长寿命

As a result of extensive tests conducted by Velan between 1966 and 1972, a new technology emerged at the time for high performance, leakproof, long life, and low maintenance stem seals for nuclear power, now available for all industries and applications.

Velan在1966年和1972年之间进行了大量的测试，结果产生了当时适用于核电的高性能、防泄漏、长寿命、阀杆密封低维护最新的技术，现在这些技术已应用在所有行业和领域。

This kind of observational plan requires long life-time of the whole system and high reliability.

这种观测任务需要整个系统具有长寿命和极高的可靠性。

The resultant LiMn 2O 4 synthesized under the optimum synthesis conditions has perfect spinel structure and is an excellent ca...

在最佳合成条件下，即Li／Mn＝1／2及温度800℃，制备的LiMn2O4具有完美的尖晶石结构及良好的电化学性能，完全可以用于高比能长寿命的锂离子蓄电池。

The breed is long-lived, and has been recorded to live as long as 34 years.

品种是长寿命，并已录得的生活，只要34年。

This research provides a possibility for the development of new luminescence composites with high- efficiency and long-lifetime.

以上复合技术为研究和开发具有高效、长寿命的复合发光材料提供了新的可能。

The experiment study about the subcritical normalizing holding temperature effects the macrostructure and hardness of the 40SiMnCrNiMoA steel shows: When subcritical normalizing holding temperature is 760℃, the ferrite in the mixture phase structure is lumpish, the hardness of the steel is low (about HRC32), and when the holding temperature is over 800℃, the hardness of the steel is about HRC49, the ferrite in the mixture phase structure is in old critical range austenite grain boundaries, it is disadvantage for the steel strengthening. When the holding temperature is 780℃, the mixture phase structure is mixture phase structure including the strip ferrite、martensite and bainite, the ferrite is less than 20%wt, its grains are fine and even, the hardness of the steel is about HRC38, it is in the range of HRC35-40 which is the long-life drill rod needed.

亚温正火温度对40SiMnCrNiMoA的组织和硬度等性能的影响的实验研究表明，当亚温正火保温温度为760℃时，复合组织中的铁素体形态是块状，处理后的材料硬度相对较低（HRC32左右）；而当采用大于800℃温度亚温正火处理，材料硬度为HRC49左右，组织中铁素体大部分较连续地存在于原奥氏体的晶界，对材料强化不利；当40SiMnCrNiMoA钢780℃亚温正火后，硬度为HRC38左右，在以往小钎杆较长寿命所需硬度范围HRC35-40内，而组织为细条状铁素体+以板条马氏体和条状无碳贝氏体为主的复合组织，晶粒细小均匀，铁素体体积含量少于20％。

The CDAS realtime telemetry and attitude determination system of meteorological satellite FY2 is a system of multifunction long life time and high reliability ,based on multiprocessor concurrent processing and multilevel faulttolerant architecture.It implements integrally realtime processing of analog telemetry including demodulation of accurate sun pulse,realtime determination of satellite's attitude,coding telemetry demodulation and realtime data processing,satelliteground loop simulation test,a...

介绍了风云二号卫星指令与数据获取站实时遥测定姿系统，该系统是一个采用多级容错、多处理器并发运行体系结构，统一实现包括精太阳脉冲解调在内的模拟遥测信号实时处理、卫星姿态实时确定、编码遥测信号解调和数据实时处理、卫星星－地回路仿真测试及系统大容量数据、图形、字符实时处理、通信、记录等多功能、长寿命、高可靠实时遥测定姿系统。

Since 1980s, ICP-MS has been used overseas for the determination of uranium, thorium, neptunium, and plutonium in environmental samples. ICP-MS is one of the most suitable analysis techniques for the measurement of the long-lived radionuclides.

自八十年代以来，国外对ICP-MS测量环境样品中的铀、钍、镎和钚的研究表明，ICP-MS在测量长寿命放射性核素方面是最有发展前景的测量技术之一。

By analyzing radionuclides such as uranium, neptunium and plutonium in environmental samples, which were collected in the immediate environment of a nuclear process or nuclear site, researchers can detect evidence of the corresponding nuclear activities.

随着核能的开发应用，为评价放射性废物对环境的影响及确定放射性废物安全处置方案，长寿命放射性核素的环境行为越来越受到各国环境科学工作者的关注。

Conventional radiochemical methods such as alpha spectrometry, neutron activation analysis, liquid scintillation system, fission track and gamma spectrometry for the quantitative determination of neptunium and plutonium often require complicated and time-consuming sample preparation and separation procedures.

研究环境中铀、镎、钚等长寿命放射性核素的精密测定，对保护公众安全和保护环境，对了解核设施的历史操作情况和现状，都具有重要意义。环境样品基体复杂，铀、镎和钚等锕系元素含量非常低，在复杂的生态条件下，这些核素常常具有复杂多变的化学形态，要准确测定其含量，必须要有灵敏可靠的检测方法。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