间隙的
- 与 间隙的 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
Nonbicarbonate and intracellular buffers contribute to the buffering of newly formed acid so that the actual drop in [HCO3-] is usually less than the increase in the anion gap due to a simple elevated-gap metabolic acidosis.
非碳酸氢盐和细胞内缓冲液有利于缓冲新形成的酸,以致实际[HCO3-]的下降低于单纯性AG增高型代谢性酸中毒引起的阴离子间隙的增加。
-
Nonbicarbonate and intracellular buffers contribute to the buffering of newly form ed acid so that the actual drop in [HCO3-] is usually less than the increase in the anion gap due to a simple elevated-gap metabolic acidosis.
非碳酸氢盐和细胞内缓冲液有利于缓冲新形成的酸,以致实际[HCO3-]的下降低于单纯性AG增高型代谢性酸中毒引起的阴离子间隙的增加。
-
There is now a corporate business card printing and membership card when used by a number of roller line is relatively high, reached 180-line/inches or 250 line/inch, in business card printing and membership card to make a color swatch, big text, inking insufficient operators often use inlarging monlchamus tuhung plinthitic roll roll and retrohepatic methods to increase the amount of ink.
此刻有的企业制卡和会员卡制作时所搁置的网纹辊线数偏矮,到达180线/英寸或250线/英寸,在制卡和会员卡制作色块、不小的笔不朱时,不朱度不敷,因此不不安纵者必然拔取增不小不朱斗辊与网纹辊间隙的办法来补充不求不朱度。
-
They have been demonstrated to be used in analysis of most failures in flip chip assembly as follows: 1 We firstly reported the IRM inspection of underfill delamination and crack.
主要结果为: 1首次利用红外显微镜测出了倒装芯片中的下部填充料裂缝和分层的位置,以及分层中空气间隙的大小。
-
Through choosing the blanking clearance of material in reasonable,just by one die blanking the different thickness of very thin gaskets, the die structure was simple and practical.
通过对材料冲裁间隙的合理选取,只用一副冲模就实现了对厚度不同的超薄垫圈的生产,且模具结构简单、实用。
-
We measured the knee joint gap of flexi...
在后交叉韧带被切断前后用张力测量器分别测量膝关节屈曲90度和伸直位时的内外侧膝关节间隙的数值,精确度为1mm,不加额外的其他力量。
-
More specifically the shunt structure prevents magnetic field from the portion of the write coil beyond the back gap from magnetizing a magnetic shield of the read head.
更具体而言,分路结构防止来自超过后间隙的部分写线圈的磁场磁化读头的磁屏蔽件。
-
Meanwhile, convex, concave-space setting, the intensity punch checking, choose a suitable model handles.
同时,凸,凹模间隙的确定,凸模的强度校核,选择合适的模柄。
-
Meanwhile,convex, concave-space setting, the intensity punch checking, choosea suitable model handles.
同时,凸,凹模间隙的确定,凸模的强度校核,选择合适的模柄。
-
Computation and test showed that the variation of magnetic force and bearing rigidity increases along with the reduction of axial magnetic gap and the augment of clearance between magnets.
计算和试验表明,随着磁隙的减小,磁块间隙的增大,磁力和刚度的变化增大。
- 推荐网络例句
-
I didn't watch TV last night, because it .
昨晚我没有看电视,因为电视机坏了。
-
Since this year, in a lot of villages of Beijing, TV of elevator liquid crystal was removed.
今年以来,在北京的很多小区里,电梯液晶电视被撤了下来。
-
I'm running my simile to an extreme.
我比喻得过头了。