锁紧螺母
- 与 锁紧螺母 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
I design two axis which taper is 1:12 to install bearing and fix bearing of cylindrical roller, I used locking nut to fix the direction of bearing owing to the reason of boring head's high precision.
主轴中设计了两个锥度为1:12的的轴段用于安装支承和固定圆柱滚子轴承,由于镗削头的精度要求很高,在轴承处使用了锁紧螺母进行轴向固定。
-
You'll need to order an extra jam nut if you want position-adjustability.
如果您想调节它的位置,需要订购另外一个锁紧螺母。
-
To release bladder remove jam nut holding bottom fitting.
拆卸固定底部接头的锁紧螺母,即可将内胆和罐子分离开来。
-
Install jam nut to a snug fit.
松紧合适地安装锁紧螺母。
-
If only one locating ring is required, it should be inserted on the same side as the lock nut.
如果只需一个定位环,此定位环应插入与锁紧螺母相同的一侧。
-
Revolving the lock nut 5 anti-clockwise to the suitable position.
3逆时针方向旋转锁紧螺母5,使其退到适当位置。
-
Tighten the lock nut until it reaches the plastic base.
锁紧螺母应拧至塑料底盘为止。
-
After completing adjustments tighten the lock nut and replace the fast fill lever cap.
在调节完成后,紧固锁紧螺母,重新安装快速进水手柄帽。
-
To adjust pressure setting, loosen the lock nut and turn the adjusting bolt clockwise to increase pressure, counter clockwise to decrease pressure.
要调节压力设置,先松开锁紧螺母,然后顺时针旋转调节螺栓以增加压力,逆时针旋转以降低压力。
-
Tang thread fastening and forced lock nut fastening.
即唐氏螺纹紧固及硬锁紧螺母紧固。
- 推荐网络例句
-
This paper discusses design and realizable methods of remote test output interface from logical design angle.
本文从逻辑设计的角度讨论遥测输出接口的设计及实现方法。
-
This also 星体投射plies to buildings, structures and geological features.
这也适用于建筑物和地质特征。
-
We all hope for a better life.
我们都希望好的生活。