铝的

Based on the mould features, the fluid mechanics mode ls were founded. Integrating with the finite element method, the hydro-mechanical deep drawing of alumite LF6 was simulated. The alumite LF6 was formed by hydro -mechanical deep drawing, and the reasonable process parameters were obtained.

根据模具几何特征，通过建立流体力学模型描述液体对板料单元的动态影响，结合有限元数值模拟技术对塑性差、难成形材料防锈铝LF6的充液拉深进行数值模拟，并进行实验研究，得到了防锈铝充液拉深合理工艺参数。

It is true that all metal printing plate, whether it is visible light-sensitive version and the printed edition, it is to have the same aluminum plate as a base, but individual manufacturer to aluminum plate surface made by granula proceesing and anodically oxdation approaches.

诚然，所有金属印版，不论是热敏版还是可见平印版，都是拔取不异的铝板息为底基，但各个创息发明商不差铝板暗不天所息的颗粒冻办理和不阴极氧冻办理方法却不尽不异。

Belite– calcium barium sulphoaluminate cement is a new type of cementitious material.

贝利特–硫铝酸钡钙水泥是一种新型的水泥材料，通过在贝利特熟料矿物体系中引入硫铝酸钡钙矿物，达到提高贝利特水泥早期强度的目的。

By way of f-CaO chemical analysis and thermal analysis, the article studied the influence of K_2O on the mineral of C_2S or C_4A_3 which chiefly formed a cement of high silicon belite sulphur aluminate cement .

目的为研究K2O对高硅贝利特硫铝酸盐水泥主要矿物C2S和C4A3 S的影响，为含有钾的低品位矿物原料生产高硅贝利特硫铝酸盐水泥奠定了基础。

By combining calcium barium sul- phoaliminate with a belite mineral system.

贝利特–硫铝酸钡钙水泥是一种新型的水泥材料，通过在贝利特熟料矿物体系中引入硫铝酸钡钙矿物，达到提高贝利特水泥早期强度的目的。

Aluminum phosphate (AlPO 4) can be prepared by solid state synthesis with different templates, aluminum chloride and ammonium diacid phosphate at low temperature (180℃) within a short time (2 h).

以氯化铝和磷酸二氢铵为原料，在模板剂存在下用固相合成方法合成了磷酸铝类化合物，合成的化合物通过化学分析、ICP测定、XRD和 IR图谱对其进行了表征，研究了化合物对铬离子吸附性能，实验表明这类化合物对铬离子有较好的吸附能

Moreover, an experiential formula for predicting the possibilities of etch film formation in the negative half-cycle of ac has been driven from the principle of mass transfer in HCl solutions. Finally, a mechanism of ac etching for aluminum foil in HCl and a theoretical rule for choosing electroetching conditions were suggested on the results.

在此基础上，提出了铝在交流负半周发生的四种变化，以及交流腐蚀扩面机理，根据这一机理，提出了铝箔的交流腐蚀工艺优化原则，并用实验对这一原则进行了初步验证。

Liquidus temperature is one of important parameters of production of aluminum electrolyze.

铝电解生产过程中电解温度是一个非常重要的工艺参数，电解温度与铝电解质初晶温度之间的差值称之为过热度。

Introduced variety and character of negative native aluminum foil using electrolyze capacitor, and expounded quality control keys for producing process, too.

介绍了铝电解电容器负极用素铝箔的种类及其特征，阐述了其加工制造过程中的质量控制要素。

Secondary growth of silicalite-1-seeded industrial CuO-ZnO-Al2O3 in alkaline solution with silica and alumina source produced intergrown ZSM-5 zeolite shells. After the shells were changed into HZSM-5, we compared the catalytical performance of the core/shell composite catalyst with a non-core/shell structured composite catalyst with the same component.

铜锌铝催化剂（CuO-ZnO-Al2O3）是工业上制备二甲醚的良好催化剂，我们将其表面预先包覆纳米沸石silicalite-1晶种，水热环境下二次生长后吸收硅源、铝源后形成ZSM-5膜，转换成氢型后形成CuO-ZnO-Al2O3/HZSM-5的核/壳结构复合催化剂。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。