阀体
- 与 阀体 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
Note: Valves are static grounded by two ball detents that insure electro-continuity between the stem body and ball.
注意:这种阀门是采用两个球形制动器实现静电接地,确保阀杆阀体和球体之间的电镀连续性。
-
Two bars of belt chain fire grate; two flakes of small louver fire grate; one middle clamping sheet; one side clamping sheet; two flakes of large louver fire grate; one middle clamping sheet of large louver fire grate; one side damping sheet of large louver fire grate; one roller; two bars of cross girder fire grate; one adapter; two flanges; one valve body.
产品/Product:炉排付片二件;小鳞片炉条二件;中夹板一件;边夹板一件;大鳞片炉条二件;中夹板一件;边夹板一件;滚柱一件;横梁炉排中片二件;阀体一件;适配器一件;法兰二件。
-
Crankcase、Crankshaft、Spider、Cylinder、Yoke Flange、Coupling、Valve Body、Mounting Ring、Adapter、Bracket、Power Line Casting.
产品/Product:曲轴箱体、曲轴、星形制动、汽缸、节叉法兰、软管接头、阀体、安装环、适配器、支架、线路件。
-
Because the crank is connected with the shaft through the flat key and the shaft is fixed onto the valve plate with the pin, thus the valve plate is driven to turn in the valve body so as to change the flow area of the pipeline change to regulate the flowrate of the medium.
由于曲柄通过平键与轴连结,。轴与阀板用销子固定,从而带动阀板在阀体内回转,使管道流通面积变化,达到调节介质流量。
-
Metal floating valve seat seal structure between the float valve seat and valve seal is not easy.
金属浮动阀座密封结构其浮动阀座与阀体之间不易密封。
-
Clips sealing construction design and finite element analysis of hydrostatic pressure kettle;2. The problems of sealing construction in float ball valve have been analyzed .
分析了石化行业用钛制浮动式球阀密封结构存在的问题,从球阀的端面密封、浮动支座、阀体连结等方面提出了新的设计方案,以提高钛球阀的使用寿命,拓宽钛材的应用范围。
-
Friction discs, brake clamp body, bracket, steering Stand Etc motorcar Fitting. Valve, valve body castings, hydraulic pressure jack castings, well cover and base component etc.
主要产品有:制动盘、制动钳体、支架、转向节等汽车配件,阀门、阀体铸件,液压千斤顶铸件和窨井盖等基础件。
-
Its has four types, continnueains over 200 kinds, and above 60% castings are exported, friction discs, brake clamp body, bracket, steering stand etc motorcar fitting, valve, valve body castings, hydraulic pressure jack castings, well cover and base component etc.
主要产品有:CA498汽缸体铸件、制动盘、制动钳体、支架、转向节等汽车铸件,阀门阀体铸件,液压千斤顶铸件和窨井盖等通用铸件。
-
When full-opening, the angle off of ball body and valve body via axes no more than 3°.
阀门全开时,球体通孔轴线与阀体通孔轴线的夹角不大于3
-
The design concept of the automatic security shutoff is a hinged door closing onto a knife-edged seat fully contained in a high-grade ductile iron body.
自动安全关断的设计原理是由内置於高品质延性铸铁﹝或铸钢﹞阀体,以铰闩的阀门闭锁在一具有刃缘的阀座上。
- 推荐网络例句
-
This one mode pays close attention to network credence foundation of the businessman very much.
这一模式非常关注商人的网络信用基础。
-
Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.
扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。
-
There is no differences of cell proliferation vitality between labeled and unlabeled NSCs.
双标记神经干细胞的增殖、分化活力与未标记神经干细胞相比无改变。