键槽

Author of this text study ordinary lathe transform keyway mill head post improvement scheme of part on the milling machine.

摘要本文作者研究了普通机床改造成键槽铣床时铣头立柱部件的改进方案。

Is the keyway in only one of the Upper Holes?

是否顶部圆柱孔只有一个键槽？

The key is a segment of a disk and fits in a keyway in the shaft that is cut with a special milling cutter.

关键是一个磁盘部分，并在与一个特殊的铣刀轴键槽切割适合。

Consult related standards before dimensioning standard structures of an individual part, such as the keyway or thread.

零件上的标准结构，如：键槽、螺纹等，应查表后再标注

The latter is keyed to the feed rod and travels with the apron along the feed rod, which has a keyway extending to cover its whole length.

后者是挂钩的饲料棒与棒沿着停机坪的饲料，其中有键槽扩展至涵盖其整个长度的旅行。

But for beginners, I recommend this technique for emergency openings: Peer down the keyway and locate the side groove of any of the tumblers using a pick as a searching tool.

但对于初学者，我建议紧急挖掘这一技术：同伴下来键槽和定位的方沟任何的玻璃杯用一个接一个寻工具。

Check for proper fit between key and keyway.

键和键槽之间的配制要适当，不可硬行插入，否则会损坏减速机。

If pulley keyway length is less than this length, rework long key by removing one-half of excess length between pulley and end of key to maintain balance.

如果皮带轮的键槽长度小于该长度，则单端去掉皮带轮和键端之间的多余长度，以此保持平衡。

Pointing to the accuracy requirement of the keyway on shifts,this paper presents a special jig and a cutter positioning method.

针对轴类零件键槽精度的要求，介绍了一种专用夹具及对刀方

Because of precision requirements,it is quite difficult to guarantee processing quality by slotting or broach.

在采煤机零件加工中，常常遇到深内孔长键槽的加工，由于精度的要求，用插削的方法很难保证加工质量，用拉削方法又不适宜。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了