阀体

Turn handle to be perfectly perpendicular to valve body.

将手柄旋转到与阀体完全垂直的位置。

IMPORTANT! Flow must always be in direction of arrow on valve body.

重要提示！水流流向必须与阀体上的箭头方向一致。

Will be the new O-ring 6, sealing gasket 39 into valve body then the installation of slot.

11将新的O型圈6，密封垫片39装入阀体接体的安装槽中。

At the same time, the stress analysis of the control valve body was shown by considering the fluid-structure interaction.

同时，在考虑流固耦合作用下对控制阀阀体进行了应力分析。

It shall be bronze-bodied and include not less than one union, with the union nut drilled to accept a tamper-proofing lock wire.

这种装置应该是青铜阀体，其接头不止一个，配置有带钻孔接头螺母，能够接受防篡改锁线。

Gravity ball check valves are converted to foot valves by replacing the union nut and end connector on the receiving end – seat end – of the body with an F.V.

重力球形止回阀可以变为底阀，只需在接受端口-阀体的阀座端口，用一个F.V。

Regulation in a number of institutions under the valve cover as part of the body is not separated.

在一些调节机构中下阀盖作为阀体的一部分，并不分离。

The results show that single power source twin-wire submerged arc welding, which is one of alternative methods of submerged arc welding with high deposition rate and low heat input, can meet manufacturing requirements of lange diameter full welding ball-valve.

结果表明，单电源双丝自动埋弧焊熔敷率高、热输入低，可满足大直径全焊接阀体球阀的制造要求。

The results showed that single power source twin-wire submerged arc welding, which is one of alternative methods of submerged arc welding with high deposition rate, low heat input, can cater for manufactural demands of big diametrical full welding ball-valve's manufacturing.

结果表明，单电源双丝自动埋弧焊熔敷率高、热输入低，可满足大直径全焊接阀体球阀的制造要求。

The trap body and cover shall be manufactured out of ASTM-A-126-7/Class B cast iron.

疏水阀阀体和阀盖应该采用ASTM-A-126-7/B级铸铁制造。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。