镀

It is characterized by anodic without a cotton package to store plating fiuid, plating anodes and the workpiece maintaining a certain space, and plating fluid circularly pumped to flow plating working area.

本文研究了电刷镀流镀的阳极材料，设计了流镀界面，并通过正交试验优化了流镀工艺参数，进行了产业化应用。

A new method for evaluating powdering rating of galvanneal coatings was studied based on computer techniques of image processing and pattern recognition theory,and a system of the powdering recognition and rating on the galvanneal coating had been designed.

针对传统人工进行合金化镀锌板镀层粉化级别评定的不足，提出基于计算机视觉的镀层粉化评价方法，自行开发了镀层识别与评级系统。

To improve the product quality and production efficiency and reduce the production costs, the pyrophosphate rolling copperplating process has been developed, the impact of the composition of plating liquid and process conditions on the performance of the plating layer has been studied and plating liquid formation and process conditions have been determined.

为提高产品质量和生产效率，降低生产成本，研究开发了焦磷酸盐滚镀铜生产工艺，研究了镀液的组成及工艺条件对镀层性能的影响，确定了镀液配方及工艺务件。

The results showed that,in case of Cr 3+ concentration were too low,the deepening plating ability of the plating solution were bad,and the plating layer with not good shininess and poor cleanliness.

随着Cr3 +浓度升高，镀液分散能力和电流效率降低，光亮区电流强度范围减小，而镀液深镀能力、镀层硬度及耐磨性随Cr3 +的浓度升高而出现极

In order to further increase the brightness of electroless silver plating and improve the performance of bath, the influence of a, a'-Bipyridyl and sodium thiosulfate on the face of coating was studied by Hull Trough test, surface morphology of coating with basic formula and optimizing formula was observed by metalloscope.

为了进一步提高烟酸镀银的光亮性，改善镀液的性能，通过赫尔槽试验研究了2，2-联吡啶与硫代硫酸钠对镀层外观的影响，并用金相显微镜观察基础配方和优化配方的镀层的表面形貌。

A model of calculating the effective aluminum content in zinc bath was proposed by using Sublattice Model on the basis of thermodynamic analysis.

热镀锌工艺包括连续镀锌和一般镀锌两种[1] 。在连续镀锌过程中，为了提高镀件的使用性能，往往在锌浴中添加一些合金元素，如Al、Ni、RE、Mg等。

The result indicate that: the electrodeposition of zinc on nickel and tungsten substrates involves instantaneous three-dimensional nucleation. The coating is the best when the current density is 4mA/cm2 and the temperature is 80 ℃. The coating by the method of the impulse electrodeposition is better than the direct current electrodeposition. Especially when f is 100Hz, ton/toff is 2/8 and J is 8mA/cm2, the coating is clean and uniformity. The crystal size is nearly 0.3μ m .

结果表明：阴极反应为准可逆反应，锌离子在镍电极和钨电极上形核是三维瞬时形核半球形扩散长大过程，直流电流密度为4mA/cm2，温度为80 ℃时，镀层质量最好；脉冲电沉积得到的镀层要优于直流电沉积得到的镀层，尤其在脉冲宽度为2ms，脉冲间隔为8ms，电流密度为8mA/cm2时，得到的镀层光滑而均匀，颗粒大小接近0.3μm。

Based on practice,the author of this essay comes up with his own opinions about electroplating and reworking of unqualified zinc alloy products,and offers some experience on un-plating chemically and electrochemically.

本文在实践的基础上对锌合金工件不合格镀层返镀和修复提出了自己的看法，提供了化学退镀和电解退镀等方面的修复经验。

In this paper, the electroplating of bright Zn-Ni alloy process was studied, the effect of (1-hydroxy ethylidene diphosphonate acid coordinating agent, chloride content, [Zn2+]/[Ni2+] mole ratio, cathode current density, temperature, a class of aldehyde compound (abbreviated as ZNP additive agent) and supplementary coordinating agent on Ni content, and brightness of plating layer was discussed, the physical phase of alloy plating layer and stability of plating solution were determined.

研究了用有机多膦酸盐作络合剂，ZNP作添加剂电镀光亮锌镍合金，探讨了络合剂、氯化物含量、[Zn2+]/[Ni2+]比、阳极电流密度、温度、辅助络合剂对合金中镍含量的影响，测定了合金镀层中物相组成及镀液稳定性，通过筛选得出最佳最镀光亮锌镍合金的镀液组成及工艺条件，并讨论了锌镍合金的异常共沉积机理。

Ni-Fe alloy coatings with varied ferrum concentration were prepared by brush plating using soluble anode.

采用可溶性阳极电刷镀技术制备镍铁合金镀层，研究了合金元素Fe在刷镀层中的作用机理，分析了镀层的组织结构和性能。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了