阀体

Body: Body is cast to provide liberal strength to meet operating conditions and to permit unobstructed flow.

阀体：阀体是铸件，具有足够的强度满足工作环境的要求，流体流动不会受到阻碍。

Style G wafer style body valves are designed with flangeless bodies with relatively short face-to-face dimensions.

类型G对夹式阀体阀门采用无法兰阀体结构，面对面尺寸相对较短。

Body and bonnet: Austenitic stainless steel forgings used for bodies and bonnets offer excellent impact strength, minimal heat loss and protection against corrosion.

阀体和阀帽：奥氏体不锈钢锻件用在阀体和阀帽上，具有优异的冲击强度，最小的热损耗和耐腐蚀能力。

As the gasket extrudes from the body, it may push the rubber flange away slightly from the cast body.

如果垫圈从阀体内挤出，则可能会将橡胶法兰从铸造阀体上轻微推出。

Metal Body lining valve: body shape metal, interior where the main point of contact with the media are lining the surface, such as rubber lined valves, plastic valves lining, lining ceramic valve.

3金属阀体衬里阀门：阀体外形为金属，内部凡与介质接触的主要表面均为衬里，如衬胶阀、衬塑料阀、衬陶阀等。

Diaphragm of the valve type selection valve diaphragm selection of choice is the most important aspects.

隔膜泵的阀体类型选择阀体的选择是隔膜泵选择中最重要的环节。

This article introduce the designing principle and structural features of forging body for ball valve; detailed analgzing open die draw extruded forging process on smith hammer and die designing.

介绍了锻钢球阀阀体设计的原则和特点，论述了在自由锻锤上锻造阀体的翻挤成形工艺及模具设

Next Body: contains valve internal parts, there is a flow channel connecting the mouth of the half part of the body shell.

下阀体：包含阀门内部零件，有一个流道连接口的阀体壳体的一半部分。

On the Body: contains valve internal parts, there is a flow channel connecting the mouth of the half part of the body shell.

上阀体：包含阀门内部零件、有一个流道连接口的阀体壳体的一半部分。

There aren't any pipe joints of integral valve, therefore it's not subject to pipe or bolt influence, pressure case will not be subject to "mutation" of pressure.

不带任何管接头的整体式阀体，因此不受管道或螺栓应力影响，并且由于阀体无任何管接头，故耐压壳体不会受压力&突变&的影响

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。