镍铁

We mainly seek for the mine suppliers to purchase: chromium ore, manganese ore, nickel ore, iron ore, cobalt, and americium ore, while also looking for chemical, crude oil, pesticides, the hard tungsten gold, soft tungsten gold, ferrochrome, ferromanganese, ferrocobalt, Ferrotitanium ferronickel, electrolytic copper zinc spindle as well as other products exporters as a long-term cooperative partnership.

公司主要寻找矿主供货商求购：铬矿、锰矿、镍矿、铁矿、钴矿、镅矿，同时还寻找各类化学化工、石脑油、农药等产品和不锈钢、硬钨金、软钨金，铬铁、锰铁、钴铁、钛铁、镍铁、电解铜、锌锭以及其它产品方面的出口商来作为本公司的长期合作伙伴。

Technology for upgrading ferronickel and the possible separation of nickel and cobalt from ferronickel are also discussed.

介绍了生产超纯镍铁以及多种镍铁基合金的试验数据，同时也讨论了镍铁提纯工艺以及从镍铁中分离铜、钴的可能性。

Based on the content of ferronickel in the ore, it can be divided into High-Ni/ Low-Fe and High-Fe/ Low-Ni varieties which is mainly located in the Philippines, Indonesia and New Caledonia of South Pacific.

根据矿石中镍铁的含量多少分为高镍低铁和高铁低镍矿脉，主要分布在菲律宾、印度尼西亚和南太平洋的新喀里多尼亚岛。

In this study, we investigate the effect of post-annealing on magnetization damping in sputtering deposited NiFe thin films. The film thickness is ranged from 10 nm to 100 nm. Thin films were deposited at room temperature and a subsequent post-annealing was performed in vacuum better than 10-6 torr from room temperature to 700 0C for 30 minutes.

中文摘要本研究中，我们使用改变后退火效应来观察溅镀制程镍铁薄膜(Ni84Fe16)系列的磁性阻尼行为，溅镀薄膜厚度范围为10 nm ~ 100 nm，而镍铁薄膜后退火过程在真空度约10-7 torr中进行，达到标的温度(范围由室温至700 ℃)后定温30分钟，自然冷却取出。

The process of three-step countercurrentleaching is presented, in the first leaching step Fe as leading impurity inthe matte is leached priorly, Co and Ni are enriched in the residue of thefirst step and then are leached in the second leaching step with a lowconcentration acid, the residue from the second step containing hardleaching Fe, Co and Ni are leached with a high concentration sulfuricacid in the third step, and Cu stays in the final resude, the leachate of thethird leaching step is diluted and divided into two parts as the leachantsto the first and second leaching step.

在此基础上，提出了三段逆流选择性浸出技术：即第一段用低酸优先浸出钴冰铜中杂质铁，将钴镍富集到第一段的浸出渣中，第二段再用低酸浸出渣中部分钴镍，第三段用高酸浸出第二段渣中难浸的钴镍铁，将铜留在最终的浸出渣中，第三段浸出液经稀释，分流，分别返回至第一段，第二段作低酸浸出介质。

In the course of selecting oxide additives material in the nickel-ferric spinel based inert anode, both the solubility in the cryolite molted salt of oxide additives and the whole thermodynamics action in electrolyte of oxide additives are discussed in this article, thus to have a comparatively reasonable selection of the nickel-ferric spinel based inert anode material.

在选择镍铁尖晶石基惰性阳极材料氧化物添加剂过程中，不仅探讨了氧化物添加剂在冰晶石熔盐中的溶解度，而且还探讨了氧化物添加剂在电解液中的整个热力学行为，从而对镍铁尖晶石基惰性阳极材料做出了较为合理的选择。

Our export products include MC/LC FeCr, HC FeCr, SiCr, HC FeMn, MC/LC FeMn, SiMn, LC SiMn, FeW, FeMo, FeNi, nitride chrome, nitride manganese, nitride silicon and compound alloys, directly supplying to famous international iron and steel enterprises, covering over 30 countries and areas with a worldwide reputation.

