间层

Tween flat seat bucket shop to make a single copy 4, the first meeting between the shop floor as a shop for five pairs of copy, and the 45-degree oblique China and the remaining layers make up between the Big Dipper as a single copy shop to make four, double only Chinese the third, five, seven, nine, eleven, thirteen addition to China, but also a 45-degree slope.

平座补间斗为单抄四铺作，第一层补间铺作为双抄五铺作，且为45度斜华，其余各层补间斗为单抄四铺作，双层只用华，第三、五、七、九、十一、十三层除华外，还出45度斜。

NGFR positive nerve fibres were markedly reduced or absent in muscular layer and submucous layer while the hypertrophic nerve trunks in myenteric and submucosal plexuses showed a sheath of intense staining in the aganglionic colon from patients with HD.

结果 丰富的NGFR染色阳性神经纤维分布于正常结肠环肌层及粘膜下层，少量分布于纵肌层，NGFR染色阳性神经元分布于肌间神经丛及粘膜下神经丛；NGFR 染色阳性神经纤维在HD无肌间神经节细胞肠段肌层及粘膜下层内明显减少或缺如，而肌间肥大的神经干及粘膜下神经干为NGFR染色阳性，并且在其外周可见一强阳性染色带。

FT-IR spectra shows that the polyaniline is present primarily in the emeraldine salt form, and the polymeric chains interact with inorganic framework, most likely via V=O…HN hydrogen bonding. XRD,TG and DSC indicate that the lamellar structure of the V_2O_5 is preserved, PAn chains eliminate water form the interlamellar region and are partially inserted between the layers, and exist with extended-chain conformation owing to the confined environment.Electrochemical investigation in the range of 1.8~3.8V vs.

红外光谱表明复合物中PAn主要以导电聚苯胺盐的形式存在，PAn链与V_2O_5晶格之间可能形成了V=O…HN氢键。X射线衍射、热重和差示扫描量热证实了PAn/V_2O_5复合物保持了较规整的层间排列结构，PAn取代了V_2O_5干凝胶中的层间水而部分嵌入其片层间，由于受空间的限制，PAn分子链以比较伸展的链构象存在。

The results show that, Au-19.25Ag-12.80Ge brazing alloy is better, its melting temperature range is 446.76494.40 ℃, and the temperature interval between the solidus and the liquidus is 47.64 ℃. When the brazing temperature is in the range of 510550 ℃, the alloy has a good spreadability and wettability with Ni. Interface structure observation reveals that there is one continuous intermetallic layer between the brazing alloy and the base metal Ni when welding. X-ray energy spectrum analysis results show that the intermetallic layer is Ge3Ni5, and because of its brittleness, the overthick intermetallic layer will decrease the shear strength of the welding joint, therefore, the welding technology should be controlled so as to gain an ideal welding interface structure.

研究结果表明：Au-19.25Ag-12.80Ge合金的性能较好，其熔化温度范围为446.76~494.40 ℃，结晶温度区间为47.64 ℃；焊接温度在510~550 ℃范围内时，Au-19.25Ag-12.80Ge钎料合金与Ni基体具有良好的铺展性和润湿性，焊接时钎料合金与Ni基体之间形成了一条连续的金属间化合物层，能谱分析表明该金属间化合物层为Ge3Ni5，由于该化合物较脆，过厚的金属间化合物层使焊接接头的剪切强度下降，故应适当控制焊接工艺以获得理想的焊接界面组织。

Fiber enlaced composite materials is widely used in engineering project .

纤维缠绕复合材料壳体在工程实际中得到广泛应用，其壳体力学性能相当复杂，本文在分析复合材料壳体层间应力的影响时，提出了复合材料壳体层间应力随纤维方向的改变有较大的不同，不仅分布形式不同，其最大层间剪应力所在的界面也各不相同。

Because of the method of Hamilton semi-analysis solution of the thermo-elastic problem of composite laminates has not any assumptions in the direction of thickness, the continuous conditions of the interlaminated stress and deformation are content. The interlaminated stress and the deformation of the laminates can be obtained through solve the state equations by analysis.

