纸油缸的工作性能满足不了产品裁切时应施加的压力要求，更换完好的弹簧后，裁切的质量达到了要求。

Caused by the brake disc brake on back wheel should not have four kinds of spaces possible: First, the foot brake 5 exhaust inlets, high pressure gas instinct Pai people the atmosphere, caused by gas-liquid master cylinder should not spring back to place, cause the system Oil will move the brake disc brake wheel cylinder piston top dead can not come back to places; are gas-liquid two disc brake master cylinder to the tubing plug, resulting in brake wheel cylinder piston can not come back to places; are three master cylinder of gas-liquid Can not spring back to their own spaces, brake fluid under high pressure gas, liquid should not return to the master cylinder reservoir chamber, resulting in brake wheel cylinder piston can not come back to places; are four wheel disc brake piston brake system because of moving fluid dirty or rusty Pistons Can not Back-bit card dead.

造成盘式制动器上的制动分泵不能回位有4种可能：一是脚制动阀5的排气口堵塞，高压气体本能排人大气，造成气液总泵的弹簧不能回位，导致制动油将盘式制动器的制动分泵活塞顶死而不能回位；二是气液总泵至盘式制动器的油管堵塞，造成制动分泵活塞不能回位；三是气液总泵的弹簧本身不能回位，制动液在高压气体作用下，不能回到气液总泵的储油室，从而造成制动分泵活塞不能回位；四是盘式制动器制动分泵活塞由于制动液太脏或活塞生锈卡死而不能回位。

Caused by disc brake on the brake Wheel Cylinder could not return to places 4 possible: First, 5 foot brake valve exhaust port blocking, high-pressure gas instinct platoon atmosphere, caused by gas-liquid master cylinder of the spring could not return to place, resulting in the system move oil, brake disc brake Wheel Cylinder Piston top dead and could not return to places; second is to the disc brake master cylinder gas-liquid pipeline blockage, resulting in brake Cylinder piston can not return to place; third master cylinder of the gas-liquid Spring itself can not return to position, brake fluid under high pressure gas can not return Axial pump to gas-liquid master cylinder reservoir chamber, resulting in brake Cylinder piston can not return to places; Fourth Wheel Cylinder piston disc brake system, due to moving fluid dirty or rusty card dead and can not return to the piston position.

造成盘式制动器上的制动分泵不能回位有4种可能：一是脚制动阀5的排气口堵塞，高压气体本能排人大气，造成气液总泵的弹簧不能回位，导致制动油将盘式制动器的制动分泵活塞顶死而不能回位；二是气液总泵至盘式制动器的油管堵塞，造成制动分泵活塞不能回位；三是气液总泵的弹簧本身不能回位，制动液在高压气体作用下，不能回到气液总泵的储油室，从而造成制动分泵活塞不能回位；四是盘式制动器制动分泵活塞由于制动液太脏或活塞生锈卡死而不能回位。

With more isthe piston - spring type energy storer, this energy storer is locatedbetween the solenoid valve and the dump pump, comes by the wheelcylinder 液压油 to enter the energy storer, then the compressionspring causes the energy storer hydraulic pressure cavity volume tochange in a big way, to temporarily stores up the brake fluid.

用得较多的为活塞-弹簧式储能器，该储能器位于电磁阀与回油泵之间，由轮缸来的液压油进入储能器，进而压缩弹簧使储能器液压腔容积变大，以暂时储存制动液。

When the flow through the balance of the piston damping the flow of holes increases, the balance of the piston, the next increase in pressure on both sides of a balanced increase in the distance the piston increases, and vice versa reduced; and also because the spring stiffness is very small, so that shift the balance of the piston pressure required very few changes, so the flow through the Poppet head is not much change, so the first opening Poppet very few changes, to mention the pressure of moving the first opening can be said to remain unchanged, that is, when the pilot valve spring after a set, Poppet Head was opened, the balance piston chamber pressure remained basically unchanged.

当流经平衡活塞上阻尼孔的流量增加时，平衡活塞上、下两侧的压差增加，平衡活塞上升距离增加，反之则减小；又因为弹簧的刚度很小，使平衡活塞上移所需压差变化很小，所以通过提动头的流量变化也不大，因此提动头的开口变化很小，提动头开启的压力可以说是不变的，亦即当先导阀的弹簧一经设定后，提动头被打开时的平衡活塞上腔的压力基本保持不变。

Pilot-operated pressure reducing valve is to use well in advance to adjust the air pressure instead of springs for voltage regulator, and its regulation principles and the main valve part of the structure and the same direct-acting pressure reducing valve.

先导式减压阀是使用预先调整好压力的空气来代替调压弹簧进行调压的，其调节原理和主阀部分的结构与直动式减压阀的相同。

Lift check valve with a spring load can withstand light valve flap, flap valve lift is not high.

起落式止回阀施用一个可承受弹簧荷重的轻量阀瓣，阀瓣的升程不高。

Mainly by the valve body, valve cover, piston, spring, main valve, valve and membrane composed of the Deputy.

主要由阀体、阀盖、活塞、弹簧、主阀、副阀及膜片等组成。

Pressure valve is of direct action type, which is composed of body, seat, core parts, bonnet, highest quotation, diaphragm, spring, adjusting nut and upper and bottom diaphragm cover etc..

本产品为直接作用型自力式压力调节阀。由阀体、阀座、阀芯部件、阀盖、顶盘、上、下膜盖、膜片、弹簧、调节螺母等零部件所组成。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。