锥

According to spatial analytic geometry,the mathematical model of intersecting of pipe and cone was established.

利用空间解析几何的原理建立了管锥相贯数学模型，用参量方程描述了管端相贯线焊接坡口的几何形状，该数学模型可应用于三轴联动火焰数控切管机。

With the reduction of operation frequency, the height of thepyramidal absorber in the microwave anechoic chamber will increase correspondingly.

随着使用频率的降低，微波暗室角锥吸收体的高度也相应增加。

The stress and radial displacement will increase with the increment of half cone angle and lead.

螺旋输送器的最大应力强度和最大径向位移均与转速近似地成二次方关系；减小叶片壁厚，沉渣对螺旋叶片作用的正压力所引起的叶片的最大轴向位移增长较快；正常工况下，螺旋输送器的最大应力强度和最大径向位移都随着半锥角和导程的增加而增大。

By changing the value of the blade thickness, cone angle, lead and height of fillet weld, influences of these parameters on the strength and displacement of the screw conveyor are investigated which form the base for optimization of the conveyor structure.

论文还通过调整螺旋输送器的叶片壁厚、半锥角、导程和焊角高等几何结构参数，研究了各参数的变化对螺旋输送器强度和变形的影响，为结构优化设计奠定了基础。

The max stress and the max radial displacement of conveyor is also proportional to the square of rotational speed. With the decrease of the blade thickness, both the stress and axial displacement of conveyor increase rapidly. The stress and radial displacement will increase with the increment of half cone angle and lead.

螺旋输送器的最大应力强度和最大径向位移均与转速近似地成二次方关系；减小叶片壁厚，沉渣对螺旋叶片作用的正压力所引起的叶片的最大轴向位移增长较快；正常工况下，螺旋输送器的最大应力强度和最大径向位移都随着半锥角和导程的增加而增大。

Firstly, the inner wall of artillery is illuminated by lighting lamp and then its image is obtained after reflecting by prism,lastly, Angle of twist is calculated through the analysis of digital image.

首先，用光源把身管内壁照亮，然后经过锥镜反射后内壁在CCD相机中成像，最后对该数字图像进行分析，计算得到缠角。

A mass of pyrolite xenolith (such as peridotite andpyroxenide) and high-pressure mineral megacrysts (such as anorthoclase, augite and kaersutite)are found in cone sheets and BS volcanic rocks.

锥状岩席和BS火山岩包含有大量的上地幔岩石包体和高压矿物巨晶(歪长石、普通辉石和钛闪石)。

This result suggested antigenic variation of T.evansihad a rule to some extant.

表明至少在感染早期，伊氏锥虫的抗原变异存在一定的规律性。

That is, the sharp edge of shaft end is cut by a conical cutting tool with a 45° degree apex angle.

即用一锥顶角为45°的圆锥刀头切除其端部锐边。

MOM and its accelerated algorithm MLFMM were introduced to simulate the planar Archimedes spiral antenna,conical spiral antenna and radome with antenna.

采用矩量法和MLFMM来分析平面阿基米德螺旋天线、角锥螺旋天线和天线罩对天线性能的影响。

And Pharaoh spoke to Joseph, saying, Your father and your brothers have come to you.

47：5 法老对约瑟说，你父亲和你弟兄们到你这里来了。

Additionally, the approximate flattening of surface strip using lines linking midpoints on perpendicular lines between geodesic curves and the unconditional extreme value method are discussed.

提出了用测地线方程、曲面上两点间短程线来计算膜结构曲面测地线的方法，同时，采用测地线间垂线的中点连线和用无约束极值法进行空间条状曲面近似展开的分析。