间距

With the assumption of small thickness of lamella and small deformation as well as that both phases are elastoplastic, an elastoplastic constitutive description for the pearlitic colony is obtained based on non-classical theory of plasticity.

在小片层间距和各相材料均为弹塑性的假设下，采用有限元方法分析了垂直于片层方向上的材料响应特性及层厚的影响，并用非经典塑性理论推导了珠光体团的弹塑性本构方程。

The voltage-current relationship has been been modified and re-deduced. The microscopic characteristics of corona discharge are studied using optical emission spectrometry. Corona discharge is used to remove NO_x coupling with TiO_2 photocatalyzer and a kind of MnO_x photocatalyzer, and the removal mechanism is analysised preliminarily.

本论文对针-板式直流电晕放电电极间距进行优化，修正推导伏安关系式，并使用光学发射光谱进行电晕放电微观特性研究；将电晕放电与TiO_2光催化剂以及一种MnO_x催化剂耦合协同作用去除NO_x，并初步分析了去除机理。

X-ray diffraction showed that the hydroxy-chromium oligocations can be used as a stable pillaring agent after aging at 70 ℃ for four days, and a pillared composite with high crystallinity can be obtain...

与原料2H-MoS2相比，柱撑材料的层间距增大，晶粒变小，比表面积增加并且热稳定性提高。对催化苯饱和加氢反应表明，柱撑材料Cr-MoS2的催化活性明显优于未柱撑的2H-MoS2和RaneyNi催化剂，且结晶度较好的柱撑材料更具有较高的催化活性和较好的可重复性。

The results indicate that the pillaring process and crystal growing of anatase can be more easily realized by increasing the acid-base ratio of pillaring agents, raising the pillaring temperature and adding proper quantities of alkali. The calcination of Ti-pillared precursor brings the growth of TiO2 grain, at the same time the layer distance is declined. In order to obtain ideal products, the right pillaring conditions are: the acid-base ratio of pillaring agents of 13, pillaring temperature of 65 ℃ and the volume of alkali (2 mol/L) in pillaring liquid of 6 mL.

结果表明：在一定范围内增大柱撑剂酸碱比、提高柱撑温度以及加入适量碱，有利于插层复合反应的进行和锐钛晶型的生长；柱撑前驱物焙烧后TiO2晶粒长大，同时焙烧引起的脱水导致膨润土层间距的下降；为获得较理想的产物，合适的柱化条件为：柱撑剂酸碱比 n n (HNO3)为13、柱撑温度65 ℃和柱撑液加碱量为(2 mol/L NaOH) 6 mL。

The effects of the crystallization degree, the uniformity of charge distribution, the surrounding hydration cation and the pillaring mode of organic molecule on the interlamellar space of hydrobiotite were finally discussed.

通过X射线衍射与红外光谱进行表征分析，讨论了结晶度、电荷分布均匀性、水合阳离子及不同有机分子柱撑模式对晶层层间距的影响。

METHODS: Puncture with the needle retaining in the cavity of knee of normal adult corpse without effusion or pneumatosis was performed, and 1, 5, 10, 15, 20, 30, 40 mL contrast-medium was injected into the cavity. Coronal section, vertical plane and transect were scanned with T2WI, 4 mm thickness and 1 mm interval by MRI.

对10件无积液、积气、结构正常的成人尸体膝关节腔内穿刺留针，通过穿刺针向关节腔内依次注入1，5，10，15，20，30，40 mL对比剂，分别于每次注射后行冠状面、矢状面、横断面T2WI，厚度4 mm，间距1 mm，MRI扫描。

XRD indicated that the replacement of the terephthalate anion by the polytungstate anion had little effect on the structure.

结果表明，经过同多钨酸根阴离子的交换以后，垂直于水滑石层板方向的平行层板方向的晶格参数值变小，平行层板方向的晶格参数值不变，(003)、(006)、(009)衍射峰处的层间距值比为3：2：1；交换过程没有改变水滑石的结构，水滑石原位生长在γ-Al2O3表面及内孔，比表面积由γ-Al2O3载体的219m2/g增加到247m2/g，孔径分布则由原来的2～11nm变化为3～4nm。

XRD indicated that the replacement of the terephthalate anion by the polytungstate anion had little effect on the structure.

结果表明，经过同多钨酸根阴离子的交换以后，垂直于水滑石层板方向的平行层板方向的晶格参数值变小，平行层板方向的晶格参数值不变，(003)、(006)、(009)衍射峰处的层间距值比为3：2：1；交换过程没有改变水滑石的结构，水滑石原位生长在γ-Al2O3表面及内孔，比表面积由γ-Al2O3载体的219平方公尺/g增加到247平方公尺/g，孔径分布则由原来的2~11nm变化为3~4nm。

The different intercalation behavior of 5,10,15,20-tetrakis(1-methylpyridinium-4-yl)porphine into α-zirconium phosphate and γ-zirconium phosphate was investigated.

