阀座

Lever Ball Float Steam Traps seat to increase the use of pairs of condensing water displacement, small displacement can reach large, the largest hydrophobic capacity of 100 tons / hour, is the ideal trap large heating equipment.

杠杆浮球式疏水阀利用双阀座增加凝结水排量，可达到体积小排量大，最大疏水量达100吨/小时，是大型加热设备最理想的疏水阀。

Lever ball float type steam trap condensate using two-seat increase in displacement, small displacement can reach large size, the largest drainage capacity of 100 tons / hour, is the major heating equipment, the best traps.

杆浮球式疏水阀利用双阀座增加凝结水排量，可达到体积小排量大，最大疏水量达100吨/小时，减压阀是大型加热设备最理想的疏水阀。

Lever Ball Float Steam Traps are not subject to the greatest advantage of pressure, temperature, condensate water flow fluctuations, continuous drainage, water that is exclusive, the Butterfly Valves minimum undercooling of 0 ℃, heating equipment can achieve the best efficiency; Lever Ball Float Steam Traps seat total in the level below, the formation of water seal, no steam leakage; its minimum working pressure 0.01Mpa, the biggest back-pressure rate of ≤ 85%; house with an exhaust device, lever float steam trap uses the most advanced components as the automatic emptying of diaphragm valves, can automatically rule out non-condensing gas, very sensitive, high-quality work and long service life.

杠杆浮球式蒸汽疏水阀的最大优点是不受压力、温度、冷凝水流量波动的影响，连续排水，有水即排，最小过冷度为0℃，能使加热设备达到最佳工作效率；杠杆浮球式蒸汽疏水阀的阀座总处于液位以下，形成水封，无蒸汽泄漏；它的最低工作压力0.01Mpa，最大背压率≤85%；内部带有排气装置，杠杆浮球式蒸汽疏水阀采用最先进的膜盒元件做为自动排空气阀，能自动排除不凝结气体，非常灵敏，工作质量高，使用寿命长。

The lever-ball float type trap employs the buoyancy and leverage principles: to make the ball float ascend or descend by the change in the liquid level and then the ball float drives the lever to make the valve disc depart from or touch the valve seat to realize drainage and close the block vapor.

杠杆浮球式是利用浮力原理和杠杆原理，通过液位的变化使浮球上升或下降，浮球驱动着杠杆使得阀瓣离开或接触阀座达到开启排水和关闭阻汽的作用。

Hold the lower valve rod, place hydrant seat into lower barrel until the bottom contacts drain ring.

用双手握住下阀杆，把阀座放入地下埋管，直到底部与放水环接触为止。

As part of the contract for the project, a UK valvemaker is supplying a Class 1500, six inch metal seated double block and bleed ball valve for a critical duty demanding zero seat leakage on liquid and gas duty.

作为该工程合同的一部分，一个英国阀门制造商正在提供一只1500级，6英寸金属硬密封双截断和泄放球阀，以满足在液体和气体工况下阀座泄漏率为零的要求。

Next, in order to ensure the process precision and production efficiency of boring machine tool ,the jig uses 'one surface-two sell' .the way of Clamps is hydraulic pressure clamping, which replaced by Manual clamping.

其次，夹具采用一面两销定位，保证了导管孔及气门阀座孔对定位销孔的位置精度。

Cut-off valve is closed parts along the center line to move the valve seat.

截止阀是指关闭件沿阀座中心线移动的阀门。

Apply heat with the flame directed AWAY from the center of the valve body.

焊接火焰不要靠近阀体中心点，温度过高会伤害阀座。

Should re-adjust the amount of compression spring or a heavy hammer position; valve flap and valve seat stick.

应重新调整弹簧的压缩量或重锤的位置；阀瓣与阀座粘住。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。