阀座

In time, the seats of rotary air lock valves leak.

而在这个时候，回转式气塞阀门的阀座就会出现泄露。

To minimize this possibility, Air Products has developed a valve that has the seat internal to the tube.

为了使这种可能性最小化，Air Products研制了一种阀座在管道内部的阀门。

Valves to have aluminum bronze disc and molded in or cartridge seat of EPDM rubber.

阀门配置铝青铜阀瓣和三元乙丙橡胶的模压式或卡盘式阀座。

Note: A Buna O-ring is installed on the upstream side behind the seat ring.

注意：丁纳橡胶O形环安装在上游侧面，位于阀座环后。

Driven by the valve stem to close one to wind the rotatory central point while rotating,the spheroid to the third a bit more separately, relative valve central point at this moment,from the third orbit a bit one cam form partial another,enter valve flat make valve it keep sealing to shut off down wards .

由阀杆带动关闭件绕旋转中心点转动时，球体由另点移至第三点，此时相对阀门中心点，从另点的第三点轨迹为一凸轮状偏心，向下进入阀座使阀门关闭保持密封。

Diaphragm, Stop Seat and Vacuum Breaker to be molded from PERMEX Rubber Compound for Chloramine Resistance

采用PERMEX橡胶化合技术将隔膜片，止回阀阀座和真空断路阀模压在一个整体内，有利于防止氯胺的腐蚀

And then tighten the clamp bench seat belt; transfer, remove with circlip pliers, and then relax circlip pliers-bed NIPs, at which point the attention, the demolition of parts, watch out for spring components, not lost.

然后收紧钳台夹口；阀座内移，用卡簧钳取出卡簧，然后放松钳台夹口，此时注意拆出的部件，留意弹簧组件，不要遗失。

Kit consists of: Check seat, Seat O-ring and Cover O-ring.

组件包括：止回阀阀座，阀座O形环和阀盖O形环。

Kit consists of: Seat, Seat O-ring and Cover O-ring

组件包括：阀座，阀座O形环和阀盖O形环

The standard seats promote a low-pressure seal, using wave spring force to load the metal seat carrier toward the ball.

标准阀座采用波纹弹簧机构，将阀座推向球体，保证了良好的低压密封性能。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。