间隙的

Variations of completeness of fusion were also represented. For ALIF and PLIF, this included tests of solid bridging bone within the posterior or anterior 75%, 50%, or 25% disc space.

对腰椎前路椎间融合与后路椎间融合来说，包括对起稳定连接作用的植骨骨质的测验，这些骨质在前路或后路手术中分别占椎间隙的75%， 50%或者25%。

Ariations of completeness of fusion were also represented. For ALIF and PLIF, this included tests of solid bridging bone within the posterior or anterior 75%, 50%, or 25% disc space.

对腰椎前路椎间融合与后路椎间融合来说，包括对起稳定连接作用的植骨骨质的测验，这些骨质在前路或后路手术中分别占椎间隙的75%， 50%或者25%。

A 7 degrees of freedom dynamic equation of helical bevel gear system with clearance was developed.

建立了含间隙的7自由度螺旋锥齿轮动力学方程，结合分岔图和最大Lyapunov指数曲线研究了分岔的演化过程及系统参数对系统分岔和混沌行为的影响。

Objective: To evaluate the effects of posterior cruciate ligament resection on thetibiofemoral joint gap and its clinical value in total knee replacement.

目的：通过研究人工膝关节置换术中后交叉韧带切除对于胫股关节间隙的影响来探讨后交叉韧带在人工膝关节置换中的临床意义。

A set of image processing algorithm for structure light stripe is presented, which combines local messages with global messages. The algorithm can overcome second reflection light effectively, which is applicable to joint seam with gap or no.

建立了一套结构光光纹图象处理算法，该算法将全局信息和局部信息结合起来，能有效地克服二次反光的影响，适用于有、无间隙的角焊缝结构光光纹。

We measuredthe knee joint gap of flexion in 90 degree and full extension by using tensor devicebefore and after resecting posterior cruciate ligament. The minimum incrementwith this device was 1 mm.

在后交叉韧带被切断前后用内径卡尺分别测量膝关节屈曲90度和伸直位时的内外侧膝关节间隙的数值，精确度为1mm。

Numerical calculations were conducted on a controlled wing with flapping gap and rotating gap.

以某一飞机的带有扑动和旋转间隙的受控翼面为例进行了数值计算。

It allows you to make slow motion smoother, clean up jumpy low framerate video, and stretch or shrink video to fit into a time slot.

允许你使慢动作变得更平稳，把神经质低的帧频录象打扫干净，和拉长或者收缩适于时间间隙的录象。

The water-repellent materials and the technology processes applied for pipe at the joint are brought up,and the reasonable suggestions to decrease the resistance of pipe are put forward.

提出适用于PCCP管道接头间隙的止水材料和工艺方法及合理的减阻措施。

An experimental study of a planar four-bar linkage with a clearance was carried out to measure the relative motion between shaft and bearing.

本文对具有间隙的平面四杆机构进行了实验研究，测量了轴销相对于轴套的运动。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。