镊子

The doctor can see the tumor through the thoracoscope and can use special forceps to take a tissue biopsy.

医生通过它可看到肿瘤组织并用非凡的镊子取组织活检。

Holding our breath, one of our conservators used tweezers and began unrolling, and another applied more moisture, without saturating it.

我们屏住呼吸，其中一位管理员开始用镊子把它们解开，另一位就把它弄得更潮湿，但没有把它浸透。

Take along a butterfly net to catch flying insects and tweezers to pick up bug s.

用一张捉蝴蝶的网就可捉住飞虫，然后用镊子把它们取下来。

Black, when pulling, the use of tools such as tweezers must be strictly sterilized, or else will be more dirt into the pores, but not worth the candle.

拔黑头时，所使用的镊子等工具一定要严格消毒，否则会将更多的污垢带入毛孔，反而得不偿失。

The nurse took some tweezers and pulled out the splinter as clean as a whistle .

护士拿着几把镊子，非常利索地把碎片镊了出来。

The nurse took some tweezers and pulled out the splinter as clean as a whistle.

护士拿著几把镊子，非常利索地把碎片镊了出来。

During the using study of handle of forceps and pancake turner this paper discovers that handle"s crooking is an important factor which affects product"s ergonomical performance and is helpful to improve the product"s usability, and that crooked angle of handle exists an optimum value, but the best crooked angle of handle of different product is different, if the optimum value is found the product"s using study should be done.

本文从镊子柄和锅铲柄的使用性研究中发现：手柄弯曲是影响产品人机工程学性能的一个重要因素，它对提高产品的可用性有着很重要的意义；手柄的弯曲还存在一个最佳角度。但是不同产品手柄的最佳弯曲角度是不相同的，倘若要获得某产品手柄的最佳弯曲角度，还必须进行该产品的使用性研究。

Ticks can also be removed from turtles with tweezers, rubbing alcohol, and dabs of petroleum jelly.

扁虱同样可以用镊子清除，此外还可以使用医用酒精或是少许凡士林。

Mr. Finnegan used tongs to take the cooked spuds out of the crevices then handed them to the children.

Finnegan先生用镊子去把煮熟的蕃薯从缝隙夹出来，然后把它们拿给孩子们。

But Rachel—as Simon often cursed to himself—with her sour face and terrible, tweezing fingers, was near enough.

但是，就象Simon总是在诅咒着，有了Rachel那张坏脾气的脸，和她那可怕的象镊子一样的手指，对Simon来说也就足够了。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。