比较了水溶性卟啉meso-四(4-N-甲基吡啶基)卟啉对具有不同层间距和结构的层状磷酸锆的插层行为。

Trans-Blot Cells and Systems 170-3825 Trans-Blot Cell With Wire Electrodes and PowerPac HC Power Supply, 100120/220240 V, includes 2 gel holder cassettes, buffer tank, lid with power cables, 4 fiber pads, 1 pack precut blot absorbent filter paper (15 x 20 cm), power supply, power cord, instructions 170-3850 Trans-Blot System With Plate Electrodes and PowerPac HC Power Supply, 100120/220240 V 170-3853 Trans-Blot System With Plate Electrodes, Super Cooling Coil, and PowerPac HC Power Supply, 100120/220240 V, includes 2 gel holder cassettes, buffer tank, lid with power cables, 4 fiber pads, 1 pack precut blot absorbent filter paper (15 x 20 cm), power supply, power cord, instructions 170-3910 Trans-Blot Cell With Wire Electrodes, includes 2 gel holder cassettes, buffer tank, lid with power cables, 4 fiber pads, 1 pack precut blot absorbent filter paper (15 x 20 cm) 170-3939 Trans-Blot Cell With Plate Electrodes and Super Cooling Coil, includes 2 gel holder cassettes, buffer tank, lid with power cables, 4 fiber pads, 1 pack precut blot absorbent filter paper (15 x 20 cm) 170-3946 Trans-Blot Cell With Plate Electrodes, includes 2 gel holder cassettes, buffer tank, lid with power cables, 4 fiber pads, 1 pack precut blot absorbent filter paper (15 x 20 cm) Trans-Blot Cell Accessories 170-3912 Super Cooling Coil, required for all high-intensity transfers 170-3913 Gel Holder Cassette, includes 2 fiber pads 170-3914 Fiber Pads, 15.5 x 20.5 cm, 6 170-3920 Trans-Blot Standard Wire Electrode Card, cathode 170-3921 Trans-Blot Standard Wire Electrode Card, anode 170-3922 Trans-Blot Cell Buffer Tank 170-3923 Trans-Blot Cell Lid With Power Cables 170-3943 Trans-Blot Platinum Anode Plate Electrode 170-3944 Trans-Blot Stainless-Steel Cathode Plate Electrode 170-3945 Trans-Blot Plate Electrode Pair, platinum anode and stainless-steel cathode 16 规格:说明: Trans-Blot Plus

电泳转印槽组件 1。缓冲液槽及带有电缆的盖 2。凝胶支架转印夹 3。纤维衬垫 4。电极丝 5。电极板 6。特级冷却芯 Trans-Blot 转印槽是功能灵活的转印设备，可理想地用于多种转印应用。Trans-Blot 转印槽特点包括：*能进行多胶转印，可容纳3 块PROTEAN I xi 凝胶、6块Criterion 凝胶、12块Mini-PROTEAN 3 或Ready Gel 预制胶*多组参数灵活可设，可调节的电压设置（从30 V 的过夜转印到200 V 的1 小时快速实验）*电极间距设置为8 cm 用于标准印迹杂交，或设置为4cm 用于高强度印迹杂交*可选择板式电极：涂有铂金的钛作为正极，不锈钢为负极，能提供高强度电场和比其它电极更高的电流密度。或选择较经济的铂金电极丝*通过特级冷却芯和水循环仪来调节温度―是天然酶（4°C）或高强度转印的理想选择，随着转印时间增加（多达24 小时），不会引起缓冲液耗竭（在高强度转印中必须使用冷却芯，也推荐用于所有板式电极的应用）*带铰链的凝胶支架转印夹能避免滑动，确保凝胶与印迹膜间的紧密接触；每个转印夹都有颜色标记以保证在转印槽中的正确定位 Trans-Blot 转印槽的锁闭凝胶支架转印夹系统。转印夹（1）支撑凝胶（2）印迹膜（3）两侧有纤维衬垫和滤纸（4）确保凝胶三明治内的完全接触。凝胶夹垂直插入缓冲液槽中（5）。

For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether

年美国个人破产法的一个改动使得破产登记急速下降，而后引起了信用卡大规模的亏损。

Eph. 4:23 And that you be renewed in the spirit of your mind

弗四23 而在你们心思的灵里得以更新