阀座

Swing check valves should be used one kind of screws or bolts to connect the valve cap for inspection and repair of disc and seat.

旋启式止回阀应该选用一种螺丝或螺栓连接的阀帽，以便检查和修理阀瓣和阀座。

Component-oriented face closure: closure of part of components, which allows the valve closure element cage, valve seat ring, valve cover, bottom flange or more of any two components where movement.

截流元件导向面：截流元件的一部分，它使得截流元件在阀笼、阀座环、阀盖、底法兰或以上任意两个零件里运动。

In the straight-through valve, the valve parts typically include the closure components, valve seat ring, valve cage, valve stem and the stem pins.

在直通阀体里，阀内件典型地包括截流元件、阀座环、阀笼、阀杆和阀杆销钉。

Do not allow any pipe dope into valve body in order to avoid damage to disc and seat.

不要让任何管道粘接剂流入阀体内，以避免损坏阀瓣和阀座。

Do not allow any pipe dope into valve body in order to avoid damage to discseat.

不要让任何管道粘接剂流入阀体内，以避免损坏阀瓣和阀座。

Do not allow any pipe dope into valve body in order to avoid damage to disc and seat.

不要让任何管道粘接剂流入壳体内，以避免损坏阀瓣和阀座。

Thus, by adjusting the tightness of the union nut, the squeeze of the seats against the ball would be maintained.

因此，在调节管接螺母的紧固度时，阀座对球体的压力就一直存在着。

Adjustment of this union nut can compensate for wear of TFE seats, with no production loss to remove valve for internal adjustment.

这种管接螺母的调整能够弥补TFE阀座的磨损，避免由于拆卸阀门进行内部调整作带来的损失。

Gravity ball check valves are converted to foot valves by replacing the union nut and end connector on the receiving end – seat end – of the body with an F.V.

重力球形止回阀可以变为底阀，只需在接受端口-阀体的阀座端口，用一个F.V。

The trap body and cover shall be manufactured out of cast iron, the diaphragm cover shall be forged brass, the diaphragm shall be duplex phosphor bronze type with stainless valve cone, the condensate valve and seats shall be hardened stainless steel and the float shall be manufactured out of seamless copper.

这种疏水阀的阀体和阀盖应该采用铸铁制造，隔膜盖应该采用锻造黄铜，这种隔膜应该是双磷青铜类型并配置不锈钢阀芯，凝结水阀和阀座应该采用硬化不锈钢，浮子应该采用无缝铜制造。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。