间隙

Even when standing with your nose to the screen, it is difficult to discern any sort of inter-pixel gap or screen door effect.

即使你的鼻子到屏幕上的地位，很难看出任何类型间像素间隙或屏幕门的效果。

Reducing the height of trimming cut zone of chain hook screw properly, increasing the final forging temperature, and keeping appropriate clearance between punch and die, using punch with sharp cutting edge can reduce the cutting stress.

适当缩小链钩螺杆锻造时的切边带高度、提高终锻温度、保持凸模与凹模之间适当的间隙、使用锐利刃口凹模都能降低锻造切边应力；降低热处理时的淬火应力，通过回火消除大部分热应力及组织应力，切边带的裂纹便得到有效控制。

According to results from detecting hydrocarbon in lower atmosphere and interstitial water of sea-bottom surface sediment and in combination with regional geology and drilling data,petroleum potential has been predicted in North Yellow Sea basin .

根据低层大气和海底浅表层沉积物间隙水烃类检测结果，结合区域地质及钻井资料，对北黄海盆地含油气远景进行了预测。

And it is systematically investigated about the influence of some parameters variations on the discharge. These parameters are secondary electron emission coefficient, the permittivity and thickness of dielectric layer, the length of gas gap and gas pressure.

对充He的AC PDP单元的多脉冲放电特性进行了模拟研究，并对保护膜的二次电子发射系数、电介质层厚度和相对介电常数以及气体间隙距离与压力等参量对放电特性的影响进行了系统全面而详细地分析讨论。

The design results were beneficial to oil self-sealing.

最后，计算了形成毛细管作用自密封所要达到的轴承间隙和喇叭口张角。

Results: Pigeons exposed to -70°C for 12 min and -90°C for 6 min and 9 min showed slight proliferation of fibrous connective tissue in the perilymphatic space at the site of cryosurgery and presented a selective decrease of the semicircular canal functions.

结果：在-70°C 12 min、-90°C 6 min和9 min显示冷冻处外淋巴间隙纤维组织轻度增生，选择性的半规管功能降低；6例患者经1年4个月至2年5个月随访，5例治疗成功，眩晕消失，1例耳鸣有缓解，4例听力无变化，1例听力下降18 dB。

The signal of ILK andα-SMA were detected mainly in perisinusoidal space of Disse, proliferative portal space,fibrotic septation and cells around hepatic sinusoid near to fibrotic septation.They nearly expressed in the common area.

ILK和α-SMA主要分布在肝窦周间隙，纤维增生的汇管区，纤维间隔及靠近纤维间隔的肝窦周围细胞，两者的表达几乎在共同区域。

Setscrew Type: Two setscrews have a angle of 90 °,this low-cost type features the most conventional attachment.However,the point of setscrew may cause damage to the shaft and may be difficult to remove.

定位螺丝固定：两个定位螺丝间隙 90 °对所固定的轴进行锁紧，是一种传统的固定方式，由于螺丝的前端与轴心接触，可能会造成轴新的损伤或拆卸困难。

Add sharps and fiats to example 33 also; use any larger intervals and any register of the piano.

增加高调在例子33中同样可用；可在任何大的间隙和钢琴的任何音域上弹奏。

Variation of striper force and clearance between punch and die plate with respect to shear plane and die stress were analyzed .

分析了不同压边力和凸凹模间隙对精冲断面质量和模具应力的影响关系。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。