铝合金

The company sells aluminum alloy, steel, copper and aluminum compound, aluminum compound radiator elegant appearance of novel, surface treatment by phosphating using special plastic electrostatic spraying, spraying process is not rigorous to ensure that the spray does not blast off from, the Company Xinjin anti-corrosion treatment equipment within the vacuum will be filling three anti-corrosion materials, this technology to further enhance adhesion of anti-corrosion materials, eliminating the dead-end coating, the coating process to prevent the bubble wall formation enhances the adhesion within the anti-corrosion, greatly extended the radiator life.

本公司销售的铝合金，钢质、铜铝复合、钢铝复合散热器外观新颖雅致，表面经磷化处理采用专用塑料静电喷涂，喷涂工艺严谨确保喷涂不脱落不爆起，本公司新进内防腐真空处理设备将防腐材料三次灌装，此工艺进一步提高防腐材料的附着力，消除了涂装死角，防止了涂装过程中管壁气泡的形成，增强了内防腐的附着力，大大延长了散热器的使用寿命。

The Zn-AI alloy coat steel wire has higher anti-corrosion properties than the Zn-coat steel wire.

锌铝合金镀层钢丝具有比纯锌镀层钢丝耐蚀能力高的优点。

A good track is determined by its intensity design and the surface . The aluminum rail track is better than the steel one in the aspect of noise-resistance.

好的轨道决定于轨道的强度设计和轨道内与滑轮接触面的光洁度，好的铝合金轨道在抗噪音方面优于钢轨。

Giesun automatic doors and windows in Guangzhou Co., Ltd., established in August 2005, specializing in remote control garage doors, automatic doors, telescopic doors, Car stalls, aluminum alloy door and window shutter design, production, installation and service.

广州吉顺自动门窗有限公司，成立二零零五年八月，专业从事遥控车库门、自动门、伸缩门、道闸、铝合金卷帘门窗的设计、制作、安装及服务。

Giesun automatic doors and windows in Guangzhou Co., Ltd., established in August 2005, specializing in remote control garage doors, automatic doors, telescopic doors, Car stalls, aluminum alloy door and window shutter design, production, installation and service.

车库门，铁艺，伸缩门广州吉顺自动门窗有限公司www.giesun.com，成立二零零五年八月，专业从事遥控车库门、自动门、伸缩门、道闸、铝合金卷帘门窗的设计、制作、安装及服务。

A Solidification technology with the solidifying time of only 20-120 s is presented through the analysis on hot wind furnace and remote infra-red furnace.

铝合金喷塑固化时间一般为20 min，通过分析热风炉及远红外炉的优点，阐述了固化时间只用20-120 s的固化技术。

The feasibility of in situ reaction formation of the Al alloy containing TiB2 particle was discussed. And mechanical properties of prepared alloys were also investigated.

分析了这种原位反应法制备含TiB2粒子铝合金的可行性，并对制备合金样品的力学性能进行了试验研究。

Changzhou sources logo Materials Limited is a member of China's Changzhou well-decorated group.

公司是集铝合金标识系统的开发、研制、设计、制作于一体的综合性公司。

The results show that the composite is dense and silicon particles are distributed uniformly. Transmission electron microscope observations show that stacking faults with high density, twins and dislocations are found in silicon particles. The Si-Al interfaces are well-bonded and no interface reactants are found. The dislocations and eutectic silicon precipitates are observed in LD11 matrix. Sip/LD11 composite has low density of 2.4 g/cm3, low coefficient of thermal expansion of 8.1×10-6/K, high thermal conductivity of 161.3 W/, and the annealing treatment can reduce the CTE and improve the thermal conductivity.

研究结果表明：复合材料组织致密，颗粒分布均匀；透射电镜观察发现，在Si颗粒内部存在高密度的层错，同时还存在孪晶和位错； Si-Al界面结合状况良好，无界面反应物； LD11铝合金中存在位错和析出的共晶Si；复合材料具有低密度(2.4 g/cm3)，低热膨胀系数(8.1×10-6/K)，高热导率161.3 W/(m·K的特性，可以通过退火处理进一步降低其热膨胀系数，提高热导率。

High power CO2 laser powder welding of aluminum alloy.

填充粉末对铝合金高功率CO2激光焊接的影响。

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。