铸

In the trail, the billet quality was inspected and the morphology of nonmetallic in clusions was studied.

还对ML08Al冷镦钢连铸坯进行了必要的检测分析，并对其中非金属夹杂物的形态与行为做了深入的研究。

Therefore, it is very important to investigate the role of nonsolvent additives in membrane formation by immersion precipitation both in the investigation on the mechanism of membrane formation and in the preparation of the commercial membrane.

为适应不同膜过程，需要使用非溶剂添加剂调整铸膜液的配方，获得理想的膜结构和性能。研究NSA对浸入凝胶成膜过程的影响，在理论和实践两方面都具有重要意义。

The thermodynamic properties of the casting solution were investigated by using the Flory-Huggins theory. A new simple method to determine the nonsolvent/polymer interaction parameter from the intrinsic viscosity was developed.

本文采用Flory-Huggins理论研究NSA对铸膜液热力学性质的影响，发展了一种从特性粘数推算非溶剂和聚合物之间的相互作用参数x〓的简便方法。

The phase separation behavior of different nonsolvent additives (methyl ethyl ketone, glycol methyl ether and diethylene glycol) on PPESK casting solution was studied at 20℃according the linerized cloud point correlation.

结合线性浊点关系，根据浊点滴定试验，通过三元相图研究了20℃下非溶剂添加剂(丁酮，乙二醇甲醚，一缩二乙二醇)对PPESK铸膜液体系的相分离行为。

On the basis of numberical simulation, water model test and Laser measuring velocity for fluid flow in mould was conducted to correct the calculated results.

本文针对薄板坯连铸两种典型结晶器--ISP结晶器和CSP结晶器，采用数值仿真和物理模拟试验相结合的研究方法，在国内外首次系统地模拟了结晶器内钢液。。。

This is not acceptable, and our customers would not accept this, need to consider a better quality casting steel, especially as this seems to be a general occurence in your moulds.

这是不能接受的，我方的客户将不能接受，必须考虑质量更好的铸钢，尤其是在你们的模具中经常出现这种情况的时候。

Based on the defect analysis of cold rolled and hot dip galvanized products produced from CSP coils by data processing, off-line testing, observation by SEM, it was shown that the quality of products is not only affected by proceeding processes such as steelmaking, casting, hot rolling but also by the performance of cold rolling and hot dip galvanizing.

应用数据统计、离线检验以及扫描电镜缺陷分析等手段，对应用CSP线生产的热轧卷在冷轧与镀锌过程中出现的产品问题进行了分析，分析结果表明，应用CSP热轧卷进行冷轧与镀锌产品生产，不但受与炼钢、连铸、热轧各工序密切相关的热轧卷质量的影响，而且与冷轧与镀锌生产线本身工艺有重要关联。

It does not have a traditional rubber seat inside the bore of the one-piece molded body.

在一件式模铸阀体的钻孔内没有传统的橡胶密封。

Opal glass , cast or rolled, non-wired, unworked, in sheets

乳白玻璃板材，压铸或轧制，无金属丝，未加工

The mold oscillating hydraulic technology is one of the key technologies in the development of casting.

摘 要：结晶器液压振动技术是连铸发展的关键技术之一。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。