公司出口产品包括中低微碳铬铁、高碳铬铁、硅铬合金、高碳锰铁、中低微碳纯净锰铁、普通硅锰、低磷低碳硅锰、钨铁、钼铁、镍铁、氮化系列铬、锰、硅合金及复合合金等，直接供应全球知名钢铁企业，产品覆盖世界30多个国家和地区，在国际市场上享誉盛名。

Our grab nickel production, nickel is mainly used to crawl,铁精粉, red clay minerals such as highly viscous due to the recent nickel 铁精粉, red clay and other minerals to be widely used, so Many major ports on the existence of such a problem, in which the ore handling when loading and unloading there is a low efficiency, has been a lot of ore grab adhesive wall, our company in order to solve this dilemma has been studied and produced by such a professional crawl very sticky ore grab, the principle is: grab the next 承梁 calculated to increase the adoption of two pieces of solder, including the specific location of board and grab the bucket to create a circular flap, so Open grab discharging, the fight is on board, including the body wall from the top down (no contact with body panels Doo), to stick the body in fighting the viscous wall down, including mine, so, which greatly improved the handling grab the efficiency of ports and factories to solve the problem, which is purpuratus grab a patent, other manufacturers can not be produced.

我公司生产的镍矿抓斗，主要用来抓取镍矿、铁精粉、红粘土等粘性很强的矿石，由于近来镍矿、铁精粉、红粘土等矿石在被人们广泛使用，因此，许多大港口就存在着这样一个问题，在装卸这此矿石的时候，存在着装卸效率低，抓斗内壁被很多矿石粘着，我公司为了解决这一难题，现已研究并生产出来这种专业抓取很粘的矿石抓斗，原理是：在抓斗的下承梁上通过计算得出要加焊俩块括板的具体位置，并要把抓斗的斗瓣做成圆形，这样在抓斗打开卸料时，括板就在斗体内壁从上而下，把粘在斗体内壁的粘矿括了下来，所以，这就大大提高了抓斗的装卸效率，为港口和工厂解决了这一难题，这种抓斗是紫石的一项专利，其它厂家是无法生产出来的。

Our grab nickel production, nickel is mainly used to crawl,铁精粉, red clay minerals such as highly viscous due to the recent nickel 铁精粉, red clay and other minerals to be widely used, so Many major ports on the existence of such a problem, in which the ore handling when loading and unloading there is a low efficiency, has been a lot of ore grab adhesive wall, our company in order to solve this dilemma has been studied and produced by such a professional crawl very sticky ore grab, the principle is: grab the next 承梁 calculated to increase the adoption of two pieces of solder, including the specific location of board and grab the bucket to create a circular flap, so Open grab discharging, the fight is on board, including the body wall from the top down (no contact with body panels Doo), to stick the body in fighting the viscous wall down, including mine, so, which greatly improved the handling grab the efficiency of ports and factories to solve the problem, which is purpuratus grab a patent, other manufacturers can not be produced.

普通会员不能显示联方式，只能给他留言我公司生产的镍矿抓斗，主要用来抓取镍矿、铁精粉、红粘土等粘性很强的矿石，由于近来镍矿、铁精粉、红粘土等矿石在被人们广泛使用，因此，许多大港口就存在着这样一个问题，在装卸这此矿石的时候，存在着装卸效率低，抓斗内壁被很多矿石粘着，我公司为了解决这一难题，现已研究并生产出来这种专业抓取很粘的矿石抓斗，原理是：在抓斗的下承梁上通过计算得出要加焊俩块括板的具体位置，并要把抓斗的斗瓣做成圆形，这样在抓斗打开卸料时，括板就在斗体内壁从上而下，把粘在斗体内壁的粘矿括了下来，所以，这就大大提高了抓斗的装卸效率，为港口和工厂解决了这一难题，这种抓斗是紫石的一项专利，其它厂家是无法生产出来的。

In this paper, the processes of electroless Ni-P, Ni-Fe-Co-P and Ni-Co-B platingwere investigated by using graphite pieces as samples first, and then Ni-P, Ni-Fe-Co-Pand Ni-Co-B coatings were deposited onto carbon nanofibers by using the selectedelectroless processes. The composition, structure of the coatings and the properties ofthe metal-coated carbon nanofibers were also studied.

本文首先利用石墨基片研究了化学镀镍磷合金、镍铁钴磷合金和镍钴硼合金工艺，然后利用优化的化学镀工艺在纳米碳纤维表面镀覆了Ni-P、Ni-Fe-Co-P和Ni-Co-B镀层；研究了镀层的成分、结构以及镀层纳米碳纤维的性能。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。