由于复合材料层合板热弹性问题的Hamilton半解析法，在板厚度方向不引入任何假定，保证了层合板层间应力和位移的连续性，通过对状态方程解析求解得到层合板的层间应力和位移。

The integrated framework of the whole system turns into three layers of structure: The first layer is integration among the subsystems, for example guard against theft and report to the police with the integration among CCTV, set up OPC server on the basis of first floor of integration, form second layers of integration, OPC server goes to the administrative center of information to integrate as the third floor.

整个系统的集成构架变成三层结构：第一层是子系统间的集成，比如防盗报警与CCTV间的集成，在第一层集成的基础上设置OPC服务器，形成第二层的集成，OPC服务器到信息管理中心作为第三层集成。

It was pointed out that the calculation formula for stress of laminated beam without pin joint in interlayer under bending experiment from relevant literature is wrong, and the calculation formulas for bending stress of laminated beam with or without pin joint in interlayer were rederived.

指出了有关文献推导出的上下梁层间无销钉连接叠层梁弯曲应力计算公式是错误的，重新推导出了上下梁层间无销钉连接与有销钉连接的叠层梁弯曲应力计算公式，对学生正确理解和认识叠层梁弯曲实验有理论指导意义。

If the slope＇s rockmass is low counter-inclined or thick-interbedded with soft interlayer, its failure model is inclined to be tilting-collapsing; if the slope＇s rockmass is homogeneous and thin-bedded with hard discontinuity, its failure model is inclined to be splitting-collapsing; if the slope＇s rockmass is low sequence-inclined with densely deep tectonic joints and weathering fissures, its failure model is inclined to be sliding-collapsing.

当缓倾内层状岩质边坡的岩层较厚，岩性呈软硬互层状产出，或岩层间软弱夹层较厚时，常发生倾倒-崩落式破坏；当缓倾内层状岩质边坡的岩层较薄，且岩性较均一，或层间结构面力学性质较好时，常发生拉裂-崩落式破坏；当缓倾角层状岩质边坡岩层倾向坡外时，在陡倾构造节理和风化卸荷裂隙切割下，常发生滑移-崩落式破坏。

Self-fluxing Fe-Cr-Ni-B-Si alloy prowders are laser clad on medium carbon steel substrate of dimensions 80×35×10mm〓. The investigation results of this clad layer are: micro-defects, micro-cavity and occluded forin substance, are the micro-cracks and crack resourses in clad layer; crack of coating propagates along the boundary of two kinds of eutectic sutructure; The included angle θ between the cracking direction and laser scanning direction in multitrack overlapping clad is smaller than that in one-track clad because of crack propagating along crystalline growth direction and crystalline direction in overlapping zone being different from it in one-track clad.

在调质态的45〓钢表面，采用预置粉末法进行FeCrNiBSi合金的多道搭接激光熔覆，对其熔覆层进行分析表明：多道搭接激光熔覆层裂纹扩展方向与激光扫描方向间的夹角θ与单道熔覆时相比明显变小，前者θ0°，后者θ角基本都为90°，这主要是因为多道搭接时，搭接区结晶方向发生了变化以及裂纹沿结晶方向扩展所致；激光熔覆层裂纹大多是以覆层与基材交界面的孔洞、熔覆层内不同方向共晶团间的显微缩孔、夹杂物的边界等三种显微缺陷作为裂纹源，并沿低熔点物相形成元素偏析造成弱化膜的共晶团界面扩展延伸。

They weren't aggressive, but I yelled and threw a rock in their direction to get them off the trail and away from me, just in case.

他们没有侵略性，但我大喊，并在他们的方向扔石头让他们过的线索，远离我，以防万一。

In slot 2 in your bag put wrapping paper, quantity does not matter in this case.

在你的书包里槽2把包装纸、数量无关紧要。