间隙的

At last the mould was designed by the antitype of some kind of notepad. The study of the technology parameters such as drawing temperature , drawing speed , block holder pressure , lubricate condition showed that when the mould clearance was 1.6mm, drawing temperature was 220~280℃, the block holder clearance was 1.16, the block holder pressure was 2 ton we can formed a qualified notepad shell of the fillet radius of 2.4mm.

最后，以某型号笔记本电脑外壳为原型，自行设计、加工了笔记本电脑外壳热拉深模具，对其拉深温度、拉深速度、压边力、润滑条件等拉深工艺参数研究表明，当模具间隙为1.6mm，拉深温度为220～280℃，压边间隙为1.16，采用石墨+机油润滑时，可获得最小圆角半径为2.4mm的笔记本电脑外壳拉深件，所得拉深件贴模性良好、回弹小，达到了设计要求。

These were studied in anesthesia extent, dose, muscular flaccidity, the operation time, referred pain, nausea, vomiting and adjuvant application.

目的 探讨选用胸10～11硬膜外麻醉用于阑尾切除术的可行性方法选择ASA Ⅰ~Ⅱ级行阑尾切除术200例病人，随机分 T1组：选用胸11～12椎间隙穿刺（n=100）；T0组：选用胸10～11椎间隙穿刺（n=100），观察麻醉阻滞平面、麻醉药用量、肌松、手术时间、牵涉痛、恶心、呕吐、辅助药应用等。

This principle can also be used to calculate the imaginary part for a given real part of the gap-impedance.

该方法原则上可求解任意给定间隙电阻所对应的间隙电抗值。

If your interdental space is large

如果您的间隙太大最好用间隙刷。

The result shows that information fusion can improve the accuracy of on-line monitoring interelectrode gap, and the error range can be controlled under 10 percent using fused equation when inter-electrode gap of ECM is between 0.2 to 0.4 mm.

试验表明：信息融合可以提高加工间隙在线检测的准确性，融合公式在间隙范围为0.2 ~ 0.4 mm内，实现检测误差小于10%。

The vehicle image presents more irregularity and largeness of gaps than natural terrain's image. Based on fractal theory, the lacunarity feature is estimated to measure the difference and can be used to eliminate the natural clutter.

基于这一特点，利用分形理论提取间隙度特征来定量估算待鉴别目标像素强度分布的不规则性和间隙大小，并以此实现鉴别处理。

T his design improvement spot: First, in radial clearance adjusting mechanism link motion gear, second , backlash adjustment increase self-locking installment.

本次设计的改进点：首先，在径向间隙调整机构连杆机构，其二，侧向间隙调整增加自锁装置。

It shows that when one screw is of opposite phase to the other one, the pure elongational force field is be caused by the vibration, along with the oscillating effect during the course of the surface stretch.

引入右Cauchy-Green张量分析了间隙内的界面拉伸量，发现当两根螺杆反相位振动时，螺棱侧间隙内存在纯拉伸力场，而且界面在拉伸过程中存在着振荡效应。

Under the angle 30°,the operative vacuity of space Ⅰ and Ⅱ were the biggest.

结论间隙Ⅰ、Ⅱ是鞍区手术中最常用的间隙，在30°视角下，其手术操作空间最大；

Results HE and Congo red stained sections showed that the pancreatic glandular lobule space was widened, with significant connective tissue hyperplasia, and fat accumulation when the islet was stained indistinctly or vermeil and tissue space was broadened.

结果 HE和刚果红染色切片光镜观察显示，胰腺小叶间隙增宽，呈明显的结缔组织增生、脂肪堆积；胰岛淡染或着朱红色，组织间隙明显增宽。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。