锥形的

Transfer 50 ml of this solution to 200-ml Erlenmeyer flask, or, if smaller aliquot is taken, dilute to about 50 ml with water. Add 10 ml 4 N H2SO4, 1 ml KI,1 drop ammonium molybdate solution, and 50 ml water. With continuous agitation, add excess of 0.00359 N Na2S2O3 (5 10 ml).

移取50毫升上述溶液于200毫升于锥形瓶中，如果取样量较少，用水稀释到50 毫升，加入10 ml 4 N H2SO4，1 ml KI， 1滴钼酸胺溶液和50毫升水，边搅拌边加入过量的0.00359 N Na2S2O3溶液(5 10 ml)。

The pendant is secured to a tapered single bale and presented on an 18-inch sterling silver box chain with a spring ring closure.

该挂件是固定在一个锥形单捆和一个18英寸的纯银弹簧圈封闭框链提出。

Such observation resulted from the special shape of the conical column, in which the composition of forces near the conical column wall was different from that near the cylindrical column wall owing to the existence of the inclined plane.

这是由台锥形柱特殊的结构造成的。由于台锥形柱斜面的存在使流体在管壁区的受力情况不同于圆柱的管壁区

Such observation resulted from the special shape of the conical column, in which the composition of forces near the conical column wall was different from that near the cylindrical column wall owing to the existence of the incline d plane.

这是由台锥形柱特殊的结构造成的。由于台锥形柱斜面的存在使流体在管壁区的受力情况不同于圆柱的管壁区

The utility mode comprises a float chamber(1),a float(2), a meter tube(3), a spacing ring(4), a collar(5), and a guiding ring(6), the float(2) is arranged inside the spacing ring(4), the meter tube (3) is a conical tube, the core-and float flowmeter(3) is a guiding cylinder with different diameters, the guiding cylinder matches for the inner wall of the meter tube.

包括浮子室(1)，浮子(2)，测量管(3)，限位环(4)，挡圈(5)，导向环(6)，所述的浮子(2)的上端置于限位环(4)内，所述的测量管(3)为锥形管，所述的浮子(2)为直径不等的导向圆柱体，该导向圆柱体与所述的测量管(3)的锥形内壁配合。

The utility model characterized in that the syringe's (2) inner wall, the parts at the back end of the syringe's (2) jaw opening, is a subuliform ring blocked, and the handspike's (4) outer wall, the parts close to the back end of the handspike(4), is heaved to the inside with more than two pieces of wing panels matching to the subuliform block ring.

本实用新型提供了一种一次性注射器，由针头（1）、针筒（2）、活塞（3）、推杆（4）组成，针筒（2）前端的乳头上套装连接着针头（1），推杆（4）前端连有活塞（3），其特征在于针筒（2）后端开口处的内壁上设有锥形挡环（5），在靠近推杆（4）后端处的推杆（4）外壁上设有与锥形挡环（5）相配合的向针筒（2）内壁凸起伸出的两支以上的翼片（6）。

An algorithm of edge detection combined with morphological filter is proposed, firstly, it adopts adaptive method to decide the wimble structuring element and applies iterative morphological filter based on two wimble structure elements to filter the image, then uses multi-scale morphological edge detector to get multi-scale edges, and obtains the more ideal image edges under the environment of existing noise by integrating the edges of various sizes.

文中提出了一种结合形态学滤波的边缘检测算法，该算法采用自适应方法确定锥形结构元素，然后利用双锥形结构元素对图像进行形态学迭代滤波，对滤波后的图像进行多尺度形态学边缘检测，并将各尺度下边缘检测的结果进行合成，最终得到在噪声存在条件下较为理想的图像边缘，并且与其它边缘检测算法进行了对比实验，实验验证了该算法的可行性和有效性。

Flat and coned washers pre-assembled or loose, should be tested on a fixture having an oversize clearance hole so that a high tensile stress is induced to the washer.

组合螺栓和组合螺母上的平垫圈或锥形垫圈，或非组合件用的平垫圈或锥形垫圈，应在具有较大孔径的通孔的夹具上进行试验，从而使垫圈承受较大的拉伸应力。

The morphologies of the CdZnTe etch pits developed by four etchants including Nakagawa, Everson, EAg1 and EAg2 solutions are studied. The results show that the etch pits of EAg2 etchant on the (111) B surface are flat-bottomed. And the etch pits of Everson etchant on (111) B include flat-bottomed pits and pyramidal pits with different slant directions, while the positions of pyramidal pits don′t move as the surface layer is continuously removed.

对碲锌镉晶体常用的Nakagawa、Everson、EAg1和EAg2四种腐蚀剂在碲锌镉材料（111）晶面上的腐蚀坑坑形进行了研究，结果发现，EAg2腐蚀剂在（111）B面上的腐蚀坑为平底坑，Everson腐蚀剂在(111)B面上产生的腐蚀坑包括平底坑和带有不同倾斜方向坑底的三角锥形坑，进一步的研究还表明，三角锥形坑并未沿着坑底的倾斜方向向下延伸。

The sightline control strategy for bad measure precision is developed, and the control methods for vertical direction, approach direction and station keeping are presented.(2)The safe approach velocities are investigated for cuboid, sphere and cone keep out zone.(3)The design method for optimal trajectory under safety constraint is developed. The cone and cuboid keep out zone can be described using line constraint, and then optimal trajectory design can be translated to line programming problem under line constraint.(4) The design strategy of collision avoidance maneuver is discussed, and the collision avoidance scheme is analyzed for V-bar and R-bar approach.The control and trajectory safety in departure phase are investigated.

1提出了测量误差较大时平移靠拢段的视线控制策略，给出了横向、纵向和悬停的控制方法；(2)针对长方体禁区、球形禁区和锥形禁区三种禁区形式，研究了V-bar逼近和任意方向逼近的纵向安全速度计算问题；(3)提出了安全约束下的最优轨迹设计方法，将冲量和有限推力作用下的最优轨迹设计问题转化为线性规划问题，并给出了将锥形和方形安全区域约束转化为标准线性约束的公式；(4)探讨了紧急避撞机动的设计策略，分析了V-bar和R-bar接近的紧急避撞机动方案。

By using competitive adsorption of activated carbom to remove unfavorable influence of carbon in carbonaceous gold concentrate on leaching process, the leaching rate of gold concentrate can be improved to 88% as compared with 10%by direct cyanidation.

本文论述了利用活性炭竞争吸附作用，消除含炭金精矿中炭在浸出过程中的影响，使金精矿的浸出率可由直接氰化的10％提高到88％。

The only thing you're ever gonna be king of is King of the Stupids!

你只配做傻瓜的国王！